Bitumen and bituminous binders - Determination of the pH value of bituminous emulsions

This document specifies a method for measuring the pH value of bituminous emulsions.
It is applicable to anionic, cationic bituminous emulsions and bituminous emulsions prepared by means of non-ionic surfactant.
NOTE   In certain circumstances, the pH value can provide an indication of the ionic character of a bituminous emulsion when confirmed by a particle polarity test conforming to EN 1430 [1].
WARNING - The use of this document can involve hazardous materials, operations and equipment. This document does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this document to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.

Bitumen und bitumenhaltige Bindemittel - Bestimmung des pH-Wertes von Bitumenemulsionen

Dieses Dokument legt ein Verfahren zur Bestimmung des pH Wertes von Bitumenemulsionen fest.
Es ist anwendbar auf anionische, kationische Bitumenemulsionen und Bitumenemulsionen, die mit Hilfe von nicht ionischen Tensiden vorbereitet wurden.
ANMERKUNG   Unter bestimmten Umständen kann der pH Wert einen Hinweis auf den Ionencharakter einer Bitumenemulsion geben, wenn dies durch eine Bestimmung der Teilchenpolarität nach EN 1430 [1] bestätigt wird.
WARNUNG - Die Anwendung dieses Dokumentes kann die Anwendung gefährlicher Stoffe, Arbeitsgänge und Geräte mit sich bringen. Dieses Dokument beansprucht nicht, alle damit verbundenen Sicherheitsprobleme zu behandeln. Es liegt in der Verantwortung des Anwenders dieses Dokuments, geeignete Sicherheits- und Gesundheitsschutzmaßnahmen vorzusehen und im Vorfeld die Anwendbarkeit von einschränkenden Vorschriften zu klären.

Bitumes et liants bitumineux - Détermination du pH des émulsions bitumineuses

Ce document spécifie une méthode pour la détermination du pH des émulsions bitumineuses.
Il est applicable aux émulsions bitumineuses anioniques, cationiques et aux émulsions bitumineuses préparées à l’aide de surfactants non-ioniques.
NOTE   Dans certains cas, la valeur du pH peut fournir une indication sur le caractère ionique de l’émulsion bitumineuse dans la mesure où cette indication est confirmée par un essai de détermination de la polarité des particules conformément à l’EN 1430 [1].
AVERTISSEMENT - L'utilisation de ce document implique l'intervention de produits, d'opérations et d'équipements à caractère dangereux. Le présent document n'est pas censé aborder tous les problèmes de sécurité concernés par son usage. Il est de la responsabilité de son utilisateur d'établir des règles d'hygiène et de sécurité appropriées et de déterminer l'applicabilité des restrictions réglementaires avant utilisation.

Bitumen in bitumenska veziva - Določevanje pH vrednosti bitumenskih emulzij

Ta dokument določa metodo za merjenje pH vrednosti bitumenskih emulzij.
Uporablja se za anionske in kationske bitumenske emulzije ter bitumenske emulzije, pripravljene z neionsko površinsko aktivno snovjo.
V določenih okoliščinah se lahko pH vrednost uporablja kot pokazatelj ionskega značaja bitumenske emulzije. Vendar ta podatek naj se potrdi s preskusom polarnosti delcev v skladu s standardom EN 1430 [1].
OPOZORILO: Pri uporabi tega dokumenta so lahko prisotni nevarni materiali, postopki in oprema. Ta dokument ne obravnava vseh varnostnih težav, ki se navezujejo na njegovo uporabo. Za vzpostavitev ustreznih varnostnih in zdravstvenih praks ter za določitev uporabnosti regulativnih omejitev pred uporabo je odgovoren uporabnik tega dokumenta.

General Information

Status
Published
Publication Date
19-Jul-2022
Withdrawal Date
30-Jan-2023
Current Stage
6060 - Definitive text made available (DAV) - Publishing
Start Date
20-Jul-2022
Due Date
02-Sep-2022
Completion Date
20-Jul-2022

Relations

Buy Standard

Standard
EN 12850:2022
English language
7 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)


SLOVENSKI STANDARD
01-september-2022
Nadomešča:
SIST EN 12850:2009
Bitumen in bitumenska veziva - Določevanje pH vrednosti bitumenskih emulzij
Bitumen and bituminous binders - Determination of the pH value of bituminous emulsions
Bitumen und bitumenhaltige Bindemittel - Bestimmung des pH-Wertes von
Bitumenemulsionen
Bitumes et liants bitumineux - Détermination du pH des émulsions bitumineuses
Ta slovenski standard je istoveten z: EN 12850:2022
ICS:
75.140 Voski, bitumni in drugi naftni Waxes, bituminous materials
proizvodi and other petroleum products
91.100.50 Veziva. Tesnilni materiali Binders. Sealing materials
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

EN 12850
EUROPEAN STANDARD
NORME EUROPÉENNE
July 2022
EUROPÄISCHE NORM
ICS 75.140; 91.100.50 Supersedes EN 12850:2009
English Version
Bitumen and bituminous binders - Determination of the
pH value of bituminous emulsions
Bitumes et liants bitumineux - Détermination du pH Bitumen und bitumenhaltige Bindemittel -
des émulsions bitumineuses Bestimmung des pH-Wertes von Bitumenemulsionen
This European Standard was approved by CEN on 13 June 2022.

CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this
European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references
concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN
member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by
translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and
United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2022 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 12850:2022 E
worldwide for CEN national Members.

Contents Page
European foreword . 3
1 Scope . 4
2 Normative references . 4
3 Terms and definitions . 4
4 Principle . 4
5 Reagents and materials . 4
6 Apparatus . 5
7 Sampling . 5
8 Procedure. 5
9 Expression of results . 6
10 Precision . 6
10.1 General . 6
10.2 Repeatability . 6
10.3 Reproducibility . 6
11 Test report . 6
Bibliography . 7

European foreword
This document (EN 12850:2022) has been prepared by Technical Committee CEN/TC 336 “Bituminous
binders”, the secretariat of which is held by AFNOR.
This European Standard shall be given the status of a national standard, either by publication of an
identical text or by endorsement, at the latest by January 2023, and conflicting national standards shall
be withdrawn at the latest by January 2023.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CEN shall not be held responsible for identifying any or all such patent rights.
This document supersedes EN 12850:2009.
The main technical changes are:
— the number of required standard buffer solutions is at least two which bracket the expected pH value
to be measured (5.4 and Clause 8);
— the requirement to use certified buffer solutions and to follow manufacturer’s instructions for their
verification and storage conditions (5.4);
— the requirement to calibrate according to the manufacturer’s instructions for the used pH meter and
with the obligation to test pH = 7 and to frame the expected pH value (Clause 8);
— the requirement that the calibration temperatures are compliant with those indicated for each buffer
solution (Clause 8).
Any feedback and questions on this document should be directed to the users’ national standards body.
A complete listing of these bodies can be found on the CEN website.
According to the CEN-CENELEC Internal Regulations, the national standards organisations of the
following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Croatia,
Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland,
Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Polan
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.