HD 145 S1:1977

Numbering of electrodes and designation of units in electronic tubes and valves

Applies to multi-electrode tubes, with the exception of cathode-ray tubes. Describes the system used for numbering the electrodes of the same type multi-electrode tubes and for assigning designations to the units of multiple-unit tubes.

Numerierung der Elektroden und Bezeichnung der Systeme an Elektronenröhren

Numérotation des électrodes et désignation des sections des tubes électroniques

Applicable aux tubes à plusieurs électrodes à l'exception des tubes à rayons cathodiques. Donne la méthode utilisée pour numéroter les électrodes de même type des tubes à plusieurs électrodes et pour désigner les sections des tubes à plusieurs sections.

Numbering of electrodes and designation of units in electronic tubes and valves

General Information

• Status: Published
• Publication Date: 14-May-1977
• Technical Committee: CLC/SR 110 - Flat panel display devices
• Drafting Committee: IEC/TC 110 - IEC_TC_110
• Parallel Committee: IEC/TC 39 - IEC_TC_39
• Current Stage: 6060 - Document made available - Publishing
• Start Date: 15-May-1977
• Completion Date: 15-May-1977
• Ref Project: SIST HD 145 S1:2004 - Numbering of electrodes and designation of units in electronic tubes and valves

Standards Content (Sample)

SLOVENSKI SIST HD 145 S1:2004

STANDARD
julij 2004
Numbering of electrodes and designation of units in electronic tubes and valves
ICS 31.100 Referenčna številka
SIST HD 145 S1:2004(en)
©  Standard je založil in izdal Slovenski inštitut za standardizacijo. Razmnoževanje ali kopiranje celote ali delov tega dokumenta ni dovoljeno

---------------------- Page: 1 ----------------------

NORME CEI
INTERNATIONALE IEC
60135
INTERNATIONAL
Première édition
STAN
DARD
First edition
1961-01
Numérotation
des électrodes et désignation
des sections des tubes
électroniques
Numbering of electrodes and designation
of units in electronic tubes and valves
© IEC 1961 Droits de reproduction
réservés — Copyright - all rights reserved
Aucune partie de cette publication ne peut être reproduite ni No part of this publication may be reproduced or utilized in
utilisée sous quelque forme que ce soit
et par aucun any form or by any means, electronic or mechanical,
procédé, électronique ou mécanique, y compris
la photo- including photocopying and microfilm, without permission in
copie et les microfilms, sans l'accord écrit de
l'éditeur. writing from the publisher.
International Electrotechnical Commission 3, rue de Varembé Geneva, Switzerland
Telefax: [phone] e-mail: [e-mail] IEC web site http: //www.iec.ch
CODE PRIX
Commission Electrotechnique Internationale
E
PRICE CODE
International Electrotechnical Commission
IEC MeeayHapoimaa
3neKTpoTexHHVecnaa KoMHCCHc
Pour prix, voir catalogue en vigueur
•
For price, see current catalogue

---------------------- Page: 2 ----------------------

CONTENTS
Page
FOREWORD 5
PREFACE 5
Clause
1. Scope and object 7
2. Numbering of electrodes in single-unit tubes and valves 7
3. Numbering of electrodes in multiple-unit tubes and valves 7
4. Designation of units in multiple-unit tubes and valves 7

---------------------- Page: 3 ----------------------

5
INTERNATIONAL ELECTROTECHNICAL COMMISSION
NUMBERING OF ELECTRODES AND DESIGNATION OF UNITS IN
ELECTRONIC TUBES AND VALVES
FOREWORD
1) The formal decisions or agreements of the I.E.C. on technical matters, prepared by Technical Committees on which
all the National Committees having a special interest therein are represented, express, as nearly as possible, an inter-
national consensus of opinion on the subjects dealt with.
2) They have the form of recommendations for international use and they are accepted by the National Committees in
that sense.
3) In order to promote this international unification, the I.E.C. expresses the wish that all National Committees having
as yet no national rules, when preparing such rules, should use the I.E.C. recommendations as the fundamental basis
for these rules in so far as national conditions will permit.
4) The desirability is recognized of extending international agreement on these matters through an endeavour to harmonize
national standardization rules with these recommendations in so far as national conditions will permit. The National
Committees pledge their influence towards that end.
PREFACE
This recommendation has been prepared by Technical Committee No. 39. Electronic tubes and valves.
Following a discussion of documents on the subject of the numbering of the electrodes and the
designation of the units in electronic tubes and valves at a meeting held in Madrid in July 1959. a draft
was submitted to the National Committees for approval under the Six Months' Rule in May 1960.
The following countries voted explicitly in favour of publication:
Austria Netherlands
Belgium Portugal
Canada Romania
Czechoslovakia Sweden
Denmark Switzerland
France Union of Socialist Soviet Republics
Germany United Kingdom
Israel United States of America
Italy

---------------------- Page: 4 ----------------------

7
NUMBERING OF ELECTRODES AND DESIGNATION OF UNITS IN
ELECTRONIC TUBES AND VALVES
Scope and object
1.
This recommendation applies to multi-electrodes tubes and valves, with the exception of cathode-ray
tubes.
...