EN 61104:1992

Compact disc video system - 12 cm CD-V

Specifies system parameters and applies to the pre-recorded optical reflective disc system called 'compact disc video (CD video)' containing digital audio and 'Laser Vision' video information. In the case of CD video, this standard modifies the relevant text in EN 60908.

Compact-Disc-Video-System - 12-cm-CD-V

Système de videodisque compact - 12 cm CD-V

Spécifie les caractéristiques du système et s'applique au système de disque optique réfléchissant préenregistré, appelé "vidéodisque compact (CD vidéo)" et contenant des informations audionumériques et des informations vidéo "Laser vision". Dans le cas d'un vidéodisque compact, cette norme modifie le texte correspondant dans la EN 60908.

Compact disc video system - 12 cm CD-V (IEC 61104:1992)

General Information

• Status: Published
• Publication Date: 10-Sep-1992
• Withdrawal Date: 31-May-1993
• Technical Committee: CLC/TC 100X - Audio, video and multimedia systems and equipment and related sub-systems
• Drafting Committee: IEC/TC 100 - IEC_TC_100
• Parallel Committee: IEC/TC 100 - IEC_TC_100
• Current Stage: 6060 - Document made available - Publishing
• Start Date: 11-Sep-1992
• Completion Date: 11-Sep-1992
• Ref Project: SIST EN 61104:1999 - Compact disc video system - 12 cm CD-V

Standards Content (Sample)

SLOVENSKI STANDARD
01-julij-1999
Compact disc video system - 12 cm CD-V (IEC 61104:1992)
Compact disc video system - 12 cm CD-V
Compact-Disc-Video-System - 12-cm-CD-V
Système de videodisque compact - 12 cm CD-V
Ta slovenski standard je istoveten z: EN 61104:1992
ICS:
33.160.40 Video sistemi Video systems
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

NORME CEI
INTERNATIONALE IEC
INTERNATIONAL
Première édition
STAN DARD
First edition
1992-06
Système
de vidéodisque compact – 12 cm CD-V
Compact disc video system – 12 cm CD-V
© IEC 1992 Droits de reproduction
réservés — Copyright - all rights reserved
Aucune partie de cette publication
ne peut être reproduite ni No part of this publication may be reproduced or utilized in
utilisée sous quelque forme que ce soit
et par aucun any form or by any means, electronic or mechanical,
procédé, électronique ou mécanique,
y compris la photo- including photocopying and microfilm, without permission in
copie et les microfilms, sans
l'accord écrit de l'éditeur. writing from the publisher.
International Electrotechnical Commission 3, rue de Varembé Geneva, Switzerland
Telefax: [phone] e-mail: [e-mail] IEC web site http: //www.iec.ch
CODE PRIX
Commission Electrotechnique Internationale
L
PRICE CODE
International Electrotechnical Commission
IEC
Me1HnyHapoitHaR 311eKTpOT@XHH4eCHaR KOMHCCHH
Pour prix, voir catalogue en vigueur
•
For price, see current catalogue

1104©IEC —3—
INTERNATIONAL ELECTROTECHNICAL COMMISSION
COMPACT DISC VIDEO SYSTEM - 12 cm CD-V
FOREWORD
1)
The formal decisions or agreements of the IEC on technical matters, prepared by Technical Committees on
which all the National Committees having a special interest therein are represented, express, as nearly as
possible, an international consensus of opinion on the subjects dealt with.
2)
They have the form of recommendations for international use and they are accepted by the National
Committees in that sense.
3)
In order to promote international unification, the IEC expresses the wish that all National Committees
should adopt the text of the IEC recommendation for their national rules in so far as national conditions will
permit. Any divergence between the IEC recommendation and the corresponding national rules should, as
far as possible, be clearly indicated in the latter.
This International Standard has been prepared by Sub-Committee 60A: Sound recording,
of IEC Technical Committee No. 60: Recording.
This standard should be read in conjunction with IEC 908: 1987.
The text of this International Standard is based on the following documents:
DIS Report on Voting
60A(CO)142
60A(CO)145
Full information on the voting for the approval of this standard can be found in the Voting
Repo rt
indicated in the above table.
1104©IEC -5-
INTRODUCTION
This International Standard specifies the implementation of video information as an
optional addition to IEC 908. Reference is made to IEC 856 and IEC 857.

1104©IEC -7-
COMPACT DISC VIDEO SYSTEM - 12 cm CD-V
1 Scope
This International Standard is applicable to a pre-recorded optical reflective disc system
called "compact disc video (CD video)" containing digital audio and "Laser vision" video
information.
In the case of CD video the subclauses mentioned in this standard shall modify the
relevant text in IEC 908.
2 Normative references
The following normative documents contain provisions which, through reference in this
text, constitute provisions of this International Standard. At the time of publication of this
standard, the editions indicated were valid. All normative documents are subject to
revision, and parties to agreements based on this International Standard are encouraged
to investigate the possibility of applying the most recent editions of the normative
documents indicated below. Members of IEC and ISO maintain registers of currently valid
International Standards.
Pre-recorded optical reflective videodisk system. "Laser vision" 50 Hz/
IEC 856: 1986,
625 lines - PAL.
Pre-recorded optical reflective videodisk system. "Laser vision" 60 Hz/
IEC 857: 1986,
525 lines - M/NTSC.
IEC 908: 1987, Compact disc digital audio system.
4.2 Requirements for the measuring pick-up
Change:
- numerical aperture (NA): 0,50 ± 0,01.
5.7 Mass of disc: 14 g to 20 g
7 Recording parameters
7.1 Rotation during playback (see figure 17)
Requirements
Video Video
7.1.2 a) Audio
PAL
NTSC
9,2 m/s min.
Scanning velocity 1,2 m/s min. 11 m/s min.
1,4 m/s max. 12 m/s max. 10,2 m/s max.
CLV
45,1 37,6
7.1.2 b) Maximum number of Not specified
revolutions/s
37,5 ± 0,1
7.1.2 c) Number of revolutions/s - 45 ± 0,1
in video lead-in area CAV
7.1.3 Limits for the velocity ±0,01 m/s Not specified Not specified
variation on any one disc
12,5 15 µs*
7.1.4 Maximum time base error (peak- µs`
to-peak) at rotational frequency
- 12 dB/oct. 12 dB/oct.
Roll-off for higher
frequencies
3 ns r.m.s. 3 ns r.m.s.
7.1.5 For frequencies > 1 000 Hz
maximum time base noise
To be fixed
Integration time To be fixed
Remark: time base errors have to be measured on the "colour burst'.

1104©IEC - 9 -
Replace 7.2 by the following:
Methods and/or
Parameters Requirements
conditions of
measurement
Video
Audio
7.2 Track
Continuous spiral from inside (start of lead-in) to outside
7.2.1 Track path
(end of lead-out of video with digital audio) of the disc.
Track interruption allowed between audio and video part
for which an area of maximum 20 pm width with unde-
fined pit structure is allowed
7.2.2 Starting diameter of 46 mm max. Outer diameter of audio
lead-out area +40 pm (max.)
lead-in area
78 ± 0,2 mm
7.2.3 Starting diameter of 50 â mm
a
program area
7.2.4 Maximum diameter of 74 mm 116 mm
program area
7.2.5a Outer diameter of 75 ± 0,2 mm
audio lead-out area
7.2.5b Minimum outer diameter of Outer diameter of program
area plus 1 mm
video lead-out area
1,7 ± 0,2 pm
7.2.6 Pitch of track: distance 1,6 ± 0,1 pm
between any two adjacent turns
Replace 7.3 by the following:
Methods and/or
Requirements
Parameters
conditions of
measurement
7.3 Limits for deviations of
information layer
perpendicular to
reference plane
Audio part Video part
7.3.1 For frequencies Below 500 Hz Below 1 000 Hz
7.3.1.1 ±0,5 mm ±0,5 mm
Deviation from nominal value
7.3.1.2 RMS value 0,4 mm max. 0,4 mm max.
7.3.1.3 Acceleration 10 m/s2 max. 40 m/s2 max.
7.3.2 For frequencies Exceeding 500 Hz Exceeding 1 000 Hz
2 pm peak-to-peak max.
Deviation 2 µm peak-to-peak max.
7.4 Limits for radial deviations
of the track
7.4.1 For frequencies Below 500 Hz Below 2 500 Hz
7.4.1.1 Radial run-out of tracks (µm) 140 µm peak-to-peak max. 140 pm peak-to-peak max.
7.4.1.2 Radial acceleration (m/s2) 0,
...