CISPR 16-1-4:2003/COR1:2005

Corrigendum 1 - Specification for radio disturbance and immunity measuring apparatus and methods - Part 1-4: Radio disturbance and immunity measuring apparatus - Ancillary equipment - Radiated disturbances

Corrigendum 1 - Spécifications des méthodes et des appareils de mesure des perturbations radioélectriques et de l'immunité aux perturbations radioélectriques - Partie 1-4: Appareils de mesure des perturbations radioélectriques et de l'immunité aux perturbations radioélectriques - Matériels auxiliaires - Perturbations rayonnées

General Information

• Status: Published
• Publication Date: 06-Feb-2005
• ICS: 33.100.10 - Emission
• ICS: 33.100.20 - Immunity
• Technical Committee: CIS/A - Radio-interference measurements and statistical methods
• Current Stage: DELPUB - Deleted Publication
• Completion Date: 20-Feb-2007

Relations

• Corrects: CISPR 16-1-4:2003 - Specification for radio disturbance and immunity measuring apparatus and methods - Part 1-4: Radio disturbance and immunity measuring apparatus - Ancillary equipment - Radiated disturbances
• Effective Date: 05-Sep-2023
• Revised: CISPR 16-1-4:2007 - Specification for radio disturbance and immunity measuring apparatus and methods - Part 1-4: Radio disturbance and immunity measuring apparatus - Ancillary equipment - Radiated disturbances
• Effective Date: 05-Sep-2023

Standards Content (Sample)

CISPR 16-1-4
(First edition – 2003)
Specification for radio disturbance and immunity measuring apparatus and methods –

Part 1-4: Radio disturbance and immunity measuring apparatus –

Ancillary equipment – Radiated disturbances

CORRIGENDUM 1
Page 93
Replace the third paragraph of Clause C.4 as follows:
In each of the eight positions, the validation factor [expressed in dB(Ω) = 20 log(V /I )] of the
go l
open circuit voltage of the RF generator (V ) and the measured current (I ) shall not deviate
go l
more than ±2 dB from the validation factor given in Figure C.8.
Page 95
Replace the existing Figure C.8 by the following new Figure C.8:

2 4 6 8 1 2 4 6 8 1 2 4 6 8 1 2
30 MHz
9 kHz
Frequency
IEC  081/05
Figure C.8 – Validation factor for a large loop-antenna of 2 m diameter
Page 101
Item c)
Replace the second paragraph by the following new text:
, the value of the
Then the validation factor is found by subtracting, at each frequency, S
relative sensitivity as given in Figure C.11, from the validation factor as given in Figure C.8.
Hence, if the measuring frequency is 100 kHz, the validation factor for the LLA with D = 3 m
equals (73,5 – (–7,5)) = 81 dB(Ω).
February 2005
Validation factor  dB(Ω)
CISPR 16-1-4
(Première édition – 2003)
Spécifications des méthodes et des appareils
...