CEN ISO/TS 21189:2019
(Main)Intelligent transport systems - Cooperative ITS - Test requirements and Protocol Implementation Conformance Statement (PICS) pro forma for CEN ISO/TS 17426 (ISO/TS 21189:2019)
Intelligent transport systems - Cooperative ITS - Test requirements and Protocol Implementation Conformance Statement (PICS) pro forma for CEN ISO/TS 17426 (ISO/TS 21189:2019)
This document provides the Protocol Implementation Conformance Statement (PICS) pro forma for conformance test specification for the Contextual Speed Information Service as defined in ISO/TS 17426:2016 in accordance with the relevant requirements and in accordance with the relevant guidance given in ISO/IEC 9646-7.
Intelligente Verkehrssysteme - Kooperative ITS - Prüfanforderungen und pro-forma Konformitätsaussagen zur Protokollimplementierung (PICS) zur CEN ISO/TS 17426 (ISO/TS 21189:2019)
Systèmes de Transport Intelligents - ITS Coopératifs - Exigences d'essais et Déclaration pro forma de conformité de l'implémentation du protocole de la norme CEN ISO/TS 17426 (ISO/TS 21189:2019)
Inteligentni transportni sistemi (ITS) - Kooperativni ITS - Zahteve za preskušanje in izjava o skladnosti izvedbe protokola (PICS) pro forma za CEN ISO TS 17426 (ISO/TS 21189:2019)
V tej tehnični specifikaciji je podana formalna izjava o skladnosti izvedbe protokola (PICS) za preskusne specifikacije skladnosti za informacijsko storitev kontekstualne hitrosti, kot je opredeljeno v CEN ISO/TS 17426:2016, v skladu z ustreznimi zahtevami in v skladu z ustreznimi smernicami standarda ISO/IEC 9646-7.
General Information
Standards Content (Sample)
SLOVENSKI STANDARD
01-september-2019
Inteligentni transportni sistemi (ITS) - Kooperativni ITS - Zahteve za preskušanje in
izjava o skladnosti izvedbe protokola (PICS) pro forma za CEN ISO TS 17426
(ISO/TS 21189:2019)
Intelligent transport systems - Cooperative ITS - Test requirements and Protocol
Implementation Conformance Statement (PICS) pro forma for CEN ISO TS 17426
(ISO/TS 21189:2019)
Intelligente Verkehrssysteme - Kooperative ITS - Prüfanforderungen und pro-forma
Konformitätsaussagen zur Protokollimplementierung (PICS) zur CEN ISO TS 17426
(ISO/TS 21189:2019)
Systèmes de Transport Intelligents - ITS Coopératifs - Exigences d'essais et Déclaration
pro forma de conformité de l'implémentation du protocole de la norme CEN ISO TS
17426 (ISO/TS 21189:2019)
Ta slovenski standard je istoveten z: CEN ISO/TS 21189:2019
ICS:
03.220.01 Transport na splošno Transport in general
35.240.60 Uporabniške rešitve IT v IT applications in transport
prometu
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
CEN ISO/TS 21189
TECHNICAL SPECIFICATION
SPÉCIFICATION TECHNIQUE
May 2019
TECHNISCHE SPEZIFIKATION
ICS
English Version
Intelligent transport systems - Cooperative ITS - Test
requirements and Protocol Implementation Conformance
Statement (PICS) pro forma for CEN ISO/TS 17426
(ISO/TS 21189:2019)
Systèmes de Transport Intelligents - ITS Coopératifs - Intelligente Verkehrssysteme - Kooperative ITS -
Exigences d'essais et Déclaration pro forma de Prüfanforderungen und pro-forma
conformité de l'implémentation du protocole de la Konformitätsaussagen zur Protokollimplementierung
norme CEN ISO/TS 17426 (ISO/TS 21189:2019) (PICS) zur CEN ISO/TS 17426 (ISO/TS 21189:2019)
This Technical Specification (CEN/TS) was approved by CEN on 21 March 2019 for provisional application.
The period of validity of this CEN/TS is limited initially to three years. After two years the members of CEN will be requested to
submit their comments, particularly on the question whether the CEN/TS can be converted into a European Standard.
CEN members are required to announce the existence of this CEN/TS in the same way as for an EN and to make the CEN/TS
available promptly at national level in an appropriate form. It is permissible to keep conflicting national standards in force (in
parallel to the CEN/TS) until the final decision about the possible conversion of the CEN/TS into an EN is reached.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2019 CEN All rights of exploitation in any form and by any means reserved Ref. No. CEN ISO/TS 21189:2019 E
worldwide for CEN national Members.
Contents Page
European foreword . 3
European foreword
This document (CEN ISO/TS 21189:2019) has been prepared by Technical Committee ISO/TC 204
"Intelligent transport systems" in collaboration with Technical Committee CEN/TC 278 “Intelligent
transport systems” the secretariat of which is held by NEN.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CEN shall not be held responsible for identifying any or all such patent rights.
This document has been prepared under a mandate given to CEN by the European Commission and the
European Free Trade Association.
According to the CEN-CENELEC Internal Regulations, the national standards organizations of the
following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria,
Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia,
France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta,
Netherlands, Norway, Poland, Portugal, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and the United Kingdom.
Endorsement notice
The text of ISO/TS 21189:2019 has been approved by CEN as CEN ISO/TS 21189:2019 without any
modification.
TECHNICAL ISO/TS
SPECIFICATION 21189
First edition
2019-04
Intelligent transport systems —
Cooperative ITS — Test requirements
and protocol implementation
conformance statement (PICS) pro
forma for ISO/TS 17426
Reference number
ISO/TS 21189:2019(E)
©
ISO 2019
ISO/TS 21189:2019(E)
© ISO 2019
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting
on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address
below or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Fax: +41 22 749 09 47
Email: copyright@iso.org
Website: www.iso.org
Published in Switzerland
ii © ISO 2019 – All rights reserved
ISO/TS 21189:2019(E)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Symbols and abbreviated terms . 1
5 Conformance requirement concerning PICS . 2
Annex A (normative) Contextual Speeds PICS pro forma . 3
Bibliography . 9
ISO/TS 21189:2019(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular, the different approval criteria needed for the
different types of ISO documents should be noted. This document was drafted in accordance with the
editorial rules of the ISO/IEC Directives, Part 2 (see www .iso .org/directives).
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Details of
any patent rights identified during the development of the document will be in the Introduction and/or
on the ISO list of patent declarations received (see www .iso .org/patents).
Any trade name used in this document is information given for the convenience of users and does not
constitute an endorsement.
For an explanation of the voluntary nature of standards, the meaning of ISO specific terms and
expressions related to conformity assessment, as well as information about ISO's adherence to the
World Trade Organization (WTO) principles in the Technical Barriers to Trade (TBT) see www .iso
.org/iso/foreword .html.
This document was prepared by Technical Committee ISO/TC 204, Intelligent transport systems.
Any feedback or questions on this document should be directed to the user’s national standards body. A
complete listing of these bodies can be found at www .iso .org/members .html.
iv © ISO 2019 – All rights reserved
ISO/TS 21189:2019(E)
Introduction
The harmonized deployment of Cooperative ITS is expected to improve road safety, support traffic
management, and reduce greenhouse gas emissions. Delivering Contextual Speed information to road
users is a key component of this development.
The purpose of this document is to provide a mechanism whereby a supplier of an implementation of
the requirements defined in ISO/TS 17426 may provide information about the implementation in a
standardized manner.
According to ISO/TS 20026 and ETSI EG 202 798 V1.1.1 (2011-01), three deliverables should be
developed to produce a complete set of Conformance Test Specifications for the Contextual Speed
Information Service as defined in ISO/TS 17426:2016:
— Test requirements and Protocol Implementation Conformance Statement (PICS) pro forma;
— Test Suite Structure and Test Purposes (TSS & TP);
— Abstract Test Suite (ATS) and partial Protocol Implementation eXtra Information for Testing (PIXIT)
pro forma.
This document catalogues the Contextual Speed Information Service testable requirements, enabling
to draft "Test Suite Structure and Test Purposes (TSS & TP)“ and "Abstract Test Suite (ATS) and partial
Protocol Implementation eXtra Information for Testing (PIXIT) pro forma” deliverables.
The two last deliverables are however out of the scope of this document.
TECHNICAL SPECIFICATION ISO/TS 21189:2019(E)
Intelligent transport systems — Cooperative ITS — Test
requirements and protocol implementation conformance
statement (PICS) pro forma for ISO/TS 17426
1 Scope
This document provides the Protocol Implementation Conformance Statement (PICS) pro forma
for conformance test specification for the Contextual Speed Information Service as defined in ISO/
TS 17426:2016 in accordance with the relevant requirements and in accordance with the relevant
guidance given in ISO/IEC 9646-7.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content
constitutes requirements of this document. For dated references, only the edition cited applies. For
undated references, the latest edition of the referenced document (including any amendments) applies.
ISO/IEC 9646-1, Information technology — Open Systems Interconnection — Conformance testing
methodology and framework — Part 1: General concepts
ISO/IEC 9646-7, Information technology — Open Systems Interconnection — Conformance testing
methodology and framework — Part 7: Implementation Conformance Statements
ISO/TS 17426:2016, Intelligent transport systems — Cooperative systems — Contextual speeds
3 Terms and definitions
For the purposes of this document, the terms and definitions given in ISO/TS 17426:2016, ISO/IEC 9646-
1 and ISO/IEC 9646-7 apply.
ISO and IEC maintain terminological databases for use in standardization at the following addresses:
— ISO Online browsing platform: available at http: //www .iso .org/obp
— IEC Electropedia: available at http: //www .electropedia .org/
4 Symbols and abbreviated terms
ADU Application Data Unit
ATS Abstract Test Suite
BSMD Bounded Secured Managed Domain
C-ITS Cooperative ITS
CSM Contextual Speed Message
HMI Human Machine Interface
ICT Information Communications Technologies
ISO/TS 21189:2019(E)
ITS Intelligent Transport Systems
ITS-AID ITS Application Identifier
ITS-S ITS Station
ITS-SCU ITS-S Communication Unit
ITS-SU ITS-S Unit
IUT Implementation Under Test
LDM Local Dynamic Map
n.a. not applicable
OEM Original Equipment Manufacturer
PDU Protocol Data Unit
PICS Protocol Implementation Conformance Statement
PIXIT Protocol Implementation eXtra Information for Testing
SUT System Under Test
TSS&TP Test Suite Structure and Test Purposes
5 Conformance require
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.