Small craft - Airborne sound emitted by powered recreational craft - Part 1: Pass-by measurement procedures (ISO 14509-1:2008)

ISO 14509-1:2008 specifies the conditions for obtaining reproducible and comparable measurement results of the maximum sound pressure level of airborne sound generated during the passage of powered recreational craft of up to 24 m length of hull, including inboards, stern drives, personal watercraft (PWC) and outboard motors.
It also specifies standard craft based type tests for stern drives with integral exhaust systems and for outboard motors. It also specifies the procedure to be followed if, in addition to the maximum sound pressure level, the determination of the sound exposure level is desired.
The accuracy grade of the acoustical test procedures specified in ISO 14509-1:2008 is engineering grade (grade 2).

Kleine Wasserfahrzeuge - Von motorgetriebenen Sportbooten abgestrahlter Luftschall - Teil 1: Vorbeifahrtmessungen (ISO 14509-1:2008)

Dieser Teil von ISO 14509 legt die Bedingungen für reproduzierbare und vergleichbare Messungen des maximalen Schalldruckpegels fest, der während der Vorbeifahrt von motorgetriebenen Sportbooten von bis zu 24 m Länge erzeugt wird. Eingeschlossen sind Boote mit Einbaumotor, Boote mit Z-Antrieb, Wasser-motorräder (Jet-Ski) und Außenbordmotoren. Er legt darüber hinaus Abnahmeprüfungen mit einem Normboot für Z-Antriebe mit integriertem Auspuffsystem und für Außenbordmotoren fest. In Anhang A ist ein Verfahren beschrieben, nach dem der Schallexpositionspegel zu messen ist, falls seine Bestimmung zusätzlich zum maximalen Schalldruckpegel gewünscht ist.
ANMERKUNG   Für Schallemissionsmessungen an anderen als den oben beschriebenen Booten gilt ISO 2922.
Das in diesem Teil von ISO 14509 beschriebene akustische Messverfahren ist von der Genauigkeitsklasse 2.

Petits navires - Bruit aérien émis par les bateaux de plaisance motorisés - Partie 1: Méthodes de mesure pour l'essai de passage (ISO 14509-1:2008)

L'ISO 14509-1:2008 spécifie les conditions d'obtention de résultats de mesures reproductibles et comparables relatifs au niveau maximum de pression acoustique du bruit aérien provoqué lors du passage de bateaux de plaisance motorisés dont la coque ne dépasse pas 24 m de longueur, y compris les moteurs intérieurs, les moteurs à embase de propulsion arrière, les scooters de mer (PWC) et les moteurs hors-bord. Elle spécifie également les essais de type basés sur des bateaux standard pour les moteurs à embase arrière de propulsion avec système d'échappement intégré et pour les moteurs hors-bord. Elle spécifie enfin les procédures à observer lorsque l'on souhaite déterminer le niveau d'exposition sonore en plus du niveau maximal de pression sonore.
La classe de précision des modes opératoires d'essais acoustiques spécifiés dans l'ISO 14509-1:2008 est la classe d'ingénierie (classe 2).

Mala plovila - Merjenje zvoka v zraku, ki ga oddajajo motorizirana rekreacijska plovila - 1. del: Postopki merjenja pri vožnji mimo (ISO 14509-1:2008)

General Information

Status
Withdrawn
Publication Date
30-Sep-2008
Withdrawal Date
02-Oct-2018
Current Stage
9960 - Withdrawal effective - Withdrawal
Completion Date
03-Oct-2018

Relations

Buy Standard

Standard
EN ISO 14509-1 2008
English language
26 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN ISO 14509-1:2008
01-december-2008
1DGRPHãþD
SIST EN ISO 14509:2001
SIST EN ISO 14509:2001/A1:2004
Mala plovila - Merjenje zvoka v zraku, ki ga oddajajo motorizirana rekreacijska
plovila - 1. del: Postopki merjenja pri vožnji mimo (ISO 14509-1:2008)
Small craft - Airborne sound emitted by powered recreational craft - Part 1: Pass-by
measurement procedures (ISO 14509-1:2008)
Kleine Wasserfahrzeuge - Von motorgetriebenen Sportbooten abgestrahlter Luftschall -
Teil 1: Vorbeifahrtmessungen (ISO 14509-1:2008)
Petits navires - Bruit aérien émis par les bateaux de plaisance motorisés - Partie 1:
Méthodes de mesure pour l'essai de passage (ISO 14509-1:2008)
Ta slovenski standard je istoveten z: EN ISO 14509-1:2008
ICS:
17.140.30 Emisija hrupa transportnih Noise emitted by means of
sredstev transport
47.080 ýROQL Small craft
SIST EN ISO 14509-1:2008 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN ISO 14509-1:2008

---------------------- Page: 2 ----------------------

SIST EN ISO 14509-1:2008
EUROPEAN STANDARD
EN ISO 14509-1
NORME EUROPÉENNE
EUROPÄISCHE NORM
October 2008
ICS 17.140.30; 47.080 Supersedes EN ISO 14509:2000
English Version
Small craft - Airborne sound emitted by powered recreational
craft - Part 1: Pass-by measurement procedures (ISO 14509-
1:2008)
Petits navires - Bruit aérien émis par les bateaux de Kleine Wasserfahrzeuge - Von motorgetriebenen
plaisance motorisés - Partie 1: Méthodes de mesure pour Sportbooten abgestrahlter Luftschall - Teil 1:
l'essai de passage (ISO 14509-1:2008) Vorbeifahrtmessungen (ISO 14509-1:2008)
This European Standard was approved by CEN on 24 August 2008.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the CEN Management Centre or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as the
official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,
France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,
Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36  B-1050 Brussels
© 2008 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 14509-1:2008: E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------

SIST EN ISO 14509-1:2008
EN ISO 14509-1:2008 (E)
Contents Page
Foreword.3
Annex ZA (informative)  Relationship between this International Standard and the Essential
Requirements of EU Directive 94/25/EC as amended by 2003/44/EC.4

2

---------------------- Page: 4 ----------------------

SIST EN ISO 14509-1:2008
EN ISO 14509-1:2008 (E)
Foreword
This document (EN ISO 14509-1:2008) has been prepared by Technical Committee ISO/TC 188 "Small craft"
in collaboration with Technical Committee CEN/SS T01 “Shipbuilding and maritime structures” the secretariat
of which is held by CMC.
This European Standard shall be given the status of a national standard, either by publication of an identical
text or by endorsement, at the latest by April 2009, and conflicting national standards shall be withdrawn at the
latest by April 2009.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. CEN [and/or CENELEC] shall not be held responsible for identifying any or all such patent rights.
This document supersedes EN ISO 14509:2000.
This document has been prepared under a mandate given to CEN by the European Commission and the
European Free Trade Association, and supports essential requirements of EC Directive.
For relationship with EC Directive, see informative Annex ZA, which is an integral part of this document.
According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following
countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Cyprus, Czech
Republic, Denmark, Estonia, Finland, Fran
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.