prEN 4855-05
(Main)Aerospace series - ECO efficiency of catering equipment - Part 05: Trash compactor
Aerospace series - ECO efficiency of catering equipment - Part 05: Trash compactor
This document specifies a test procedure to identify performance characteristics and trash volume capacity rating of trash compactors used on a commercial aircraft. Furthermore it specifies the calculation procedure to determine an energy efficiency index.
Luft- und Raumfahrt - ECO Effizienz von Cateringgeräten - Teil 05: Müllpresse
Série aérospatiale - Écoefficacité du matériel de restauration - Partie 05 : Compacteurs de déchets
Aeronavtika - Ekoučinkovitost naprav za gostinstvo - 5. del: Kompaktor za odpadke
General Information
Standards Content (Sample)
SLOVENSKI STANDARD
01-junij-2024
Aeronavtika - Ekoučinkovitost naprav za gostinstvo - 5. del: Kompaktor za
odpadke
Aerospace series - ECO efficiency of catering equipment - Part 05: Trash compactor
Luft- und Raumfahrt - ECO Effizienz von Cateringgeräten - Teil 05: Müllpresse
Série aérospatiale - Éco efficacité du matériel de restauration - Partie 05: Équipement
pour compacteur de déchets
Ta slovenski standard je istoveten z: prEN 4855-05
ICS:
13.030.01 Odpadki na splošno Wastes in general
49.095 Oprema za potnike in Passenger and cabin
oprema kabin equipment
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
DRAFT
EUROPEAN STANDARD
NORME EUROPÉENNE
EUROPÄISCHE NORM
April 2024
ICS 49.095
English Version
Aerospace series - ECO efficiency of catering equipment -
Part 05: Trash compactor
Série aérospatiale - Éco efficacité du matériel de Luft- und Raumfahrt - ECO Effizienz von
restauration - Partie 05: Équipement pour compacteur Cateringgeräten - Teil 05: Müllpresse
de déchets
This draft European Standard is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee ASD-
STAN.
If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations
which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC
Management Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Türkiye and
United Kingdom.
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are
aware and to provide supporting documentation.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without
notice and shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2024 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN 4855-05:2024 E
worldwide for CEN national Members.
Contents Page
European foreword . 3
Introduction . 4
1 Scope . 5
2 Normative references . 5
3 Terms and definitions . 5
4 Symbols and abbreviations . 6
5 General test conditions . 6
5.1 Measurements and calculations . 6
5.2 Environmental conditions . 6
5.3 Power supply and voltage . 6
5.4 Measurement equipment . 6
5.5 Test set up . 7
5.6 Test medium . 7
5.7 General conditions for weight measurement . 7
6 Test procedures . 7
6.1 Energy consumption test . 7
6.2 Measurement of the trash capacity . 8
7 Evaluation and calculation . 8
7.1 General. 8
7.2 Calculation of energy consumption index (ECI) . 8
7.3 Calculation of performance index (PI) . 9
7.4 Test report . 10
7.5 Calculation sheet . 10
European foreword
This document (prEN 4855-05:2024) has been prepared by the Aerospace and Defence Industries
Association of Europe — Standardization (ASD-STAN).
This document is currently submitted to the CEN Enquiry.
Introduction
During aircraft operations, the trash compaction in the cabin is mandatory to maintain the catering on
board. There exist different equipment types to compact the collected trash in order to reduce the space
required for waste storage, differing in waste volume and compaction rate. To meet the target to
determine an energy efficiency index for aircraft trash compactors the purpose of this document is to
standardize the test procedure and efficiency calculations for this equipment type.
1 Scope
This document specifies a test procedure to identify performance characteristics and trash volume
capacity rating of trash compactors used on a commercial aircraft. Furthermore it specifies the
calculation procedure to determine an energy efficiency index.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content
constitutes requirements of this document. For dated references, only the edition cited
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.