EN 61300-2-17:2003
(Main)Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 2-17: Tests - Cold
Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 2-17: Tests - Cold
Details a procedure for determining the suitability of a fibre optic device to withstand extended low temperature (cold)environmental conditions, which may occur in use, storage and/or transport. This procedure does not assess the ability of a device to operate during temperature variations; in this case, EN 61300-2-22 would be used.
Lichtwellenleiter - Verbindungselemente und passive Bauteile - Grundlegende Prüf- und Messverfahren - Teil 2-17: Prüfungen - Kälte
Dispositifs d'interconnexion et composants passifs à fibres optiques - Méthodes fondamentales d'essais et de mesures - Partie 2-17: Essais - Froid
Details a procedure for determining the suitability of a fibre optic device to withstand extended low temperature (cold)environmental conditions, which may occur in use, storage and/or transport. This procedure does not assess the ability of a device to operate during temperature variations; in this case, EN 61300-2-22 would be used.
Povezovalne naprave in pasivne komponente iz optičnih vlaken – Postopki osnovnega preskušanja in merjenja – 2-17. del: Testi - Mraz (IEC 61300-2- 17:2003)*
General Information
Relations
Standards Content (Sample)
SLOVENSKI SIST EN 61300-2-17:2004
STANDARD
september 2004
Povezovalne naprave in pasivne komponente iz optičnih vlaken – Postopki
osnovnega preskušanja in merjenja – 2-17. del: Testi - Mraz (IEC 61300-2-
17:2003)*
Fibre optic interconnecting devices and passive components - Basic test and
measurement procedures - Part 2-17: Tests - Cold (IEC 61300-2- 17:2003)
ICS 33.180.20 Referenčna številka
© Standard je založil in izdal Slovenski inštitut za standardizacijo. Razmnoževanje ali kopiranje celote ali delov tega dokumenta ni dovoljeno
EUROPEAN STANDARD EN 61300-2-17
NORME EUROPÉENNE
EUROPÄISCHE NORM April 2003
ICS 33.180.20 Supersedes EN 61300-2-17:1997
English version
Fibre optic interconnecting devices and passive components -
Basic test and measurement procedures
Part 2-17: Tests -
Cold
(IEC 61300-2-17:2003)
Dispositifs d'interconnexion Lichtwellenleiter-Verbindungselemente
et composants passifs à fibres optiques - und passive Bauteile -
Méthodes fondamentales d'essais Grundlegende Prüf- und Messverfahren
et de mesures Teil 2-17: Prüfungen -
Partie 2-17: Essais - Kälte
Froid (IEC 61300-2-17:2003)
(CEI 61300-2-17:2003)
This European Standard was approved by CENELEC on 2003-03-01. CENELEC members are bound to
comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on
application to the Central Secretariat or to any CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CENELEC member into its own language and
notified to the Central Secretariat has the same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Czech Republic,
Denmark, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Luxembourg, Malta,
Netherlands, Norway, Portugal, Slovakia, Spain, Sweden, Switzerland and United Kingdom.
CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
Central Secretariat: rue de Stassart 35, B - 1050 Brussels
© 2003 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 61300-2-17:2003 E
Foreword
The text of document 86B/1777/FDIS, future edition 2 of IEC 61300-2-17, prepared by SC 86B, Fibre
optic interconnecting devices and passive components, of IEC TC 86, Fibre optics, was submitted to
the IEC-CENELEC parallel vote and was approved by CENELEC as EN 61300-2-17 on 2003-03-01.
This European Standard supersedes EN 61300-2-17:1997.
The following dates were fixed:
– latest date by which the EN has to be implemented
at national level by publication of an identical
national standard or by endorsement (dop) 2003-12-01
– latest date by which the national standards conflicting
with the EN have to be withdrawn (dow) 2006-03-01
Annexes designated "normative" are part of the body of the standard.
In this standard, annex ZA is normative.
Annex ZA has been added by CENELEC.
__________
Endorsement notice
The text of the International Standard IEC 61300-2-17:2003 was approved by CENELEC as a
European Standard without any modification.
__________
- 3 - EN 61300-2-17:2003
Annex ZA
(normative)
Normative references to international publications
with their corresponding European publications
This European Standard incorporates by dated or undated reference, provisions from other
publications. These normative references are cited at the appropriate places in the text and the
publications are listed hereafter. For dated references, subsequent amendments to or revisions of any
of these publications apply to this European Standard only when incorporated in it by amendment or
revision. For undated references the latest edition of the publication referred to applies (including
amendments).
NOTE When an international publication has been modified by common modifications, indicated by (mod), the relevant
EN/HD applies.
Publication Year Title EN/HD Year
1) 2)
IEC 60068-2-1 - Environmental testing EN 60068-2-1 1993
Part 2: Tests - Tests A: Cold
1) 2)
IEC 61300-2-22 - Fibre optic interconnecting devices and EN 61300-2-22 1997
passive components - Basic test and
measurement procedures
Part 2-22: Tests - Change of
temperature
1)
Undated reference.
2)
Valid edition at date of issue.
INTERNATIONAL IEC
STANDARD 61300-2-17
Second edition
2003-02
Fibre optic interconnecting devices
and passive components –
Basic test and measurement procedures –
Part 2-17:
Tests – Cold
Dispositifs d'interconnexion et composants passifs
à fibres optiques –
Méthodes fondamentales d'essais et de mesures –
Partie 2-17:
Essais – Froid
© IEC 2003 ⎯ Copyright - all rights reserved
No part of this publication may be reproduced or utilized in any form or by any means, electronic or
mechanical, including photocopying and microfilm, without permission in writing from the publisher.
International Electrotechnical Commission, 3, rue de Varembé, PO Box 131, CH-1211 Geneva 20, Switzerland
Telephone: +41 22 919 02 11 Telefax: +41 22 919 03 00 E-mail: inmail@iec.ch Web: www.iec.ch
PRICE CODE
Commission Electrotechnique Internationale F
International Electrotechnical Commission
ɆɟɠɞɭɧɚɪɨɞɧɚɹɗɥɟɤɬɪɨɬɟɯɧɢɱɟɫɤɚɹɄɨɦɢɫɫɢɹ
For price, see current catalogue
– 2 – 61300-2-17 © IEC:2003(E)
INTERNATIONAL ELECTROTECHNICAL COMMISSION
____________
FIBRE OPTIC INTERCONNECTING DEVICES
AND PASSIVE COMPONENTS –
BASIC TEST AND MEASUREMENT PROCEDURES –
Part 2-17: Tests – Cold
FOREWORD
1) The IEC (International Electrotechnical Commission) is a worldwide organization for standardization comprising
all national electrotechnical committees (IEC National Committees). The object of the IEC is to promote
international co-operation on all questions concerning standardization in the electrical and electronic fields. To
this end and in addition to other activities, the IEC publishes International Standards. Their preparation is
entrusted to technical committees; any IEC National Committee interested in the subject dealt with may
participate in this preparatory work. International, governmental and non-governmental organizations liaising
with the IEC also participate in this preparation. The IEC collaborates closely with the International
Organization for Standardization (ISO) in accordance with conditions determined by agreement between the
two organizations.
2) The formal decisions or agreements of the IEC on technical matters express, as nearly as possible, an
international consensus of
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.