EN 61300-2-17:2011

Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 2-17: Tests - Cold

IEC 61300-2-17:2010 details a procedure for determining the suitability of a fibre optic device to withstand environmental conditions of extended low temperature (cold), which may occur in use, storage and/or transport. This procedure does not assess the ability of a device to operate during temperature variations; in this case, IEC 61300-2-22 would be used. The main changes with respect to the previous edition are: - Procedure and details to be specified were reconsidered; - The deviation of the temperature in severity was changed ± 3 °C to ± 2 °C.

Lichtwellenleiter - Verbindungselemente und passive Bauteile - Grundlegende Prüf- und Messverfahren - Teil 2-17: Prüfungen - Kälte

Dispositifs d’interconnexion et composants passifs à fibres optiques - Méthodes fondamentales d’essais et de mesures - Partie 2-17: Essais - Froid

La CEI 61300-2-17:2010 précise une méthode destinée à déterminer l'aptitude d'un dispositif à fibres optiques à supporter des conditions environnementales de basse température prolongée (froid) qui peuvent intervenir en cours d'utilisation, de stockage et/ou de transport. Ladite méthode n'évalue pas la capacité d'un dispositif à fonctionner pendant des variations de température; dans ce cas, c'est la CEI 61300-2-22 qui s'applique. Les principales modifications par rapport à l'édition antérieure du document sont: - La procédure et les détails devant être spécifiés ont été réexaminés; - L'écart de température dans la partie sévérité a été modifié de ± 3 °C à ± 2 °C.

Optični spojni elementi in pasivne komponente - Postopki osnovnega preskušanja in merjenja - 2-17. del: Preskusi - Mraz (IEC 61300-2-17:2010)

Ta del IEC 61300 podrobno opisuje postopek ugotavljanja primernosti optičnega elementa, da kljubuje okoljskim razmeram z zelo nizko temperaturo (v mrazu), do katerih lahko pride pri uporabi, shranjevanju in/ali prevozu. Ta postopek ne ocenjuje zmožnosti pripomočka za delovanje pri temperaturnem nihanju; v tem primeru bi se uporabil IEC 61300-2-22.

General Information

• Status: Published
• Publication Date: 17-Mar-2011
• Withdrawal Date: 02-Jan-2012
• ICS: 33.180.10 - Fibres and cables
• Technical Committee: CLC/TC 86BXA - Fibre optic interconnect, passive and connectorised components
• Drafting Committee: IEC/SC 86B - IEC_SC_86B
• Parallel Committee: IEC/SC 86B - IEC_SC_86B
• Current Stage: 6060 - Document made available - Publishing
• Start Date: 18-Mar-2011
• Completion Date: 18-Mar-2011
• Ref Project: SIST EN 61300-2-17:2011 - Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 2-17: Tests - Cold (IEC 61300-2-17:2010)

Relations

• Replaces: EN 61300-2-17:2003 - Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 2-17: Tests - Cold
• Effective Date: 29-Jan-2023

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN 61300-2-17:2011
01-maj-2011
1DGRPHãþD
SIST EN 61300-2-17:2004
2SWLþQLVSRMQLHOHPHQWLLQSDVLYQHNRPSRQHQWH3RVWRSNLRVQRYQHJDSUHVNXãDQMD
LQPHUMHQMDGHO3UHVNXVL0UD],(&
Fibre optic interconnecting devices and passive components - Basic test and
measurement procedures - Part 2-17: Tests - Cold (IEC 61300-2-17:2010)
Lichtwellenleiter - Verbindungselemente und passive Bauteile - Grundlegende Prüf- und
Messverfahren - Teil 2-17: Prüfungen - Kälte (IEC 61300-2-17:2010)
Dispositifs d’interconnexion et composants passifs à fibres optiques - Méthodes
fondamentales d’essais et de mesures - Partie 2-17: Essais - Froid (CEI 61300-2-
17:2010)
Ta slovenski standard je istoveten z: EN 61300-2-17:2011
ICS:
33.180.20 3RYH]RYDOQHQDSUDYH]D Fibre optic interconnecting
RSWLþQDYODNQD devices
SIST EN 61300-2-17:2011 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN 61300-2-17:2011

---------------------- Page: 2 ----------------------

SIST EN 61300-2-17:2011

EUROPEAN STANDARD
EN 61300-2-17

NORME EUROPÉENNE
March 2011
EUROPÄISCHE NORM

ICS 33.180.10 Supersedes EN 61300-2-17:2003


English version


Fibre optic interconnecting devices and passive components -
Basic test and measurement procedures -
Part 2-17: Tests -
Cold
(IEC 61300-2-17:2010)


Dispositifs d’interconnexion et Lichtwellenleiter -
composants passifs à fibres optiques - Verbindungselemente und passive
Méthodes fondamentales d’essais et de Bauteile -
mesures - Grundlegende Prüf- und Messverfahren -
Partie 2-17: Essais - Teil 2-17: Prüfungen -
Froid Kälte
(CEI 61300-2-17:2010) (IEC 61300-2-17:2010)




This European Standard was approved by CENELEC on 2011-01-03. CENELEC members are bound to comply
with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard
the status of a national standard without any alteration.

Up-to-date lists and bibliographical references concerning such national standards may be obtained on
application to the Central Secretariat or to any CENELEC member.

This European Standard exists in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CENELEC member into its own language and notified
to the Central Secretariat has the same status as the official versions.

CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus,
the Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy,
Latvia, Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia,
Spain, Sweden, Switzerland and the United Kingdom.

CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung

Management Centre: Avenue Marnix 17, B - 1000 Brussels


© 2011 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 61300-2-17:2011 E

---------------------- Page: 3 ----------------------

SIST EN 61300-2-17:2011
EN 61300-2-17:2011 - 2 -
Foreword
The text of document 86B/2984/CDV, future edition 3 of IEC 61300-2-17, prepared by SC 86B, Fibre
optic interconnecting devices and passive components, of IEC TC 86, Fibre optics, was submitted to the
IEC-CENELEC parallel vote and was approved by CENELEC as EN 61300-2-17 on 2011-01-03.
This European Standard supersedes EN 61300-2-17:2003.
The main changes with respect to EN 61300-2-17:2003 are listed below:
a) Procedure and details to be specified were reconsidered;
b) The deviation of the temperature in severity was changed ± 3 °C to ± 2 °C.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CEN and CENELEC shall not be held responsible for identifying any or all such patent
rights.
The following dates were fixed:
– latest date by which the EN has to be implemented
at national level by publication of an identical
(dop) 2011-10-03
national standard or by endorsement
– latest date by which the national standards conflicting
(dow) 2012-01-03
with the EN have to be withdrawn
Annex ZA has been added by CENELEC.
__________
Endorsement notice
The text of the International Standard IEC 61300-2-17:2010 was approved by CENELEC as a European
Standard without any modification.
In the official version, for Bibliography, the following note has to be added for the standard indicated:
IEC 61300-2-22 NOTE  Harmonized as EN 61300-2-22.
__________

---------------------- Page: 4 ----------------------

SIST EN 61300-2-17:2011
- 3 - EN 61300-2-17:2011
An
...