EN ISO 105-X11:1996

Textiles - Tests for colour fastness - Part X11: Colour fastness to hot pressing (ISO-X11:1994)

Tests are given for hot pressing when the textile is dry, when it is wet, and when it is damp. The end-use of the textile usually determines which test should be made. A dry specimen (dry pressing) or a dry specimen covered with a wet cotton adjacent fabric (damp pressing) or a wet specimen covered with a wet cotton adjacent fabric (wet pressing) are pressed with a heating device at a specified temperature and pressure for a specified time.

Textilien - Farbechtheitsprüfungen - Teil X11: Bestimmung der Farbechtheit gegen Bügeln (ISO 105-X11:1994)

Dieser Teil von ISO 105 beschreibt ein Prüfverfahren zur Bestimmung der Widerstandsfähigkeit der Farbe von Textilien jeder Art und in allen Verarbeitungßuständen gegen das Bügeln und das Behandeln auf Trockenzylindern.

Textiles - Essais de solidité des teintures - Partie X11: Solidité des teintures au repassage à chaud (ISO 105-X11:1994)

1.1 La présente partie de l'ISO 105 prescrit une méthode pour la détermination de la résistance des teintures sur les textiles de toute nature, à tous leurs stades de transformation, au repassage ou au traitement industriel sur cylindres chauds. 1.2 Des essais sont prévus pour le repassage à chaud lorsque le textile est sec, lorsqu'il est mouillé et lorsqu'il est humide. La destination finale du textile détermine généralement quel essai doit être effectué.

Tekstilije - Preskušanje barvne obstojnosti - Del X11: Barvna obstojnost pri vročem likanju (ISO-X11:1994)

General Information

• Status: Published
• Publication Date: 20-Aug-1996
• Withdrawal Date: 27-Feb-1997
• ICS: 59.080.01 - Textiles in general
• Technical Committee: CEN/TC 248 - Textiles and textile products
• Drafting Committee: CEN/TC 248/SC 3 - Chemical properties
• Current Stage: 9093 - Decision to confirm - Review Enquiry
• Start Date: 14-Jun-2006
• Completion Date: 14-Jun-2006
• Ref Project: SIST EN ISO 105-X11:1999 - Textiles - Tests for colour fastness - Part X11: Colour fastness to hot pressing (ISO-X11:1994)

Relations

• Revised: prEN ISO 105-X11 - Textiles - Tests for colour fastness - Part X11: Colour fastness to hot pressing (ISO/DIS 105-X11:2024)
• Effective Date: 15-Nov-2023

Standards Content (Sample)

SLOVENSKI STANDARD
01-marec-1999
7HNVWLOLMH3UHVNXãDQMHEDUYQHREVWRMQRVWL'HO;%DUYQDREVWRMQRVWSUL
YURþHPOLNDQMX,62;
Textiles - Tests for colour fastness - Part X11: Colour fastness to hot pressing (ISO-
X11:1994)
Textilien - Farbechtheitsprüfungen - Teil X11: Bestimmung der Farbechtheit gegen
Bügeln (ISO 105-X11:1994)
Textiles - Essais de solidité des teintures - Partie X11: Solidité des teintures au
repassage a chaud (ISO 105-X11:1994)
Ta slovenski standard je istoveten z: EN ISO 105-X11:1996
ICS:
59.080.01 Tekstilije na splošno Textiles in general
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

INTERNATIONAL ISO
STANDARD 105-XI 1
Fourth edition
1994-09-01
Textiles - Tests for colour fastness -
Part XI 1:
Colour fastness to hot pressing
Essais de soliditg des teintures -
Textiles -
Partie XI 1: Solidite des teintures au repassage a chaud
Reference number
ISO 105-XI 1 :1994(E)
ISO 105-X11:1994(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide
federation of national Standards bodies (ISO member bodies). The work
of preparing International Standards is normally carried out through ISO
technical committees. Esch member body interested in a subject for
which a technical committee has been established has the right to be
represented on that committee. International organizations, governmental
and non-governmental, in liaison with ISO, also take part in the work. ISO
collaborates closely with the International Electrotechnical Commission
(1 EC) on all matters of electrotechnical standardization.
Draft International Standards adopted by the technical committees are
circulated to the member bodies for voting. Publication as an International
Standard requires approval by at least 75 % of the member bodies casting
a vote.
International Standard ISO 105-XI 1 was prepared by Technical Committee
ISORC 38, Textiles, Subcommittee SC 1, Tests for coloured textiles and
coloran ts.
This fourth edition cancels and replaces the third edition
(ISO lO5-XI 1 :1987), of which it constitutes a minor revision.
ISO 105 was previously published in thirteen “Parts ”, each designated by
a letter (e.g. “Part A ”), with publication dates between 1978 and 1985.
Esch part contained a series of “sections ”, each designated by the re-
spective patt letter and by a two-digit serial number (e.g. “Section AO1 “).
These sections are now being republished as separate documents, them-
selves designated “Parts” but retaining their earlier alphanumeric desig-
nations. A complete list of these Parts is given in ISO 105-AOI.
0 ISO 1994
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced
or utilized in any form or by any means, electronie or mechanical, including photocopying and
microfilm, without Permission in writing from the publisher.
International Organization for Standardization
Case Postale 56 l CH-l 21 l Geneve 20 l Switzerland
Printed in Switzerland
ii
INTERNATIONAL STANDARD Q 60 ISO 105-XI 1:1994(E)
Textiles - Tests for colour fastness -
Part XI 1:
Colour fastness to hot pressing
ISO 105-F:l985, Textiles - Tests for colour fastness
1 Scope
- Part F: Standard adjacent fabrics.
1.1 This part of ISO specifies a method for deter-
ISO 139: 1973, Textiles - Standard atmospheres for
mining the resistance of the colour of textiles of all
conditioning and testing.
kinds and in all forms to ironing and to processing on
hot cylinders.
3 Principle
1.2 Tests are given for hot pressing when the tex-
3.1 Dry pressing
tile is dry, when it is damp and when it is wet. The
end-use of the textile usually determines which test
A dry specimen is pressed with a heating device at a
should be made.
specified temperature and pressure for a specified
time.
2 Normative references
3.2 Damp pressing
The following Standards contain provisions which,
through reference in this text, constitute provisions
A dry specimen is covered with a wet cotton adjacent
of this part of ISO 105. At the time of publication, the
fabric and pressed with a heating device at a specified
editions indicated were valid. All Standards are subject
temperature and pressure for a specified time.
to revision, and Parties to agreements based on this
part of ISO 105 are encouraged to investigate the
3.3 Wet pressing
possibility of applying the most recent editions of the
Standards indicated below. Members of IEC and ISO
The upper surface of a wet specimen is covered with
maintain registers of currently valid International
a wet cotton adjacent fabric and pressed with a heat-
Standards.
ing device at a specified temperature and pressure for
a specified time.
ISO 105-AO1:1994, Textiles - Tests for colour fast-
Part A07: General principles of testing.
ness -
3.4 Assessment
ISO 105-AO2:1993, Textiles - Tests for colour fast-
The Change in colour of the specimen and the staining
ness - Part AO2 Grey scale for assessing Change in
of the adjacent fabric are assessed by comparison
colour.
with the grey scales immediately and again after
ISO 105-A03:1993, Textiles - Tests for colour fast- a period of exposure to air in accordance with
Part A03: Grey scale for assessing staining. ISO 105-AO1:1994, clause 10.
ness -
0 ISO
ISO 105-Xll:1994(E)
resistant sheet should be cooled and the wet wool
4 Apparatus
dried between tests.
4.1 Heating device, consisting of a pair of smooth
4.3 Padding, wool flannel of mass per unit area
parallel plates, equipped with an accurately control-
approximately 260 g/m*.
lable electrical heating System and giving a pressure
on the specimen of 4 kPa + 1 kPa.
-
Two layers of wool flannel are used to make a p
...