HD 620 S1:1996/A1:2001
(Amendment)Distribution cables with extruded insulation for rated voltages from 3,6/6 (7,2) kV to 20,8/36 (42) kV
Distribution cables with extruded insulation for rated voltages from 3,6/6 (7,2) kV to 20,8/36 (42) kV
Superseded by HD 620 S2:2010
Energieverteilungskabel mit extrudierter Isolierung für Nennspannungen von 3,6/6 (7,2) kV bis 20,8/36 (42) kV
Câbles de distribution, à isolation extrudée, pour des tensions assignées de 3,6/6 (7,2) kV à 20,8/36 (42) kV inclus
Amendment to HD according to maintenance programme - Group 2
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST HD 620 S1:1998/A1:2002
01-april-2002
Amendment to HD according to maintenance programme - Group 2
Distribution cables with extruded insulation for rated voltages from 3,6/6 (7,2) kV to
20,8/36 (42) kV
Energieverteilungskabel mit extrudierter Isolierung für Nennspannungen von 3,6/6 (7,2)
kV bis 20,8/36 (42) kV
Câbles de distribution, à isolation extrudée, pour des tensions assignées de 3,6/6 (7,2)
kV à 20,8/36 (42) kV inclus
Ta slovenski standard je istoveten z: HD 620 S1:1996/A1:2001
ICS:
29.060.20 Kabli Cables
SIST HD 620 S1:1998/A1:2002 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST HD 620 S1:1998/A1:2002
---------------------- Page: 2 ----------------------
SIST HD 620 S1:1998/A1:2002
HARMONIZATION DOCUMENT HD 620 S1/A1
DOCUMENT D'HARMONISATION (Volume I: Parts 1 to 5)
HARMONISIERUNGSDOKUMENT July 2001
ICS 29.060.20
English version
Distribution cables with extruded insulation for rated voltages
from 3,6/6 (7,2) kV to 20,8/36 (42) kV
Câbles de distribution, à isolation Energieverteilungskabel mit extrudierter
extrudée, pour des tensions assignées Isolierung für Nennspannungen
de 3,6/6 (7,2) kV à 20,8/36 (42) kV inclus von 3,6/6 (7,2) kV bis 20,8/36 (42) kV
This amendment A1 modifies the Harmonization Document HD 620 S1:1996; it was approved by
CENELEC on 2000-08-01. CENELEC members are bound to comply with the CEN/CENELEC Internal
Regulations which stipulate the conditions for implementation of this amendment on a national level.
Up-to-date lists and bibliographical references concerning such national implementation may be obtained on
application to the Central Secretariat or to any CENELEC member.
This amendment exists in three official versions (English, French).
CENELEC members are the national electrotechnical committees of Austria, Belgium, Czech Republic,
Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway,
Portugal, Spain, Sweden, Switzerland and United Kingdom.
CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
Central Secretariat: rue de Stassart 35, B - 1050 Brussels
© 2001 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. HD 620 S1:1996/A1:2001 E
---------------------- Page: 3 ----------------------
SIST HD 620 S1:1998/A1:2002
Page 0-2
HD 620 S1:1996/A1:2001
FOREWORD
This amendment to HD 620 S1:1996 has been prepared by WG9 of CENELEC TC20 "Electric Cables".
CENELEC TC20 confirmed at its Dublin meeting (April 1997) that the amendment should go to the Unique
Acceptance Procedure.
Part 1 has been completely re-issued, due to extensive changes to the tables of compounds, and to the
complete withdrawal of cable types with PVC insulation. Because of this withdrawal of PVC insulated cables,
Parts 3 and 4 are now designated "Spare". A list of additions and amendments to the particular sections of
Parts 5-9 is given in this Part 0.
NOTE During the preparation of this amendment, IEC 502 (4th edition) has been replaced by IEC 60502-2.
In general the updating of these references has not been included in this amendment unless a complete section has been introduced or
replaced. Users should refer to IEC 60502-2 for the most up-to-date information, but note that the clause numbers are not identical to those
in IEC 502 (4th edition).
The draft was submitted to the Unique Acceptance Procedure in September 1999 and was approved by
CENELEC as amendment A1 to HD 620 S1:1996 on 2000-08-01.
The following dates were fixed:
- latest date by which the existence of the amendment
has to be announced at national level (doa) 2001-02-01
- latest date by which the amendment has to be implemented
at national level by publication of a harmonized
national standard or by endorsement (dop) 2002-01-01
- latest date by which the national standards conflicting
with the amendment have to be withdrawn (dow) 2003-08-01
---------------------- Page: 4 ----------------------
SIST HD 620 S1:1998/A1:2002
Page 0-3
HD 620 S1:1996/A1:2001
Contents
(HD 620 S1:1996 plus amendment A1)
(2)
PART 1 General requirements
(3)
PART 3 (Spare)
(3)
PART 4 (Spare)
PART 5 XLPE insulated single core cables, and single core pre-assembled cables
5-A Cables with PE (Type 5A-1) or PVC sheath (Type 5A-2)
(1)
5-B Cables with PE (Type 5B-1) or PVC sheath (Type 5B-2)
(2)
5-C Cables with PE (Type 5C-1) or PVC sheath (Type 5C-2)
5-D Cables with PE (Type 5D-1) or PVC sheath (Type 5D-2)
(2)
5-E-1 Cables with polyolefine compound sheath (Type 5E-1)
5-E-2 Bundle assembled cables with steel messenger core for overhead distribution and service MV
(Type 5E-3)
5-F Cables with aluminium conductors and PVC sheath (Type 5F-1), cables with aluminium
conductors and PE sheath with
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.