Surface active agents - Detergents - Determination of cationic-active matter content - Part 1: High-molecular-mass cationic-active matter (ISO 2871-1:2010)

This part of ISO 2871 specifies a method for the determination of high-molecular-mass cationic-active materials such as
a) quaternary ammonium compounds in which two of the alkyl groups each contain 10 or more carbon atoms, e.g. distearyl-dimethyl-ammonium chlorides, or
b) salts of imidazoline or 3-methylimidazoline in which long-chain acylaminoethyl and alkyl groups are substituted in the 1- and 2-positions, respectively. The method is applicable to solids or to aqueous solutions of the active material when the relative molecular mass of the cationic-active matter is known or when it has been previously determined if its content is expressed as a percentage by mass. The method is not applicable if anionic surface active agents are present.

Tenside - Waschmittel - Bestimmung des Gehaltes der kationaktiven Substanz - Teil 1: Hochmolekulare kationaktive Substanz (ISO 2871-1:2010)

Dieser Teil von ISO 2871 legt ein Verfahren fest zur Bestimmung hochmolekularer kationaktiver Substanz, wie z. B.
a)   von quarternären Ammoniumverbindungen, in denen zwei der Alkylgruppen jeweils 10 oder mehr Kohlen¬stoffatome enthalten, beispielsweise von Distearyldimethylammoniumchlorid, oder
b)   von Salzen des Imidazolins oder des 3 Methylimidazolins, in denen langkettige Acylaminoethyl  und Alkyl Gruppen in der 1  oder 2 Stellung substituiert sind.
Das Verfahren gilt für Feststoffe oder wässrige Lösungen der Aktivsubstanz, wenn die relative Molmasse der kationaktiven Substanz bekannt ist oder vorher bestimmt wurde, falls ihr Gehalt als Massenanteil in Prozent angegeben wird.
Das Verfahren gilt nicht, wenn anionische Tenside vorliegen.

Agents de surface - Détergents - Détermination de la teneur en matière active cationique - Partie 1: Matière active cationique à haute masse moléculaire (ISO 2871-1:2010)

L'ISO 2871-1:2010 spécifie une méthode de détermination des matières actives cationiques à haute masse moléculaire telles que les composés d'ammonium quartenaire dans lesquels deux des groupes alkyl contiennent chacun 10 atomes de carbone ou plus, les chlorures de distéaryl-diméthyl-ammonium par exemple, ou les sels d'imidazoline ou méthyl-3-imidazoline dans lesquels les groupes acylaminoéthyl et les groupes alkyl à longues chaînes sont respectivement substitués en positions 1 et 2.
La méthode s'applique à la matière active à l'état solide ou en solution aqueuse. La méthode ne s'applique pas si des agents de surface anioniques sont présents.

Površinsko aktivne snovi - Detergenti - Določevanje kationsko aktivnih snovi - 1. del: Kationsko aktivne snovi z veliko molekulsko maso (ISO 2871-1:2010)

Ta del ISO 2871 določa metodo za določevanje kationsko aktivnih materialov z veliko molekulsko maso kot so
a) kvartarne amonijeve sestavine, v katerih dve od alkilnih skupin vsaka vsebuje 19 ali več atomov ogljika, npr. distearilni dimetilni amonijevi kloridi, ali
b) soli imidazolina ali 3-metilimidazolina v katerem so dolge verige akilaminoetila in alkilnih skupin zamenjane z 1- in 2-pozicijo v tem vrstnem redu.  Metoda velja za trdne snovi ali za vodne raztopine aktivnega materiala, kadar je relativna molekulska masa kationsko aktivne snovi znana ali kadar je bila prej dognana, če je njegova sestava izražena kot odstotek mase. Metoda ne velja, če so prisotni anionski površinski aktivni agenti.

General Information

Status
Published
Public Enquiry End Date
19-Dec-2009
Publication Date
18-Aug-2010
Current Stage
6060 - National Implementation/Publication (Adopted Project)
Start Date
06-Aug-2010
Due Date
11-Oct-2010
Completion Date
19-Aug-2010

Relations

Buy Standard

Standard
EN ISO 2871-1:2010
English language
10 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN ISO 2871-1:2010
01-september-2010
1DGRPHãþD
SIST EN ISO 2871-1:1997
3RYUãLQVNRDNWLYQHVQRYL'HWHUJHQWL'RORþHYDQMHNDWLRQVNRDNWLYQLKVQRYL
GHO.DWLRQVNRDNWLYQHVQRYL]YHOLNRPROHNXOVNRPDVR ,62
Surface active agents - Detergents - Determination of cationic-active matter content -
Part 1: High-molecular-mass cationic-active matter (ISO 2871-1:2010)
Tenside - Waschmittel - Bestimmung des Gehaltes der kationaktiven Substanz - Teil 1:
Hochmolekulare kationaktive Substanz (ISO 2871-1:2010)
Agents de surface - Détergents - Détermination de la teneur en matière active cationique
- Partie 1: Matière active cationique à haute masse moléculaire (ISO 2871-1:2010)
Ta slovenski standard je istoveten z: EN ISO 2871-1:2010
ICS:
71.100.40 Površinsko aktivna sredstva Surface active agents
SIST EN ISO 2871-1:2010 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN ISO 2871-1:2010

---------------------- Page: 2 ----------------------

SIST EN ISO 2871-1:2010


EUROPEAN STANDARD
EN ISO 2871-1

NORME EUROPÉENNE

EUROPÄISCHE NORM
February 2010
ICS 71.100.40 Supersedes EN ISO 2871-1:1994
English Version
Surface active agents - Detergents - Determination of cationic-
active matter content - Part 1: High-molecular-mass cationic-
active matter (ISO 2871-1:2010)
Agents de surface - Détergents - Détermination de la Tenside - Waschmittel - Bestimmung des Gehaltes der
teneur en matière active cationique - Partie 1: Matière kationaktiven Substanz - Teil 1: Hochmolekulare
active cationique à haute masse moléculaire (ISO 2871- kationaktive Substanz (ISO 2871-1:2010)
1:2010)
This European Standard was approved by CEN on 11 February 2010.

CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the CEN Management Centre or to any CEN member.

This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as the
official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.






EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2010 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 2871-1:2010: E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------

SIST EN ISO 2871-1:2010
EN ISO 2871-1:2010 (E)
Contents Page
Foreword .3

2

---------------------- Page: 4 ----------------------

SIST EN ISO 2871-1:2010
EN ISO 2871-1:2010 (E)
Foreword
This document (EN ISO 2871-1:2010) has been prepared by Technical Committee ISO/TC 91 "Surface active
agents" in collaboration with Technical Committee CEN/TC 276 “Surface active agents” the secretariat of
which is held by AFNOR.
This European Standard shall be given the status of a national standard, either by publication of an identical
text or by endorsement, at the latest by August 2010, and conflicting national standards shall be withdrawn at
the latest by August 2010.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. CEN [and/or CENELEC] shall not be held responsible for identifying any or all such patent rights.
This document supersedes EN ISO 2871-1:1994.
According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following
countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech
Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia,
Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain,
Sweden, Switzerland and the United Kingdom.
Endorsement notice
The text of ISO 2871-1:2010 has been approved by CEN as a EN ISO 2871-1:2010 without any modification.

3

---------------------- Page: 5 ----------------------

SIST EN ISO 2871-1:2010

---------------------- Page: 6 ----------------------

SIST EN ISO 2871-1:2010

INTERNATIONAL ISO
STANDARD 2871-1
Second edition
2010-02-15


Surface active agents — Detergents —
Determination of cationic-active matter
content —
Part 1:
High-molecular-mass cationic-active
matter
Agents de surface — Détergents — Détermination de la teneur en
matière active cationique —
Partie 1: Matière active cationique à haute masse moléculaire




Reference number
ISO 2871-1:2010(E)
©
ISO 2010

---------------------- Page: 7 ----------------------

SIST EN ISO 2871-1:2010
ISO 2871-1:2010(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but
shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In
the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.


COPYRIGHT PROTECTED DOCUMENT


©  ISO 2010
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland

ii © ISO 2010 – All rights reserved

---------------------- Page: 8 ----------------------

SIST EN ISO 2871-1:2010
ISO 2871-1:2010(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies
(ISO member bodies). The work of preparing International Standards is normally carried out through ISO
technical committees. Each member body interested in a subject for which a technical committee has been
established has the right to be represented on that committee. International organizations, governmental and
non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the
International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
The main task of technical committees is to prepare Inter
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.