Magnesium and magnesium alloys - Magnesium alloy ingots and castings

This document defines the grades and the corresponding requirements for cast alloyed magnesium materials.
This document specifies 2 groups of magnesium alloy grades by a classification based on the chemical composition. The first group deals with grades for magnesium alloy ingots. The second group deals with grades for magnesium alloy castings.
This document also specifies mechanical properties measured on test pieces machined from cast samples.
This document does not cover technical delivery conditions for magnesium alloy castings (see EN 1559-1 [7] and EN 1559-5 [8]).

Magnesium und Magnesiumlegierungen - Blockmetalle und Gussstücke aus Magnesiumlegierungen

Dieses Dokument legt die Sorten und die entsprechenden Anforderungen an Gussstücke aus Magnesium-legierungen fest.
Dieses Dokument legt zwei Gruppen von Magnesiumgusslegierungssorten nach der Einordnung anhand der chemischen Zusammensetzung fest. Die erste Gruppe behandelt Sorten für Blockmetalle aus Magnesium¬legierungen. Die zweite Gruppe behandelt Sorten für Gussstücke aus Magnesiumlegierungen.
Dieses Dokument legt außerdem die mechanischen Eigenschaften fest, die an Proben, die aus Probestücken hergestellt wurden, ermittelt wurden.
Dieses Dokument deckt nicht die technischen Lieferbedingungen für Gussstücke aus Magnesium-legierungen (siehe EN 1559 1 [7] und EN 1559 5 [8]) ab.

Magnésium et alliages de magnésium - Lingots et pièces moulées en alliages de magnésium

Le présent document spécifie les nuances et les exigences correspondantes pour les matériaux moulés en alliages de magnésium.
Le présent document spécifie deux groupes de nuances d’alliages de magnésium moulé, en utilisant une classification basée sur la composition chimique. Le premier groupe concerne les nuances pour lingots en alliages de magnésium. Le second groupe concerne les nuances pour les pièces moulées en alliages de magnésium.
Le présent document spécifie aussi les propriétés mécaniques déterminées sur des éprouvettes usinées, préparées à partir d’échantillons coulés.
Le présent document ne couvre pas les conditions techniques de fourniture des pièces moulées en alliages de magnésium (voir l’EN 1559-1 [7] et l’EN 1559-5 [8]).

Magnezij in magnezijeve zlitine - Ingoti in ulitki iz magnezijevih zlitin

Ta dokument določa razrede in ustrezne zahteve za materiale iz litij magnezijevih zlitin. Ta dokument določa 2 skupini razredov magnezijevih zlitin z razvrstitvijo, ki temelji na kemijski sestavi. Prva skupina obravnava razrede za ingote iz magnezijevih zlitin. Druga skupina obravnava razrede za ulitke iz magnezijevih zlitin. Ta dokument določa tudi mehanske lastnosti, izmerjene na strojno obdelanih preskusnih primerkih iz litih vzorcev. Ta dokument ne zajema tehničnih dobavnih pogojev za ulitke iz magnezijevih zlitin (glej standarda EN 1559-1 [7] in EN 1559-5 [8]).

General Information

Status
Published
Publication Date
24-Sep-2019
Withdrawal Date
30-Mar-2020
Current Stage
6060 - Definitive text made available (DAV) - Publishing
Start Date
25-Sep-2019
Due Date
03-Mar-2020
Completion Date
25-Sep-2019

Relations

Buy Standard

Standard
EN 1753:2019
English language
31 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day
Draft
prEN 1753:2018
English language
31 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN 1753:2019
01-december-2019
Nadomešča:
SIST EN 1753:1998
SIST EN 1753:1998/AC:2004
Magnezij in magnezijeve zlitine - Ingoti in ulitki iz magnezijevih zlitin
Magnesium and magnesium alloys - Magnesium alloy ingots and castings
Magnesium und Magnesiumlegierungen - Blockmetalle und Gussstücke aus
Magnesiumlegierungen
Magnésium et alliages de magnésium - Lingots et pièces moulées en alliages de
magnésium
Ta slovenski standard je istoveten z: EN 1753:2019
ICS:
77.150.20 Magnezijevi izdelki Magnesium products
SIST EN 1753:2019 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------
SIST EN 1753:2019

---------------------- Page: 2 ----------------------
SIST EN 1753:2019


EN 1753
EUROPEAN STANDARD

NORME EUROPÉENNE

September 2019
EUROPÄISCHE NORM
ICS 77.150.20 Supersedes EN 1753:1997
English Version

Magnesium and magnesium alloys - Magnesium alloy
ingots and castings
Magnésium et alliages de magnésium - Lingots et Magnesium und Magnesiumlegierungen - Blockmetalle
pièces moulées en alliages de magnésium und Gussstücke aus Magnesiumlegierungen
This European Standard was approved by CEN on 5 August 2019.

CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this
European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references
concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN
member.

This European Standard exists in three official versions (English, French, German). A version in any other language made by
translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and
United Kingdom.





EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2019 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 1753:2019 E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------
SIST EN 1753:2019
EN 1753:2019 (E)
Contents Page
European foreword . 3
Introduction . 4
1 Scope . 5
2 Normative references . 5
3 Terms and definitions . 5
4 Designation. 6
5 Order information . 7
6 Manufacture . 7
7 Requirements . 7
8 Sampling . 20
9 Test methods . 22
10 Retests . 24
11 Inspection documentation . 24
Annex A (informativ
...

SLOVENSKI STANDARD
oSIST prEN 1753:2018
01-september-2018
Magnezij in magnezijeve zlitine - Ingoti in ulitki iz magnezijevih zlitin
Magnesium and magnesium alloys - Magnesium alloy ingots and castings
Magnesium und Magnesiumlegierungen - Blockmetalle und Gussstücke aus
Magnesiumlegierungen
Magnésium et alliages de magnésium - Lingots et pièces moulées en alliages de
magnésium
Ta slovenski standard je istoveten z: prEN 1753
ICS:
77.150.20 Magnezijevi izdelki Magnesium products
oSIST prEN 1753:2018 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------
oSIST prEN 1753:2018

---------------------- Page: 2 ----------------------
oSIST prEN 1753:2018


DRAFT
EUROPEAN STANDARD
prEN 1753
NORME EUROPÉENNE

EUROPÄISCHE NORM

June 2018
ICS 77.150.20 Will supersede EN 1753:1997
English Version

Magnesium and magnesium alloys - Magnesium alloy
ingots and castings
Magnésium et alliages de magnésium - Lingots et Magnesium und Magnesiumlegierungen - Blockmetalle
pièces moulées en alliages de magnésium und Gussstücke aus Magnesiumlegierungen
This draft European Standard is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee
CEN/TC 190.

If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations
which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.

This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC
Management Centre has the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and United Kingdom.

Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are
aware and to provide supporting documentation.

Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without
notice and shall not be referred to as a European Standard.


EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2018 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN 1753:2018 E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------
oSIST prEN 1753:2018
prEN 1753:2018 (E)
Contents Page
European foreword . 4
Introduction . 5
1 Scope . 6
2 Normative references . 6
3 Terms and definitions . 6
4 Designation. 7
4.1 Material . 7
4.2 Casting process . 7
4.3 Temper . 7
5 Order information . 8
6 Manufacture . 8
7 Requirements .
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.