SIST EN 12963:2002
(Main)Adhesives - Determination of free monomer content in adhesives based on synthetic polymers
Adhesives - Determination of free monomer content in adhesives based on synthetic polymers
This European Standard specifies a simple test method for the gas-chromatographic determination of free monomer content in polymeric adhesives after specific treatment.
This test method can be used for the determination of acrylic, styrene, vinyl and other unsaturated monomers.
NOTE This method could also be used for the determination of other monomers, if applicable.
Klebstoffe - Bestimmung des freien Monomeranteils in Klebstoffen auf der Basis synthetischer Polymere
Anwendungsbereich
Diese Europäische Norm legt ein einfaches gaschromatographisches Prüfverfahren zur Bestimmung
des freien Monomeranteils in polymeren Klebstoffen nach einer besonderen Behandlung fest.
Dieses Prüfverfahren kann verwendet werden für die Bestimmung von Acryl-, Styrol-, Vinyl- und anderen
ungesättigten Monomeren.
ANMERKUNG Dieses Verfahren könnte auch, falls zutreffend, für die Bestimmung von anderen Monomeren
angewendet werden.
Adhésifs - Détermination de la teneur en monomeres libres dans des adhésifs a base de polymeres synthétiques
1 Domaine d'application
La présente norme européenne spécifie une méthode simple permettant de déterminer par chromatographie en phase gazeuse, apres un traitement spécifique, la teneur en monomeres libres d'adhésifs a base de polymeres.
La présente norme peut etre utilisée pour la détermination de monomeres acryliques, styrene, vinyliques et d'autres monomeres non saturés.
NOTE Cette méthode peut également etre utilisée avec d'autres monomeres, le cas échéant.
Lepila - Določevanje prostega monomera v lepilih na osnovi sintetičnih polimerov
General Information
Standards Content (Sample)
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Klebstoffe - Bestimmung des freien Monomeranteils in Klebstoffen auf der Basis synthetischer PolymereAdhésifs - Détermination de la teneur en monomeres libres dans des adhésifs a base de polymeres synthétiquesAdhesives - Determination of free monomer content in adhesives based on synthetic polymers83.180LepilaAdhesivesICS:Ta slovenski standard je istoveten z:EN 12963:2001SIST EN 12963:2002en01-februar-2002SIST EN 12963:2002SLOVENSKI
STANDARD
SIST EN 12963:2002
EUROPEAN STANDARDNORME EUROPÉENNEEUROPÄISCHE NORMEN 12963April 2001ICS 83.180English versionAdhesives - Determination of free monomer content inadhesives based on synthetic polymersAdhésifs - Détermination de la teneur en monomères libresdans des adhésifs à base de polymères synthétiquesKlebstoffe - Bestimmung des freien Monomeranteils inKlebstoffen auf der Basis synthetischer PolymereThis European Standard was approved by CEN on 1 March 2001.CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this EuropeanStandard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such nationalstandards may be obtained on application to the Management Centre or to any CEN member.This European Standard exists in three official versions (English, French, German). A version in any other language made by translationunder the responsibility of a CEN member into its own language and notified to the Management Centre has the same status as the officialversions.CEN members are the national standards bodies of Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece,Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and United Kingdom.EUROPEAN COMMITTEE FOR STANDARDIZATIONCOMITÉ EUROPÉEN DE NORMALISATIONEUROPÄISCHES KOMITEE FÜR NORMUNGManagement Centre: rue de Stassart, 36
B-1050 Brussels© 2001 CENAll rights of exploitation in any form and by any means reservedworldwide for CEN national Members.Ref. No. EN 12963:2001 ESIST EN 12963:2002
Page 2EN 12963:2001ContentsPageForeword.31Scope.42Normative references.43Terms and definitions.44Principle.45Safety.46Chemicals.47Apparatus.58Sampling and sample preparation.59Chromatographic conditions.510Calibration of the gas chromatograph.611Procedure.612Expression of results.713Test report.7SIST EN 12963:2002
Page 3EN 12963:2001ForewordThis European Standard has been prepared by Technical Committee CEN/TC 193 "Adhesives", the secretariat ofwhich is held by AENOR.This European Standard shall be given the status of a national standard, either by publication of an identical text orby endorsement, at the latest by October 2001, and conflicting national standards shall be withdrawn at the latestby October 2001.According to the CEN/CENELEC Internal Regulations, the national standards organizations of the followingcountries are bound to implement this European Standard: Austria, Belgium, Czech Republic, Denmark, Finland,France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden,Switzerland and the United Kingdom.SIST EN 12963:2002
Page 4EN 12963:20011 ScopeThis European Standard specifies a simple test method for the gas-chromatographic determination of freemonomer content in polymeric adhesives after specific treatment.This test method can be used for the determination of acrylic, styrene, vinyl and other unsaturated monomers.NOTE
This method could also be used for the determination of other monomers, if applicable.2 Normative referencesThis European Standard incorporates by dated or undated reference, provisions from other publications. Thesenormative references are cited at the appropriate places in the text and the publications are listed hereafter. Fordated references, subsequent amendments to or revisions of any of these publications apply to this EuropeanStandard only when incorporated in it by amendment or revision. For undated references the latest edition of thepublication referred to applies (including amendments).EN 923Adhesives — Terms and definitionsEN 1066Adhesives —
SamplingEN 1067Ad
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.