IEC 60904-4:2009

Photovoltaic devices - Part 4: Reference solar devices - Procedures for establishing calibration traceability

IEC 60904-4:2009 sets the requirements for calibration procedures intended to establish the traceability of photovoltaic reference solar devices to SI units as required by IEC 60904-2. Applies to photovoltaic (PV) reference solar devices that are used to measure the irradiance of natural or simulated sunlight for the purpose of quantifying the performance of PV devices. The use of a PV reference solar device is required in the application of IEC 60904-1 and IEC 60904-3.

Dispositifs photovoltaïques - Partie 4: Dispositifs solaires de référence - Procédures pour établir la traçabilité de l'étalonnage

La CEI 60904-4:2009 fixe les exigences relatives aux procédures d'étalonnage, dans le but d'établir la traçabilité des dispositifs solaires photovoltaïques de référence en unités SI, comme cela est stipulé par la CEI 60904-2. La présente norme s'applique aux dispositifs solaires photovoltaïques (PV) de référence utilisés pour mesurer l'éclairement énergétique de la lumière solaire naturelle ou simulée, afin de quantifier les performances des dispositifs PV. L'utilisation d'un dispositif solaire PV de référence est requise lors de l'application des CEI 60904-1 et CEI 60904-3.

General Information

• Status: Published
• Publication Date: 08-Jun-2009
• ICS: 27.160 - Solar energy engineering
• Technical Committee: TC 82 - Solar photovoltaic energy systems
• Drafting Committee: WG 2 - TC 82/WG 2
• Current Stage: DELPUB - Deleted Publication
• Completion Date: 12-Nov-2019

Relations

• Revised: IEC 60904-4:2019 - Photovoltaic devices - Part 4: Photovoltaic reference devices - Procedures for establishing calibration traceability
• Effective Date: 05-Sep-2023

Standards Content (Sample)

IEC 60904-4 ®
Edition 1.0 2009-06
INTERNATIONAL
STANDARD
NORME
INTERNATIONALE
Photovoltaic devices –
Part 4: Reference solar devices – Procedures for establishing calibration
traceability
Dispositifs photovoltaïques –
Partie 4: Dispositifs solaires de référence – Procédures pour établir la traçabilité
de l'étalonnage
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by

any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IEC or

IEC's member National Committee in the country of the requester.
If you have any questions about IEC copyright or have an enquiry about obtaining additional rights to this publication,
please contact the address below or your local IEC member National Committee for further information.

Droits de reproduction réservés. Sauf indication contraire, aucune partie de cette publication ne peut être reproduite
ni utilisée sous quelque forme que ce soit et par aucun procédé, électronique ou mécanique, y compris la photocopie
et les microfilms, sans l'accord écrit de la CEI ou du Comité national de la CEI du pays du demandeur.

Si vous avez des questions sur le copyright de la CEI ou si vous désirez obtenir des droits supplémentaires sur cette

publication, utilisez les coordonnées ci-après ou contactez le Comité national de la CEI de votre pays de résidence.

IEC Central Office
3, rue de Varembé
CH-1211 Geneva 20
Switzerland
Email: [e-mail]
Web: www.iec.ch
About the IEC
The International Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes
International Standards for all electrical, electronic and related technologies.

About IEC publications
The technical content of IEC publications is kept under constant review by the IEC. Please make sure that you have the
latest edition, a corrigenda or an amendment might have been published.
ƒ Catalogue of IEC publications: www.iec.ch/searchpub
The IEC on-line Catalogue enables you to search by a variety of criteria (reference number, text, technical committee,…).
It also gives information on projects, withdrawn and replaced publications.
ƒ IEC Just Published: www.iec.ch/online_news/justpub
Stay up to date on all new IEC publications. Just Published details twice a month all new publications released. Available
on-line and also by email.
ƒ Electropedia: www.electropedia.org
The world's leading online dictionary of electronic and electrical terms containing more than 20 000 terms and definitions
in English and French, with equivalent terms in additional languages. Also known as the International Electrotechnical
Vocabulary online.
ƒ Customer Service Centre: www.iec.ch/webstore/custserv
If you wish to give us your feedback on this publication or need further assistance, please visit the Customer Service
Centre FAQ or contact us:
Email: [e-mail]
Tel.: [phone]
Fax: [phone]
A propos de la CEI
La Commission Electrotechnique Internationale (CEI) est la première organisation mondiale qui élabore et publie des
normes internationales pour tout ce qui a trait à l'électricité, à l'électronique et aux technologies apparentées.

A propos des publications CEI
Le contenu technique des publications de la CEI est constamment revu. Veuillez vous assurer que vous possédez
l’édition la plus récente, un corrigendum ou amendement peut avoir été publié.
ƒ Catalogue des publications de la CEI: www.iec.ch/searchpub/cur_fut-f.htm
Le Catalogue en-ligne de la CEI vous permet d’effectuer des recherches en utilisant différents critères (numéro de référence,
texte, comité d’études,…). Il donne aussi des informations sur les projets et les publications retirées ou remplacées.
ƒ Just Published CEI: www.iec.ch/online_news/justpub
Restez informé sur les nouvelles publications de la CEI. Just Published détaille deux fois par mois les nouvelles
publications parues. Disponible en-ligne et aussi par email.
ƒ Electropedia: www.electropedia.org
Le premier dictionnaire en ligne au monde de termes électroniques et électriques. Il contient plus de 20 000 termes et
définitions en anglais et en français, ainsi que les termes équivalents dans les langues additionnelles. Egalement appelé
Vocabulaire Electrotechnique International en ligne.
ƒ Service Clients: www.iec.ch/webstore/custserv/custserv_entry-f.htm
Si vous désirez nous donner des commentaires sur cette publication ou si vous avez des questions, visitez le FAQ du
Service clients ou contactez-nous:
Email: [e-mail]
Tél.: [phone]
Fax: [phone]
IEC 60904-4 ®
Edition 1.0 2009-06
INTERNATIONAL
STANDARD
NORME
INTERNATIONALE
Photovoltaic devices –
Part 4: Reference solar devices – Procedures for establishing calibration
traceability
Dispositifs photovoltaïques –
Partie 4: Dispositifs solaires de référence – Procédures pour établir la traçabilité
de l'étalonnage
INTERNATIONAL
ELECTROTECHNICAL
COMMISSION
COMMISSION
ELECTROTECHNIQUE
PRICE CODE
INTERNATIONALE
T
CODE PRIX
ICS 27.160 ISBN 978-2-88910-323-2
– 2 – 60904-4 © IEC:2009
CONTENTS
FOREWORD.3

1 Scope and object.5

2 Normative references .5

3 Terms and definitions .5

4 Requirements for traceable calibration procedures of PV reference solar devices .7

5 Uncertainty analysis .8

6 Calibration report.8

7 Marking .8
Annex A (informative) Examples of validated calibration procedures.10
Bibliography.24

Figure 1 – Schematic of most common reference instruments and transfer methods
used in the traceability chains for solar irradiance detectors. .7
Figure A.1 – Block diagram of differential spectral responsivity calibration
superimposing chopped monochromatic radiation DE(l) and DC bias radiation E .18
b
Figure A.2 – Optical arrangement of differential spectral responsivity calibration. .19
Figure A.3 – Schematic apparatus of the solar simulator method. .21

Table 1 – Examples of reference instruments, used in a traceability chain of time and
solar irradiance.7
Table A.1 – Typical uncertainty components (k = 2) of global sunlight method .15
Table A.2 – Typical uncertainty components (k = 2) of a differential spectral
responsivity calibration .18
Table A.3 – Example of uncertainty components (k = 2) of a solar simulator method
calibration.21
Table A.4 – Typical uncertainty components (k = 2) of a solar simulator method
calibration when WRR traceable cavity radiometer is used .21
Table A.5 – Typical uncertainty components (k = 2) of a direct sunlight method .23

60904-4 © IEC:2009 – 3 –
INTERNATIONAL ELECTROTECHNICAL COMMISSION

____________
PHOTOVOLTAIC DEVICES –
Part 4: Reference solar devices –

Procedures for establishing calibration traceability

FOREWORD
1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising
all national electrotechnical committees (IEC National Committees). The object of IEC is to promote
international co-operation on all questions concerning standardization in the electrical and electronic fields. To
this end and in addition to other activities, IEC publishes International Standards, Technical Specifications,
Technical Reports, Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC
Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested
in the subject dealt with may participate in this preparatory work. International, governmental and non-
governmental organizations liaising with the IEC also participate in this preparation. IEC collaborates closely
with the International Organization for Standardization (ISO) in accordance with conditions determined by
agreement between the two organizations.
2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international
consensus of opinion on the relevant subjects since each technical committee has representation from all
interested IEC National Committees.
3) IEC Publications have the form of recommendations for international use and are accepted by IEC National
Committees in that sense. While all reasonable efforts are made to ensure that the technical content of IEC
Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any
misinterpretation by any end user.
4) In order to promote international uniformity, IEC National Committees undertake to apply IEC Publications
transparently to the maximum extent possible in their national and regional publications. Any divergence
between any IEC Publication and the corresponding national or regional publication shall be clearly indicated in
the latter.
5) IEC provides no marking procedure to indicate its approval and cannot be rendered responsible for any
equipment declared to be in conformity with an IEC Publication.
6) All users should ensure that they have the latest edition of this publication.
7) No liability shall attach to IEC or its directors, employees, servants or agents including individual experts and
members of its technical committees and IEC National Committees for any personal injury, property damage or
other damage of any nature whatsoever, whether direct or indirect, or for costs (including legal fees) and
expenses arising out of the publication, use of, or reliance upon, this IEC Publication or any other IEC
Publications.
8) Attention is drawn to the Normative references cited in this publication. Use of the referenced publications is
indispensable for the correct application of this publication.
9) Attention is drawn to the possibility that some of the elements of this IEC Publication may be the subject of
patent rights. IEC shall not be held responsible for identifying any or all such patent rights.
International Standard IEC 60904-4 has been prepared by IEC technical committee 82: Solar
photovoltaic energy systems.
The text of this standard is based on the following documents:
CDV Report on voting
82/533/CDV 82/561/RVC
Full information on the voting for the approval of this standard can be found in the report on
voting indicated in the above table.
This publication has been drafted in accordance with the ISO/IEC Directives, Part 2.
A list of all parts of IEC 60904 series, under the general title Photovoltaic devices, can be
found on the IEC website.
– 4 – 60904-4 © IEC:2009
The committee has decided that the contents of this publication will remain unchanged until

the maintenance result date indicated on the IEC web site under "http://webstore.iec.ch" in

the data related to the specific publication. At this date, the publication will be

• reconfirmed,
• withdrawn,
• replaced by a revised edition, or

• amended.
60904-4 © IEC:2009 – 5 –
PHOTOVOLTAIC DEVICES –
Part 4: Reference solar devices –

Procedures for establishing calibration traceability

1 Scope and object
This part of IEC 60904 sets the requirements for calibration procedures intended to establish
the traceability of photovoltaic reference solar devices to SI units as required by IEC 60904-2.
This standard applies to photovoltaic (PV) reference solar devices that are used to measure
the irradiance of natural or simulated sunlight for the purpose of quantifying the performance
of PV devices. The use of a PV reference solar device is required in the application of
IEC 60904-1 and IEC 60904-3.
This standard has been written with single junction PV reference solar devices in mind, in
particular crystalline Silicon. However, the main part of the standard is sufficiently general to
include other technologies. The methods described in Annex A, however, are limited to single
junction technologies.
2 Normative references
The following referenced documents are indispensable for the application of this document.
For dated references, only the edition cited applies. For undated references, the latest edition
of the referenced document (including any amendments) applies.
IEC 60904-2, Photovoltaic devices – Part 2: Requirements for reference solar devices
ISO/IEC 17025, General requirements for the competence of testing and calibration
laboratories
ISO 9059, Solar energy – Calibration of field pyrheliometers by comparison to a reference
pyrheliometer
ISO 9846, Solar energy – Calibration of a pyranometer using a pyrheliometer

ISO/IEC Guide 98-3: 2008, Uncertainty of measurement – Part 3: Guide to the expression of
uncertainty in measurement (GUM: 1995)
3 Terms and definitions
For the purposes of this document, the following ter
...