EN 565:2006
(Main)Mountaineering equipment - Tape - Safety requirements and test methods
Mountaineering equipment - Tape - Safety requirements and test methods
This European Standard specifies safety requirements and test methods for tape supplied on drums or in separate lengths, for use in mountaineering including climbing.
Bergsteigerausrüstung - Band - Sicherheitstechnische Anforderungen und Prüfverfahren
Diese Europäische Norm legt sicherheitstechnische Anforderungen und Prüfverfahren fest für Band, das auf
Trommeln oder in separaten Längen angeboten und beim Bergsteigen einschließlich Klettern verwendet wird.
Equipement d'alpinisme et d'escalade - Sangle - Exigences de sécurité et méthodes d'essai
La présente Norme européenne spécifie les exigences de sécurité et les méthodes d'essai relatives aux sangles fournies sur tambours ou en longueurs séparées, utilisées en alpinisme et en escalade.
Gorniška oprema - Trak - Varnostne zahteve in preskusne metode
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN 565:2007
01-marec-2007
1DGRPHãþD
SIST EN 565:1998
SIST EN 565:1998/AC:1998
Gorniška oprema - Trak - Varnostne zahteve in preskusne metode
Mountaineering equipment - Tape - Safety requirements and test methods
Bergsteigerausrüstung - Band - Sicherheitstechnische Anforderungen und Prüfverfahren
Equipement d'alpinisme et d'escalade - Sangle - Exigences de sécurité et méthodes
d'essai
Ta slovenski standard je istoveten z: EN 565:2006
ICS:
97.220.40 Oprema za športe na Outdoor and water sports
prostem in vodne športe equipment
SIST EN 565:2007 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
EUROPEAN STANDARD
EN 565
NORME EUROPÉENNE
EUROPÄISCHE NORM
December 2006
ICS 97.220.40 Supersedes EN 565:1997
English Version
Mountaineering equipment - Tape - Safety requirements and
test methods
Equipement d'alpinisme et d'escalade - Sangle - Exigences Bergsteigerausrüstung - Band - Sicherheitstechnische
de sécurité et méthodes d'essai Anforderungen und Prüfverfahren
This European Standard was approved by CEN on 25 October 2006.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the Central Secretariat or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the Central Secretariat has the same status as the official
versions.
CEN members are the national standards bodies of Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France,
Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania,
Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36 B-1050 Brussels
© 2006 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 565:2006: E
worldwide for CEN national Members.
---------------------- Page: 2 ----------------------
EN 565:2006 (E)
Contents Page
Foreword.3
Introduction .4
1 Scope.5
2 Normative references.5
3 Terms and definitions .5
4 Safety requirements.5
4.1 Stability.5
4.2 Tensile strength.5
4.3 Packaging.5
4.4 Mass per unit length.5
5 Test methods.6
5.1 Test samples.6
5.2 Conditioning.6
5.3 Stability.6
5.4 Determination of tensile strength .6
5.5 Determination of mass per unit length.
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.