SIST HD 349 S1:2004

Preferred diameters of wire terminations of capacitors and resistors

Presents preferred diameters in tabular form in the metric and inch-pound unit sizes.

Vorzugswerte der Durchmesser von Anschlußdrähten für Kondensatoren und Widerstände

Valeurs préférentielles des diamètres des fils de sorties des condensateurs et résistances

Présente les diamètres préférentiels sous formes de tableaux, en millimètres et en inches.

Preferred diameters of wire terminations of capacitors and resistors

General Information

• Status: Withdrawn
• Publication Date: 30-Jun-2004
• Withdrawal Date: 22-Jul-2018
• ICS: 31.040.01 - Resistors in general
• ICS: 31.060.01 - Capacitors in general
• Technical Committee: SS EIT - Technical Board for the electrotechnical, information technology and telecommunications fields
• Current Stage: 9900 - Withdrawal (Adopted Project)
• Start Date: 23-Jul-2018
• Due Date: 15-Aug-2018
• Completion Date: 23-Jul-2018
• Ref Project: HD 349 S1:1977 - Preferred diameters of wire terminations of capacitors and resistors

Relations

• Replaced By: SIST EN 60301:2012 - Preferred diameters of wire terminations of capacitors and resistors
• Effective Date: 20-Sep-2011
• Replaced By: SIST EN 60301:2012 - Preferred diameters of wire terminations of capacitors and resistors
• Effective Date: 29-Jan-2023

Standards Content (Sample)

SLOVENSKI SIST HD 349 S1:2004

STANDARD
julij 2004
Preferred diameters of wire terminations of capacitors and resistors
ICS 31.040.01; 31.060.01 Referenčna številka
SIST HD 349 S1:2004(en)
©  Standard je založil in izdal Slovenski inštitut za standardizacijo. Razmnoževanje ali kopiranje celote ali delov tega dokumenta ni dovoljeno

---------------------- Page: 1 ----------------------

NORME
CEI
INTERNATIONALE
IEC
60301
INTERNATIONAL
Deuxième édition
STAN
DARD
Second edition
1971-01
Valeurs préférentielles des diamètres des fils
de sorties des condensateurs et résistances
Preferred diameters of wire terminations
of capacitors and resistors
© IEC 1971 Droits de reproduction
réservés — Copyright - all rights reserved
Aucune partie de cette publication ne peut être reproduite ni No part of this publication may be reproduced or utilized in
utilisée sous quelque forme que ce soit et par aucun any form or by any means, electronic or mechanical,
procédé, électronique ou mécanique, y compris la photo- including photocopying and microfilm, without permission in
copie et les microfilms, sans l'accord écrit de l'éditeur. writing from the publisher.
International Electrotechnical Commission 3, rue de Varembé Geneva, Switzerland
Telefax: [phone] e-mail: [e-mail] IEC web site http: //www.iec.ch
CODE PRIX
Commission Electrotechnique Internationale
C
PRICE CODE
International Electrotechnical Commission
IEC
MensayHapo HaR 3IleKTpOTexHH4ecRaR HOMNCCHR
Pour prix, voir catalogue en vigueur
• • For price, see current catalogue

---------------------- Page: 2 ----------------------

- 3 -
INTERNATIONAL ELECTROTECHNICAL COMMISSION
PREFERRED DIAMETERS OF WIRE TERMINATIONS OF CAPACITORS
AND RESISTORS
FOREWORD
1)
The formal decisions or agreements of the I E C on technical matters, prepared by Technical Committees on which all the
National Committees having a special interest therein are represented, express, as nearly as possible, an international
consensus of opinion on the subjects dealt with.
2) They have the form of recommendations for international use and they are accepted by the National Committees in that
sense.
3) In order to promote this international unification, the I E C expresses the wish that all National Committees having as
yet no national rules, when preparing such rules, should use the 1 E C recommendations as the fundamental basis for these
rules in so far as national conditions will permit.
4) The desirability is recognized of extending international agreement on these matters through an endeavour to harmonize
national standardization rules with these recommendations in so far as national conditions will permit. The National
Committees pledge their influence towards that end.
PREFACE
This Recommendation has been prepared by IEC Technical Committee No. 40, Capacitors and Resistors for Electronic
Equipment.
A first draft of the first edition, prepared by the Secretariat, was discussed during the meetings held in Tokyo in 1965 and
in Hamburg in 1966. As a result of this latter meeting, a new draft was submitted to the National Committees for approval
under the Six Months' Rule in November 1966. The comments received were discussed at the meeting held in Prague in 1967.
Amendments were submitted to the National Committees for approval under the Two Months' Procedure in May 1968.
The following countries voted explicitly in favour of publication of the first edition :
Australia Japan
...