EN 60598-2-5:1998
(Main)Luminaires - Part 2-5: Particular requirements - Floodlights
Luminaires - Part 2-5: Particular requirements - Floodlights
Specifies requirements for floodlights for use with tungsten filament, tubular fluorescent and other discharge lamps on supply voltages not exceeding 1 000 V.
Leuchten - Teil 2: Besondere Anforderungen - Hauptabschnitt 5: Scheinwerfer
Luminaires - Partie 2-5: Règles particulières - Projecteurs
Détaille les prescriptions applicables aux projecteurs à utiliser avec des lampes à filament de tungstène, des lampes tubulaires fluorescentes ou autres lampes à décharge, pour des tensions d'alimentation ne dépassant pas 1 000 V.
Svetilke - 2-5. del: Posebne zahteve - Žarometi in sojniki (IEC 60598-2-5:1998)
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
01-julij-1999
1DGRPHãþD
SIST EN 60598-2-5:1995
Svetilke - 2-5. del: Posebne zahteve - Žarometi in sojniki (IEC 60598-2-5:1998)
Luminaires - Part 2-5: Particular requirements - Floodlights
Leuchten - Teil 2: Besondere Anforderungen - Hauptabschnitt 5: Scheinwerfer
Luminaires - Partie 2-5: Règles particulières - Projecteurs
Ta slovenski standard je istoveten z: EN 60598-2-5:1998
ICS:
29.140.40 Svetila Luminaires
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
INTERNATIONAL IEC
STANDARD 60598-2-5
Second edition
1998-01
Luminaires –
Part 2-5:
Particular requirements –
Floodligths
IEC 1998 Copyright - all rights reserved
No part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical,
including photocopying and microfilm, without permission in writing from the publisher.
International Electrotechnical Commission, 3, rue de Varembé, PO Box 131, CH-1211 Geneva 20, Switzerland
Telephone: +41 22 919 02 11 Telefax: +41 22 919 03 00 E-mail: inmail@iec.ch Web: www.iec.ch
PRICE CODE
H
Commission Electrotechnique Internationale
International Electrotechnical Commission
МеждународнаяЭлектротехническаяКомиссия
For price, see current catalogue
IS 01 Interpretation of subclause 5.6.8
IEC 60598-2-5 : 1998 Second edition
Luminaires - Part 2: Particular requirements
Section Five – Floodlights
INTERPRETATION SHEET
The following interpretation was agreed at the Bled meeting of IEC/SC 34D WG LUMEX held in
April 1996.
When the test sample remains as one sheet, the fragmentation lines would normally be used to
indicate fractures and the size and number of particles would thus be evaluated, unless
reinforcing or a film were employed.
March 2001 ICS 29.140.40 French text overleaf
60598-2-5 © IEC:1998 – 3 –
CONTENTS
Page
FOREWORD . 5
Clause
5.1 Scope. 7
5.2 General test requirements . 7
5.3 Definitions . 7
5.4 Classification of luminaires . 7
5.5 Marking . 7
5.6 Construction. 9
5.7 Creepage distances and clearances . 11
5.8 Provision for earthing. 11
5.9 Terminals . 11
5.10 External and internal wiring. 11
5.11 Protection against electric shock. 13
5.12 Endurance tests and thermal tests. 13
5.13 Resistance to dust and moisture . 13
5.14 Insulation resistance and electric strength. 13
5.15 Resistance to heat, fire and tracking . 13
Figure 1 – Counting particles at the edge of the square. 15
60598-2-5 © IEC:1998 – 5 –
INTERNATIONAL ELECTROTECHNICAL COMMISSION
_________
LUMINAIRES –
Part 2-5: Particular requirements – Floodlights
FOREWORD
1) The IEC (International Electrotechnical Commission) is a worldwide organization for standardization comprising
all national electrotechnical committees (IEC National Committees). The object of the IEC is to promote
international co-operation on all questions concerning standardization in the electrical and electronic fields. To
this end and in addition to other activities, the IEC publishes International Standards. Their preparation is
entrusted to technical committees; any IEC National Committee interested in the subject dealt with may
participate in this preparatory work. International, governmental and non-governmental organizations liaising
with the IEC also participate in this preparation. The IEC collaborates closely with the International Organization
for Standardization (ISO) in accordance with conditions determined by agreement between the two
organizations.
2) The formal decisions or agreements of the IEC on technical matters express, as nearly as possible, an
international consensus of opinion on the relevant subjects since each technical committee has representation
from all interested National Committees.
3) The documents produced have the form of recommendations for international use and are published in the form
of standards, technical reports or guides and they are accepted by the National Committees in that sense.
4) In order to promote international unification, IEC National Committees undertake to apply IEC International
Standards transparently to the maximum extent possible in their national and regional standards. Any
divergence between the IEC Standard and the corresponding national or regional standard shall be clearly
indicated in the latter.
5) The IEC provides no marking procedure to indicate its approval and cannot be rendered responsible for any
equipment declared to be in conformity with one of its standards.
6) Attention is drawn to the possibility that some of the elements of this International Standard may be the subject
of patent rights. The IEC shall not be held responsible for identifying any or all such patent rights.
International Standard IEC 60598-2-5 has been prepared by subcommittee 34D: Luminaires, of
IEC technical committee 34: Lamps and related equipment.
This second edition cancels and replaces the first edition published in 1979, amendment 1
(1987) and amendment 2 (1993), and constitutes a technical revision.
The text of this standard is based on the first edition, amendment 1 and amendment 2, and the
following documents:
FDIS Report on voting
34D/476/FDIS 34D/487/RVD
Full information on the voting for the approval of this standard can be found in the report on
voting indicated in the above table.
60598-2-5 © IEC:1998 – 7 –
LUMINAIRES –
Part 2-5: Particular requirements – Floodlights
5.1 Scope
This part of IEC 60598 specifies requirements for floodlights for use with tungsten filament,
tubular fluorescent and other discharge lamps on supply voltages not exceeding 1 000 V. It is
to be read in conjunction with those sections of IEC 60598-1 to which reference is made.
5.2 General test requirements
The provisions of section 0 of IEC 60598-1 apply. The tests described in each appropriate
section of IEC 60598-1 shall be carried out in the order listed in this part.
5.3 Definitions
For the purposes of this part of IEC 60598, the definitions of section 0 of IEC 60598-1 apply
together with the following definitions:
5.3.1
floodlighting
lighting by projection of the whole of a scene or subject to an illuminance significan
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.