EN 13763-6:2003

Explosives for civil uses - Detonators and relays - Part 6: Determination of resistance to cracking in low temperatures of leading wires

This European Standard specifies a method for determining the resistance to cracking at low temperatures of leading wire insulation of detonators. This method is only applicable to electric detonators with plastic covered leading wires.

Explosivstoffe für zivile Zwecke - Zünder und Verzögerungselemente - Teil 6: Bestimmung des Widerstandes der Isolation von Zünderdrähten gegen Rissbildung bei niedrigen Temperaturen

Explosifs à usage civil - Détonateurs et relais - Partie 6: Détermination de la résistance à la fissuration des fils d'amorces à basse température

La présente norme spécifie une méthode permettant de déterminer la résistance à la fissuration à basses températures de l'isolation des fils d'amorce des détonateurs. Cette méthode n'est applicable qu'aux détonateurs électriques comportant des fils d'amorce revêtus de plastique.

Eksplozivi za civilno uporabo – Detonatorji in zakasnilniki – 6. del: Ugotavljanje odpornosti vodnikov proti razpokanju pri nizkih temperaturah

General Information

• Status: Published
• Publication Date: 04-Nov-2003
• Withdrawal Date: 30-May-2004
• ICS: 71.100.30 - Explosives. Pyrotechnics and fireworks
• Technical Committee: CEN/TC 321 - Explosives for civil uses
• Drafting Committee: CEN/TC 321/WG 4 - Detonators and relays
• Current Stage: 9093 - Decision to confirm - Review Enquiry
• Completion Date: 30-Jul-2015
• Directive: 2014/28/EU - Directive 2014/28/EU of the European Parliament and of the Council of 26 February 2014 on the harmonisation of the laws of the Member States relating to the making available on the market and supervision of explosives for civil uses
• Directive: 93/15/EEC - Council Directive 93/15/EEC of 5 April 1993 on the harmonization of the provisions relating to the placing on the market and supervision of explosives for civil uses
• Mandate: M/055 - Standardization mandate to CEN for explosives for civil uses
• Ref Project: SIST EN 13763-6:2004 - Explosives for civil uses - Detonators and relays - Part 6: Determination of resistance to cracking in low temperatures of leading wires

Relations

• Revised: FprEN 13763-6 - Explosives for civil uses - Detonators and detonating cord relays - Part 6: Determination of resistance to cracking in low temperatures of leading wires
• Effective Date: 18-Jan-2023

Standards Content (Sample)

2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Eksplozivi za civilno uporabo – Detonatorji in zakasnilniki – 6. del: Ugotavljanje odpornosti vodnikov proti razpokanju pri nizkih temperaturahExplosivstoffe für zivile Zwecke - Zünder und Verzögerungselemente - Teil 6: Bestimmung des Widerstandes der Isolation von Zünderdrähten gegen Rissbildung bei niedrigen TemperaturenExplosifs a usage civil - Détonateurs et relais - Partie 6: Détermination de la résistance a la fissuration des fils d'amorces a basse températureExplosives for civil uses - Detonators and relays - Part 6: Determination of resistance to cracking in low temperatures of leading wires71.100.30Eksplozivi. PirotehnikaExplosives. PyrotechnicsICS:Ta slovenski standard je istoveten z:EN 13763-6:2003SIST EN 13763-6:2004en01-januar-2004SIST EN 13763-6:2004SLOVENSKI
STANDARD







EUROPEAN STANDARDNORME EUROPÉENNEEUROPÄISCHE NORMEN 13763-6November 2003ICS 71.100.30English versionExplosives for civil uses - Detonators and relays - Part 6:Determination of resistance to cracking in low temperatures ofleading wiresExplosifs à usage civil - Détonateurs et relais - Partie 6:Détermination de la résistance à la fissuration des filsd'amorces à basse températureExplosivstoffe für zivile Zwecke - Zünder undVerzögerungselemente - Teil 6: Bestimmung desWiderstandes der Isolation von Zünderdrähten gegenRissbildung bei niedrigen TemperaturenThis European Standard was approved by CEN on 1 September 2003.CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this EuropeanStandard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such nationalstandards may be obtained on application to the Management Centre or to any CEN member.This European Standard exists in three official versions (English, French, German). A version in any other language made by translationunder the responsibility of a CEN member into its own language and notified to the Management Centre has the same status as the officialversions.CEN members are the national standards bodies of Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece,Hungary, Iceland, Ireland, Italy, Luxembourg, Malta, Netherlands, Norway, Portugal, Slovakia, Spain, Sweden, Switzerland and UnitedKingdom.EUROPEAN COMMITTEE FOR STANDARDIZATIONCOMITÉ EUROPÉEN DE NORMALISATIONEUROPÄISCHES KOMITEE FÜR NORMUNGManagement Centre: rue de Stassart, 36
B-1050 Brussels© 2003 CENAll rights of exploitation in any form and by any means reservedworldwide for CEN national Members.Ref. No. EN 13763-6:2003 E



EN 13763-6:2003 (E)2ContentspageForeword.3Introduction.51Scope.52Normative references.53Terms and definitions.54Test pieces.55Apparatus.66Procedure.67Test report.7Annex A (informative)
Range of applicability of the test method.8Annex ZA (informative)
Clauses of this European Standard addressing essential requirements or otherprovisions of EU Directives.9



EN 13763-6:2003 (E)3ForewordThis document (EN 13763-6:2003) has been prepared by Technical Committee CEN/TC 321 "Explosives for civiluses", the secretariat of which is held by AENOR.This European Standard shall be given the status of a national standard, either by publication of an identical text orby endorsement, at the latest by May 2004, and conflicting national standards shall
...