EN 60670-23:2008
(Main)Boxes and enclosures for electrical accessories for household and similar fixed electrical installations - Part 23: Particular requirements for floor boxes and enclosures
Boxes and enclosures for electrical accessories for household and similar fixed electrical installations - Part 23: Particular requirements for floor boxes and enclosures
This standard applies to boxes and enclosures intended to be installed in any kind of floor, and to protect accessories against load up to and including 1 000 N.
Dosen und Gehäuse für elektrische Installationsgeräte für Haushalt und ähnliche ortsfeste elektrische Installationen - Teil 23: Besondere Anforderungen für Unterflurdosen
Boîtes et enveloppes pour appareillage électrique pour installations électriques fixes pour usages domestiques et analogues - Partie 23: Règles particulières pour les boîtes et enveloppes de sol
La présente norme est applicable aux boîtes et enveloppes prévues pour être installées dans toutes sortes de sols et protéger les appareils contre des charges jusqu'à et y compris 1 000 N.
Omarice in ohišja za električni pribor za gospodinjstva in podobne fiksne inštalacije - 23. del: Posebne zahteve za talne omarice in ohišja (IEC 60670-23:2006)
Ta točka 1. dela se ne uporablja v naslednjih primerih: dodatek po četrtem odstavku: Ta standard se uporablja za omarice in ohišja, ki so predvidena za namestitev na različno talno podlago in za zaščito opreme pred obremenitvijo do vključno 1000 N.
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
01-februar-2009
2PDULFHLQRKLãMD]DHOHNWULþQLSULERU]DJRVSRGLQMVWYDLQSRGREQHILNVQH
LQãWDODFLMHGHO 3RVHEQH]DKWHYH]DWDOQHRPDULFHLQRKLãMD ,(&
Boxes and enclosures for electrical accessories for household and similar fixed electrical
installations - Part 23: Particular requirements for floor boxes and enclosures (IEC 60670
-23:2006)
Dosen und Gehäuse für Installationsgeräte für Haushalt und ähnliche ortsfeste
elektrische Installationen - Teil 23: Besondere Anforderungen für Unterflurdosen (IEC
60670-23:2006)
Boîtes et enveloppes pour appareillage électrique pour installations électriques fixes
pour usages domestiques et analogues - Partie 23: Règles particulières pour les (CEI
60670-23:2006)boîtes et enveloppes de sol
Ta slovenski standard je istoveten z: EN 60670-23:2008
ICS:
29.120.99 'UXJDHOHNWULþQDGRGDWQD Other electrical accessories
RSUHPD
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
EUROPEAN STANDARD
EN 60670-23
NORME EUROPÉENNE
December 2008
EUROPÄISCHE NORM
ICS 29.120.10
English version
Boxes and enclosures for electrical accessories for
household and similar fixed electrical installations -
Part 23: Particular requirements for floor boxes and enclosures
(IEC 60670-23:2006, modified)
Boîtes et enveloppes pour appareillage Dosen und Gehäuse
électrique pour installations électriques für elektrische Installationsgeräte
fixes pour usages domestiques für Haushalt und ähnliche ortsfeste
et analogues - elektrische Installationen -
Partie 23: Règles particulières Teil 23: Besondere Anforderungen
pour les boîtes et enveloppes de sol für Unterflurdosen
(CEI 60670-23:2006, modifiée) (IEC 60670-23:2006, modifiziert)
This European Standard was approved by CENELEC on 2008-11-01. CENELEC members are bound to comply
with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard
the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on
application to the Central Secretariat or to any CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CENELEC member into its own language and notified
to the Central Secretariat has the same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Cyprus, the
Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia,
Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain,
Sweden, Switzerland and the United Kingdom.
CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
Central Secretariat: rue de Stassart 35, B - 1050 Brussels
© 2008 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 60670-23:2008 E
Foreword
The text of the International Standard IEC 60670-23:2006, prepared by SC 23B, Plugs, socket-outlets and
switches, of IEC TC 23, Electrical accessories, together with the common modifications prepared by the
Technical Committee CENELEC TC 23BX, d.c. plugs and socket outlets and switches for household and
similar fixed electrical installations, was submitted to the Unique Acceptance Procedure and was approved
by CENELEC as EN 60670-23 on 2008-11-01.
EN 60670-1:2005.
clause or subclause of Part 1 is not mentioned in this Part 23, that clause or subclause applies as far as is
reasonable. Where this Part 23 states “add”, “replace” or “delete”, the relevant text of Part 1 is to be adapted
accordingly.
Subclauses, figures, tables or notes which are additional to those in Part 1 are numbered starting from 101.
In this standard, the following print types are used:
- requirements proper: in roman type;
- test specifications: in italic type;
- notes: in smaller roman type.
The following dates were fixed:
– latest date by which the EN has to be implemented
at national level by publication of an identical
national standard or by endorsement (dop) 2009-11-01
– latest date by which the national standards conflicting
with the EN have to be withdrawn (dow) 2011-11-01
Annex ZB has been added by CENELEC.
_________
- 3 - EN 60670-23:2008
Endorsement notice
The text of the International Standard IEC 60670-23:2006 was approved by CENELEC as a European
Standard with agreed common modifications as given below.
COMMON MODIFICATIONS
1 Scope
Replace the whole Clause 1 by:
1 Scope
This clause of Part 1 is applicable except as follows:
Addition after the fourth paragraph:
This standard applies to floor boxes and floor enclosures.
The flush floor boxes and flush floor enclosures are intended to protect accessories against
load up to and including 1 000 N.
NOTE Outdoor requirements are under consideration.
7 Classification
7.2 Delete the note.
7.2.101.3 Add the following note:
NOTE The IP X4 rating is fulfilled with the lid, if any, closed and without any cables connected.
12 Construction
12.101 Add at the end of the compliance sentence:
"and by the test of 13.2".
13 Resistance to ageing, protection against ingress of solid objects and against
harmful ingress of water
13.3.101 Delete the first sentence.
Add the following at the end of the subclause:
Immediately after the test, there shall be no water in the box or enclosure.
15 Mechanical strength
15.101 Add at the end of the compliance paragraph:
"There shall be no damage neither to the means supporting the box in the floor nor to the lid."
Annex ZB
(normative)
Special national conditions
Special national condition: National characteristic or practice that cannot be changed even over a long
period, e.g. climatic conditions, electrical earthing conditions.
NOTE If it affects harmonization, it forms part of the European Standard.
For the countries in which the relevant special national conditions apply these provisions are normative, for
other countries they are informative.
Clause Special national condition
Denmark
13.3.101 Change the last paragraph in Subclause 13.3.101 to:
The floor enclosure shall be mounted as instructed to a level surface of impermeable material
with the lid(s), if any, closed and with plugs and connectors connected as in normal use. The
mounting surface shall extend 50 mm in each direction from the perimeter of the floor box
cover at its interface with the mounting surface.
__________
NORME CEI
INTERNATIONALE
IEC
60670-23
INTERNATIONAL
Première édition
STANDARD
First edition
2006-04
Boîtes et enveloppes pour appareillage électrique
pour installations électriques fixes
pour usages domestiques et analogues –
Partie 23:
Règles particulières pour les boîtes
et enveloppes de sol
Boxes and enclosures for electrical accessories
for household and similar fixed electrical
installations –
Part 23:
Particular requirements for floor boxes
and enclosures
IEC 2006 Droits de reproduction réservés Copyright - all rights reserved
Aucune partie de cette publication ne peut être reproduite ni No part of this publication may be reproduced or utilized in any
utilisée sous quelque forme que ce soit et par aucun procédé, form or by any means, electronic or mechanical, including
électronique ou mécanique, y compris la photocopie et les photocopying and microfilm, without permission in writing from
microfilms, sans l'accord écrit de l'éditeur. the publisher.
International Electrotechnical Commission, 3, rue de Varembé, PO Box 131, CH-1211 Geneva 20, Switzerland
Telephone: +41 22 919 02 11 Telefax: +41 22 919 03 00 E-mail: inmail@iec.ch Web: www.iec.ch
CODE PRIX
K
PRICE CODE
Commission Electrotechnique Internationale
International Electrotechnical Commission
МеждународнаяЭлектротехническаяКомиссия
Pour prix, voir catalogue en vigueur
For price, see current catalogue
60670-23 IEC:2006 – 3 –
CONTENTS
FOREWORD.5
1 Scope.9
2 Normative references .9
3 Definitions .9
4 General requirements .9
5 General notes on tests .11
6 Ratings.11
7 Classification.11
8 Marking .11
9 Dimensions .11
10 Protection against electric shock .13
11 Provision for earthing .13
12 Construction .13
13 Resistance to ageing, protection against ingress of solid objects and against
harmful ingress of water .13
14 Insulation resistance and electric strength .15
15 Mechanical strength .15
16 Resistance to heat.17
17 Creepage distances, clearances and distances through sealing compound .17
18 Resistance of insulating material to abnormal heat and fire .17
19 Resistance to tracking .17
20 Resistance to corrosion .17
21 Electromagnetic compatibility (EMC) .17
60670-23 IEC:2006 – 5 –
INTERNATIONAL ELECTROTECHNICAL COMMISSION
____________
BOXES AND ENCLOSURES FOR ELECTRICAL ACCESSORIES FOR
HOUSEHOLD AND SIMILAR FIXED ELECTRICAL INSTALLATIONS −
Part 23: Particular requirements for floor boxes and enclosures
FOREWORD
1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising
all national electrotechnical committees (IEC National Committees). The object of IEC is to promote
international co-operation on all questions concerning standardization in the electrical and electronic fields. To
this end and in addition to other activities, IEC publishes International Standards, Technical Specifications,
Technical Reports, Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC
Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested
in the subject dealt with may participate in this preparatory work. International, governmental and non-
governmental organizations liaising with the IEC also participate in this preparation. IEC collaborates closely
with the International Organization for Standardization (ISO) in accordance with conditions determined by
agreement between the two organizations.
2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international
consensus of opinion on the relevant subjects since each technical committee has representation from all
interested IEC National Committees.
3) IEC Publications have the form of recommendations for international use and are accepted by IEC National
Committees in that sense. While all reasonable efforts are made to ensure that the technical content of IEC
Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any
misinterpretation by any end user.
4) In order to promote international uniformity, IEC National Committees undertake to apply IEC Publications
transparently to the maximum extent possible in their national and regional publications. Any divergence
between any IEC Publication and the corresponding national or regional publication shall be clearly indicated in
the latter.
5) IEC provides no marking procedure to indicate its approval and cannot be rendered responsible for any
equipment declared to be in conformity with an IEC Publication.
6) All users should ensure that they have the latest edition of this publication.
7) No liability shall attach to IEC or its directors, employees, servants or agents including individual experts and
members of its technical committees and IEC National Committees for any personal injury, property damage or
other dam
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.