SIST EN 543:2003
(Main)Adhesives - Determination of apparent density of powder and granule adhesives
Adhesives - Determination of apparent density of powder and granule adhesives
This European Standard defines a method for the determination of apparent density of powder and granule adhesives.
The method is applicable to all powder and granule adhesives.
Klebstoffe - Bestimmung der Schüttdichte von Pulver- und Granulat-Klebstoffen
Adhésifs - Détermination de la masse volumique apparente des adhésifs en poudre et en granules
La présente Norme européenne définit une méthode de détermination de la masse volumique apparente des adhésifs en poudre et en granulés.
Elle est applicable a tous les adhésifs en poudre et en granulés.
Lepila - Določanje nasipne gostote lepil v prahu in granulah
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN 543:2003
01-julij-2003
1DGRPHãþD
SIST EN 543:1998
/HSLOD'RORþDQMHQDVLSQHJRVWRWHOHSLOYSUDKXLQJUDQXODK
Adhesives - Determination of apparent density of powder and granule adhesives
Klebstoffe - Bestimmung der Schüttdichte von Pulver- und Granulat-Klebstoffen
Adhésifs - Détermination de la masse volumique apparente des adhésifs en poudre et en
granules
Ta slovenski standard je istoveten z: EN 543:2003
ICS:
83.180 Lepila Adhesives
SIST EN 543:2003 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 543:2003
---------------------- Page: 2 ----------------------
SIST EN 543:2003
EUROPEAN STANDARD
EN 543
NORME EUROPÉENNE
EUROPÄISCHE NORM
April 2003
ICS 83.180 Supersedes EN 543:1994
English version
Adhesives - Determination of apparent density of powder and
granule adhesives
Adhésifs - Détermination de la masse volumique apparente Klebstoffe - Bestimmung der Schüttdichte von Pulver- und
des adhésifs en poudre et en granules Granulat-Klebstoffen
This European Standard was approved by CEN on 20 February 2003.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the Management Centre or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the Management Centre has the same status as the official
versions.
CEN members are the national standards bodies of Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece,
Hungary, Iceland, Ireland, Italy, Luxembourg, Malta, Netherlands, Norway, Portugal, Slovakia, Spain, Sweden, Switzerland and United
Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36 B-1050 Brussels
© 2003 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 543:2003 E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST EN 543:2003
EN 543:2003 (E)
Contents
page
Foreword.3
1 Scope .4
2 Normative references .4
3 Terms and definitions.4
4 Principle.4
5 Safety .4
6 Apparatus .4
7 Sampling.5
8 Procedure .5
9 Expression of results .6
10 Test report .6
2
---------------------- Page: 4 ----------------------
SIST EN 543:2003
EN 543:2003 (E)
Foreword
This document (EN 543:2003) has been prepared by Technical Committee CEN/TC 193 "Adhesives", the
secretariat of which is held by AENOR.
This European Standard shall be given the status of a national stand
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.