Light and lighting - Measurement and presentation of photometric data of lamps and luminaires - Part 3: Presentation of data for emergency lighting of workplaces

This document specifies the required data for lamps and luminaires for the verification of conformity to the requirements of EN 1838. This document does not define the data requirements for signage, as these can be found in EN 1838.
This document can be used in conjunction with EN 13032-1 and EN 13032-4.
This document specifies the requirements for emergency lighting with or without a replaceable light source. For luminaires with a non-replaceable light source data should always be given for the luminaire. For luminaires with a replaceable light source, light source data should be provided in addition to luminaire data.
NOTE    Product, safety and performance data can be found in CENELEC documents (see Bibliography).

Licht und Beleuchtung - Messung und Darstellung photometrischer Daten von Lampen und Leuchten - Teil 3: Darstellung von Daten für die Notbeleuchtung von Arbeitsstätten

Dieses Dokument legt die erforderlichen Daten von Lampen und Leuchten fest, die für eine Überprüfung der Übereinstimmung mit den Anforderungen nach EN 1838 benötigt werden. Dieses Dokument definiert nicht die notwendigen Angaben für die Kennzeichnung, da diese in EN 1838 enthalten sind.
Dieses Dokument wird in Verbindung mit EN 13032-1 und EN 13032-4 verwendet.
Dieses Dokument legt die Anforderungen für Notbeleuchtung mit oder ohne ersetzbare Lichtquelle fest. Bei Leuchten mit nicht ersetzbarer Lichtquelle sollten die Daten stets für die Leuchte angegeben werden. Bei Leuchten mit ersetzbaren Lichtquelle sollten zusätzlich zu den Leuchtendaten auch die Lichtquellendaten angegeben werden.
ANMERKUNG   Produkt-, Sicherheits- und Leistungsdaten sind in CENELEC Dokumenten zu finden (siehe Literaturhinweise).

Lumière et éclairage - Mesure et présentation des données photométriques des lampes et des luminaires - Partie 3 : Présentation des données relatives à l’éclairage de sécurité des lieux de travail

Le présent document spécifie les données requises pour les lampes et les luminaires en vue de la vérification de la conformité aux exigences de l’EN 1838. Il ne définit pas les exigences relatives aux données concernant la signalétique car elles sont indiquées dans l’EN 1838.
Le présent document est utilisé conjointement avec l'ISO 13032-1et l’ISO 13032-4.
Il spécifie les exigences pour un éclairage de secours comportant ou non une source de lumière remplaçable. Dans le cas de luminaires à source de lumière non remplaçable, il convient de toujours fournir des données relatives au luminaire. Dans le cas de luminaires à source de lumière remplaçable, il convient de fournir des données relatives à la source de lumière en plus de celles qui se rapportent au luminaire.
NOTE   Les données relatives au produit, à la sécurité et aux performances peuvent être consultées dans les documents du CENELEC (voir en Bibliographie).

Svetloba in razsvetljava - Merjenje in podajanje fotometričnih podatkov svetlobnih virov in svetilk - 3. del: Podajanje podatkov za zasilno razsvetljavo delovnega mesta

General Information

Status
Not Published
Current Stage
5060 - Closure of Vote - Formal Approval
Due Date
26-Aug-2021
Completion Date
26-Aug-2021

RELATIONS

Buy Standard

Draft
prEN 13032-3:2020
English language
11 pages
sale 10% off
Preview
sale 10% off
Preview

e-Library read for
1 day

Standards Content (sample)

SLOVENSKI STANDARD
oSIST prEN 13032-3:2020
01-september-2020

Svetloba in razsvetljava - Merjenje in podajanje fotometrijskih podatkov svetlobnih

virov in svetilk - 3. del: Podajanje podatkov za zasilno razsvetljavo delovnega
mesta

Light and lighting - Measurement and presentation of photometric data of lamps and

luminaires - Part 3: Presentation of data for emergency lighting of workplaces
Licht und Beleuchtung - Messung und Darstellung photometrischer Daten von Lampen

und Leuchten - Teil 3: Darstellung von Daten für die Notbeleuchtung von Arbeitsstätten

Lumière et éclairage - Mesure et présentation des données photométriques des lampes

et des luminaires - Partie 3 : Présentation des données relatives à l’éclairage de sécurité

des lieux de travail
Ta slovenski standard je istoveten z: prEN 13032-3
ICS:
17.180.20 Barve in merjenje svetlobe Colours and measurement of
light
91.160.10 Notranja razsvetljava Interior lighting
oSIST prEN 13032-3:2020 en,fr,de

2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------
oSIST prEN 13032-3:2020
---------------------- Page: 2 ----------------------
oSIST prEN 13032-3:2020
DRAFT
EUROPEAN STANDARD
prEN 13032-3
NORME EUROPÉENNE
EUROPÄISCHE NORM
July 2020
ICS 17.180.20; 91.160.10 Will supersede EN 13032-3:2007
English Version
Light and lighting - Measurement and presentation of
photometric data of lamps and luminaires - Part 3:
Presentation of data for emergency lighting of workplaces

Lumière et éclairage - Mesure et présentation des Licht und Beleuchtung - Messung und Darstellung

données photométriques des lampes et des luminaires photometrischer Daten von Lampen und Leuchten -

- Partie 3 : Présentation des données relatives à Teil 3: Darstellung von Daten für die Notbeleuchtung

l'éclairage de sécurité des lieux de travail von Arbeitsstätten

This draft European Standard is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee

CEN/TC 169.

If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations

which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.

This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other

language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC

Management Centre has the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,

Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,

Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and

United Kingdom.

Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are

aware and to provide supporting documentation.

Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without

notice and shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels

© 2020 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN 13032-3:2020 E

worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
oSIST prEN 13032-3:2020
prEN 13032-3:2020 (E)
Contents Page

European foreword ...................................................................................................................................................... 3

Introduction .................................................................................................................................................................... 4

5.1 Essential luminaire data............................................................................................................................... 7

5.1.1 Luminaire code ................................................................................................................................................ 7

5.1.2 Luminous intensity table ............................................................................................................................. 7

5.1.3 Luminaire maintenance factors (F ) ...................................................................................................... 8

5.1.4 Luminaire service correction factor (FLSC) ............................................................................................. 8

5.2 Useful luminaire data .................................................................................................................................... 9

5.2.1 Physical dimensions of the luminaire ..................................................................................................... 9

5.2.2 Intensity diagram ............................................................................................................................................ 9

5.2.3 Spacing tables ................................................................................................................................................... 9

Annex A (informative) Illuminance calculation on a horizontal plane from a point source ............ 10

Bibliography ................................................................................................................................................................. 11

---------------------- Page: 4 ----------------------
oSIST prEN 13032-3:2020
prEN 13032-3:2020 (E)
European foreword

This document (prEN 13032-3:2020) has been prepared by Technical Committee CEN/TC 169 “Light

and Lighting”, the secretariat of which is held by DIN.
This document is currently submitted to the CEN Enquiry.
This document will supersede EN 13032-2:2017.
---------------------- Page: 5 ----------------------
oSIST prEN 13032-3:2020
prEN 13032-3:2020 (E)
Introduction

Emergency lighting for work and other places is required by National Regulations in a number of

European countries and the lighting criteria is specified in EN 1838. To assist in the design of suitable

emergency lighting solutions photometric and other characteristics data are required for the selected

equipment. This document specifies the required data for emergency lighting as required by EN 1838.

---------------------- Page: 6 ----------------------
oSIST prEN 13032-3:2020
prEN 13032-3:2020 (E)
1 Scope

This document specifies the required data for lamps and luminaires for the verification of conformity to

the requirements of EN 1838. This document does not define the data requirements for signage, as

these can be found in EN 1838.
This document is used in conjunction with EN 13032-1 and EN 13032-4.

This document specifies the requirements for emergency lighting with or without a replaceable light

source. For luminaires with a non-replaceable light source data should always be given for the

luminaire. For luminaires with a replaceable light source, light source data should be provided in

addition to luminaire data.

NOTE Product, safety and performance data can be found in CENELEC documents (see Bibliography).

2 Normative references

The following documents are referred to in the text in such a way that some or all of their content

constitutes requirements of this document. For dated references, only the edition cited applies. For

undated references, the latest edition of the referenced document (including any amendments) applies.

EN 1838, Lighting applications — Emergency lighting

EN 12665, Light and lighting — Basic terms and criteria for specifying lighting requirements

EN 13032-1, Light and lighting — Measurement and presentation of photometric data of lamps and

luminaires — Part 1: Measurement and file format

EN 13032-4, Lighting applications — Measurement and presentation of photometric data of lamps and

luminaires — Part 4: LED lamps, modules and luminaires
3 Terms and definitions

For the purposes of this document, the terms and definitions given in EN 12665 and the following apply.

ISO and IEC maintain terminological databases for use in standardization at the following addresses:

— IEC Electropedia: available at http://www.electropedia.org/
— ISO Online browsing platform: available at https://www.iso.org/obp
3.1
correction factor

factor to modify the luminaire data as presented on a particular photometric data sheet to those of

similar luminaires
EXAMPLE Ballast Lumen Factor, length, lumen corrections.
3.2
essential data

lamp and luminaire data required for the verification of conformity to the requirements of EN 1838

3.3
lamp code
any combination of letters and numbers by which the lamp type is identified
---------------------- Page: 7 ----------------------
oSIST prEN 13032-3:2020
prEN 13032-3:2020 (E)
3.4
lamp dimensions
all dimensions of the lamp that are relevant for the lumin
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.