ISO/FDIS 22369-3

Equipment for crop protection — Method for measurement of potential drift from horizontal boom sprayer systems by the use of a test bench — Part 3:

Matériel de protection des cultures — Classification de la dérive des matériels de pulvérisation — Partie 3:

General Information

• Status: Withdrawn
• ICS: 65.060.40 - Plant care equipment
• Technical Committee: ISO/TC 23/SC 6 - Equipment for crop protection
• Drafting Committee: ISO/TC 23/SC 6 - Equipment for crop protection
• Current Stage: 5098 - Project deleted
• Completion Date: 28-Apr-2014

Relations

• Replaced By: ISO 22401:2015 - Equipment for crop protection — Method for measurement of potential spray drift from horizontal boom sprayers by the use of a test bench
• Effective Date: 10-May-2014

Standards Content (Sample)

DRAFT INTERNATIONAL STANDARD
ISO/DIS 22401
ISO/TC 23/SC 6 Secretariat: AFNOR
Voting begins on: Voting terminates on:
2014-04-30 2014-06-30
Equipment for crop protection — Method for measurement
of potential drift from horizontal boom sprayer systems by
the use of a test bench
Matériel de protection des cultures — Classification de la dérive des matériels de pulvérisation
ICS: 65.060.40
THIS DOCUMENT IS A DRAFT CIRCULATED
FOR COMMENT AND APPROVAL. IT IS
THEREFORE SUBJECT TO CHANGE AND MAY
NOT BE REFERRED TO AS AN INTERNATIONAL
STANDARD UNTIL PUBLISHED AS SUCH.
IN ADDITION TO THEIR EVALUATION AS
BEING ACCEPTABLE FOR INDUSTRIAL,
TECHNOLOGICAL, COMMERCIAL AND
USER PURPOSES, DRAFT INTERNATIONAL
STANDARDS MAY ON OCCASION HAVE TO
BE CONSIDERED IN THE LIGHT OF THEIR
POTENTIAL TO BECOME STANDARDS TO
WHICH REFERENCE MAY BE MADE IN
Reference number
NATIONAL REGULATIONS.
ISO/DIS 22401:2014(E)
RECIPIENTS OF THIS DRAFT ARE INVITED
TO SUBMIT, WITH THEIR COMMENTS,
NOTIFICATION OF ANY RELEVANT PATENT
RIGHTS OF WHICH THEY ARE AWARE AND TO
©
PROVIDE SUPPORTING DOCUMENTATION. ISO 2014

---------------------- Page: 1 ----------------------
ISO/DIS 22401:2014(E)

Copyright notice
This ISO document is a Draft International Standard and is copyright-protected by ISO. Except as
permitted under the applicable laws of the user’s country, neither this ISO draft nor any extract
from it may be reproduced, stored in a retrieval system or transmitted in any form or by any means,
electronic, photocopying, recording or otherwise, without prior written permission being secured.
Requests for permission to reproduce should be addressed to either ISO at the address below or ISO’s
member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail [e-mail]
Web www.iso.org
Reproduction may be subject to royalty payments or a licensing agreement.
Violators may be prosecuted.
ii © ISO 2014 – All rights reserved

---------------------- Page: 2 ----------------------
ISO/DIS 22401
Contents Page
Foreword . iv
Introduction . v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Principles. 2
5 Test materials and equipment . 2
5.1 Test liquid . 2
5.2 Test bench to assess potential spray drift . 2
6 Test conditions . 3
6.1 Environmental conditions . 3
6.2 Test bench positioning . 4
6.3 Forward speed . 4
6.4 Vehicle travel track . 4
7 Test procedure . 4
7.1 Method . 4
7.2 Results . 5
7.3 Test validation . 6
8 Comparison .
...

FINAL
INTERNATIONAL ISO/FDIS
DRAFT
STANDARD 22369-3
ISO/TC 23/SC 6
Crop protection equipment — Drift
Secretariat: AFNOR
classification of spraying equipment —
Voting begins on:
2012-03-15
Part 3:
Voting terminates on:
Potential spray drift measurement for field
2012-05-15
crop sprayers by the use of a test bench
Matériel de protection des cultures — Classification de la dérive des
matériels de pulvérisation —
Partie 3: Mesurage de la dérive potentielle de pulvérisation des
pulvérisateurs à rampes par banc d’essai
RECIPIENTS OF THIS DRAFT ARE INVITED TO
SUBMIT, WITH THEIR COMMENTS, NOTIFICATION
OF ANY RELEVANT PATENT RIGHTS OF WHICH
THEY ARE AWARE AND TO PROVIDE SUPPOR-
TING DOCUMENTATION.
IN ADDITION TO THEIR EVALUATION AS
Reference number
BEING ACCEPTABLE FOR INDUSTRIAL, TECHNO-
ISO/FDIS 22369-3:2012(E)
LOGICAL, COMMERCIAL AND USER PURPOSES,
DRAFT INTERNATIONAL STANDARDS MAY ON
OCCASION HAVE TO BE CONSIDERED IN THE
LIGHT OF THEIR POTENTIAL TO BECOME STAN-
DARDS TO WHICH REFERENCE MAY BE MADE IN
©
NATIONAL REGULATIONS. ISO 2012

---------------------- Page: 1 ----------------------
ISO/FDIS 22369-3:2012(E)
Copyright notice
This ISO document is a Draft International Standard and is copyright-protected by ISO. Except as permitted
under the applicable laws of the user’s country, neither this ISO draft nor any extract from it may be reproduced,
stored in a retrieval system or transmitted in any form or by any means, electronic, photocopying, recording
or otherwise, without prior written permission being secured.
Requests for permission to reproduce should be addressed to either ISO at the address below or ISO’s
member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail [e-mail]
Web www.iso.org
Reproduction may be subject to royalty payments or a licensing agreement.
Violators may be prosecuted.
ii © ISO 2012 – All rights reserved

---------------------- Page: 2 ----------------------
ISO/FDIS 22369-3:2012(E)
Contents Page
Foreword .iv
Introduction . v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Principles . 2
5 Test materials and equipment . 2
5.1 Test liquid . 2
5.2 Test bench to assess potential drift . 2
6 Test conditions . 3
6.1 Environmental conditions . 3
6.2 Test bench positioning . 3
6.3 Forward speed . 3
6.4 Vehicle travel track . 4
7 Test procedure . 4
7.1 Method . 4
7.2 Results . 4
7.3 Test validatio
...

PROJET
NORME ISO/FDIS
FINAL
INTERNATIONALE 22369-3
ISO/TC 23/SC 6
Matériel de protection des cultures —
Secrétariat: AFNOR
Classification de la dérive des matériels
Début de vote:
de pulvérisation —
2012-03-15
Vote clos le:
Partie 3:
2012-05-15
Mesurage de la dérive potentielle de
pulvérisation des pulvérisateurs à
rampes par banc d’essai
Crop protection equipment — Drift classification of spraying equipment —
Part 3: Potential spray drift measurement for field crop sprayers by the
use of a test bench
LES DESTINATAIRES DU PRÉSENT PROJET SONT
INVITÉS À PRÉSENTER, AVEC LEURS OBSER-
VATIONS, NOTIFICATION DES DROITS DE PRO-
PRIÉTÉ DONT ILS AURAIENT ÉVENTUELLEMENT
CONNAISSANCE ET À FOURNIR UNE DOCUMEN-
TATION EXPLICATIVE.
OUTRE LE FAIT D’ÊTRE EXAMINÉS POUR
ÉTABLIR S’ILS SONT ACCEPTABLES À DES FINS
INDUSTRIELLES, TECHNOLOGIQUES ET COM-
Numéro de référence
MERCIALES, AINSI QUE DU POINT DE VUE DES
ISO/FDIS 22369-3:2012(F)
UTILISATEURS, LES PROJETS DE NORMES
INTERNATIONALES DOIVENT PARFOIS ÊTRE
CONSIDÉRÉS DU POINT DE VUE DE LEUR POSSI-
BILITÉ DE DEVENIR DES NORMES POUVANT
SERVIR DE RÉFÉRENCE DANS LA RÉGLEMENTA-
©
TION NATIONALE. ISO 2012

---------------------- Page: 1 ----------------------
ISO/FDIS 22369-3:2012(F)
Notice de droit d’auteur
Ce document de l’ISO est un projet de Norme internationale qui est protégé par les droits d’auteur de l’ISO.
Sauf autorisé par les lois en matière de droits d’auteur du pays utilisateur, aucune partie de ce projet ISO
ne peut être reproduite, enregistrée dans un système d’extraction ou transmise sous quelque forme que
ce soit et par aucun procédé, électronique ou mécanique, y compris la photocopie, les enregistrements ou
autres, sans autorisation écrite préalable.
Les demandes d’autorisation de reproduction doivent être envoyées à l’ISO à l’adresse ci-après ou au
comité membre de l’ISO dans le pays du demandeur.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail [e-mail]
Web www.iso.org
Toute reproduction est soumise au paiement de droits ou à un contrat de licence.
Les contrevenants pourront être poursuivis.
ii © ISO 2012 – Tous droits réservés

---------------------- Page: 2 ----------------------
ISO/FDIS 22369-3:2012(F)
Sommaire Page
Avant-propos .iv
Introduction . v
1 Domaine d’application . 1
2 Références normatives . 1
3 Termes et définitions . 2
4 Principes . 2
5 Matériaux et équipement d’essai . 2
5.1 Bouillie d’essai . 2
5.2 Banc d’essai pour évaluer la dérive potentielle . 2
6 Conditions d’essai . 3
6.1 Conditions environnementales . 3
6.2 Position du banc d’essai . 3
6.3 Vitesse de déplacement . 4
6.4 Voie de roulement du véhicule . 4
7 Mode opératoire d’essai . 4
7.1 Méthode . 4
7.2 Résultats .
...