ISO 3272-3:2001
(Main)Microfilming of technical drawings and other drawing office documents — Part 3: Aperture card for 35 mm microfilm
Microfilming of technical drawings and other drawing office documents — Part 3: Aperture card for 35 mm microfilm
This part of ISO 3272 specifies the technical characteristics of tab size aperture cards, data processing type, in which the aperture does or does not contain raw microfilm. It covers tape-type and jacket-type aperture cards, including camera cards. This part of ISO 3272 does not apply to A6 aperture cards.
Microfilmage des dessins techniques et autres documents de bureau d'études — Partie 3: Cartes à fenêtre pour microfilms de 35 mm
General Information
Relations
Standards Content (Sample)
INTERNATIONAL ISO
STANDARD 3272-3
Second edition
2001-11-15
Microfilming of technical drawings and
other drawing office documents —
Part 3:
Aperture card for 35 mm microfilm
Microfilmage des dessins techniques et autres documents de bureau
d'études —
Partie 3: Cartes à fenêtre pour microfilms de 35 mm
Reference number
ISO 3272-3:2001(E)
©
ISO 2001
---------------------- Page: 1 ----------------------
ISO 3272-3:2001(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not
be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this
file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this
area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters
were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event
that a problem relating to it is found, please inform the Central Secretariat at the address given below.
© ISO 2001
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic
or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body
in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.ch
Web www.iso.ch
Printed in Switzerland
ii © ISO 2001 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 3272-3:2001(E)
Contents Page
Foreword.iv
Introduction.v
1 Scope .1
2 Normative references.1
3 Terms and definitions .1
4 Physical characteristics of the aperture card.2
4.1 Material .2
4.2 Aperture characteristics .2
4.3 Tape-type cards .2
4.4 Jacket-type cards .4
Annex A (informative) Aperture cards, corner and colours.5
A.1 Corner shape and corner cut .5
A.2 Colour .5
A.3 Colour stripes .5
Bibliography.6
© ISO 2001 – All rights reserved iii
---------------------- Page: 3 ----------------------
ISO 3272-3:2001(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO
member bodies). The work of preparing International Standards is normally carried out through ISO technical
committees. Each member body interested in a subject for which a technical committee has been established has
the right to be represented on that committee. International organizations, governmental
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.