prEN 12697-2
(Main)Bituminous mixtures - Test methods - Part 2: Determination of particle size distribution
Bituminous mixtures - Test methods - Part 2: Determination of particle size distribution
This document specifies a procedure for the determination of the particle size distribution of the aggregates of bituminous mixtures by sieving. The test is applicable to aggregates recovered after binder extraction in accordance with EN 12697 1 or EN 12697 39.
NOTE Fibres, solid (non-soluble during extraction) additives and (some) binder modifiers influence the test result.
Asphalt - Prüfverfahren - Teil 2: Korngrößenverteilung
Dieses Dokument legt ein Verfahren für die Bestimmung der Korngrößenverteilung der Gesteinskörnungen in Asphalt mittels Siebanalyse fest. Die Prüfung ist für Gesteinskörnungen, die nach Extraktion des Bindemittels nach EN 12697 1 oder EN 12697 39 rückgewonnen wurden, anwendbar.
ANMERKUNG Fasern, feste Zusatzstoffe (die bei der Extraktion nicht in Lösung gehen) und (einige) Modifizierungs¬mittel für Bindemittel beeinflussen das Prüfergebnis.
Mélanges bitumineux - Méthodes d'essai - Partie 2 : Granulométrie
Le présent document spécifie un mode opératoire pour la détermination de la composition granulométrique des granulats dans les mélanges bitumineux, par tamisage. L’essai s’applique aux granulats récupérés après extraction du liant selon l’EN 12697 1 ou l’EN 12697 39.
NOTE Les fibres, additifs solides (non solubles durant l’extraction) et (certains) modificateurs de liants influencent le résultat de l’essai.
Bitumenske zmesi - Preskusne metode - 2. del: Ugotavljanje zrnavosti
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
01-december-2023
Nadomešča:
SIST EN 12697-2:2015+A1:2019
Bitumenske zmesi - Preskusne metode - 2. del: Ugotavljanje zrnavosti
Bituminous mixtures - Test methods - Part 2: Determination of particle size distribution
Asphalt - Prüfverfahren - Teil 2: Korngrößenverteilung
Mélanges bitumineux - Méthodes d'essai - Partie 2 : Granulométrie
Ta slovenski standard je istoveten z: prEN 12697-2
ICS:
93.080.20 Materiali za gradnjo cest Road construction materials
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
DRAFT
EUROPEAN STANDARD
NORME EUROPÉENNE
EUROPÄISCHE NORM
September 2023
ICS 93.080.20 Will supersede EN 12697-2:2015+A1:2019
English Version
Bituminous mixtures - Test methods - Part 2:
Determination of particle size distribution
Mélanges bitumineux - Méthodes d'essai - Partie 2 : Asphalt - Prüfverfahren - Teil 2: Korngrößenverteilung
Granulométrie
This draft European Standard is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee
CEN/TC 227.
If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations
which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC
Management Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Türkiye and
United Kingdom.
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are
aware and to provide supporting documentation.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without
notice and shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2023 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN 12697-2:2023 E
worldwide for CEN national Members.
Contents Page
European foreword . 3
Introduction . 4
1 Scope . 5
2 Normative references . 5
3 Terms and definitions . 5
4 Principle . 5
5 Apparatus . 6
6 Sample preparation . 6
7 Procedure . 6
8 Calculation . 6
9 Test report . 7
10 Precision . 7
Bibliography . 8
European foreword
This document (prEN 12697-2:2023) has been prepared by Technical Committee CEN/TC 227 “Road
materials”, the secretariat of which is held by BSI.
This document is currently submitted to the CEN Enquiry.
This document will supersede EN 12697-2:2015+A1:2019.
EN 12697-2:2015+A1:2019:
— general editorial update according to current standard template and CEN/CENELEC Internal
Regulations, Part 3:2022;
— [Introduction] new Clause introduced. Text moved from previous Clause 4 Significance and use;
— [1] deletion of misleading paragraph regarding applicability of this European standard;
— [2] deletion of normative reference to EN 932-6. Added to the Bibliography;
— [2] deletion of “for hot mix asphalt” in titles of occurring test methods in EN 12697-series;
— [4] amended title to read “Principle”. Following Clauses re-numbered accordingly;
— [5.2] sieve size 2,8 mm replaced by 4 mm. Paragraph revised (Clause 6.2 in previous version);
— [5.3] clarification regarding sieve sizes higher or equal to 4 mm (Clause 6.3 in previous version);
— [6] amended description for the drying to constant mass (Clause 7 in previous version);
— [7] clarification of the minimum amount of material (Clause 8 in previous version);
— [9] update of the contents in the test report (Clause 10 in previous version);
A list of all parts in a series can be found on the CEN website: www.cencenelec.eu.
Introduction
The composition of a bituminous mixture in terms of binder content and agg
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.