EN 50525-2-83:2011

Electric cables - Low voltage energy cables of rated voltages up to and including 450/750 V (U0/U) - Part 2-83: Cables for general applications - Multicore cables with crosslinked silicone rubber insulation

This European Standard applies to multicore cables insulated and sheathed with heat resistant crosslinked silicone rubber. Types with or without an overall textile braid, and with or without a strain-bearing element, are included. The cables are of rated voltages U0/U 300/500 V. The cables are intended for use within high temperature zones, either: - in fixed installations with mechanical protection (cables to 4.1); or - for flexible use under low mechanical stress (cables to 4.2). The maximum conductor operating temperature for each of the cables in this standard is 180 °C. NOTE HD 516 contains extensive guidance on the safe use of cables in this standard. This EN 50525-2-83 should be read in conjunction with EN 50525-1, which specifies general requirements.

Kabel und Leitungen - Starkstromleitungen mit Nennspannungen bis 450/750 V (U0/U) - Teil 2-83: Starkstromleitungen für allgemeine Anwendungen - Mehradrige Leitungen mit vernetzter Silikon-Isolierung

Câbles électriques - Câbles d’énergie basse tension de tension assignée au plus égale à 450/750 V (U0/U) - Partie 2-83: Câbles pour applications générales - Câbles multiconducteurs isolés au silicone réticulé

Električni kabli - Nizkonapetostni energetski kabli z nazivno napetostjo do vključno 450/750 V - 2-83. del: Kabli za splošno uporabo - Večžilni kabli z zamreženo elastomerno izolacijo iz silikonske gume

Ta evropski standard velja za večžilne kable, ki so oplaščeni in imajo zamreženo elastomerno izolacijo iz toplotno odporne silikonske gume. Vključeni so tipi, ki so ali niso v celoti pleteni iz tkanine in z elementom napetostne zmogljivosti ali brez njega. Ti kabli imajo nazivno napetost U0/U 300/500 V. Kabli so primerni za uporabo na območjih z visokimi temperaturami ali: - pri fiksnih inštalacijah z mehansko zaščito (kabli do točke 4.1.); ali - za fleksibilno uporabo pod nizkim mehanskih stresom (kabli do točke 4.2). Maksimalna delovna temperatura pretvornika za vsakega od kablov iz tega standarda je 180 °C.

General Information

• Status: Published
• Publication Date: 05-May-2011
• Withdrawal Date: 16-Jan-2014
• ICS: 29.060.20 - Cables
• Technical Committee: CLC/TC 20 - Electric cables
• Drafting Committee: CLC/TC 20 - Electric cables
• Current Stage: 9093 - Decision to confirm - Review Enquiry
• Completion Date: 25-Sep-2019
• Directive: 2006/95/EC - Directive 2006/95/EC of the European Parliament and of the Council of 12 December 2006 on the harmonisation of the laws of Member States relating to electrical equipment designed for use within certain voltage limits (codified version)
• Directive: 2014/35/EU - Directive 2014/35/EU of the European Parliament and of the Council of 26 February 2014 on the harmonisation of the laws of the Member States relating to the making available on the market of electrical equipment designed for use within certain voltage limits
• Directive: 2014/53/EU - Directive 2014/53/EU of The European Parliament and of the Council of 16 April 2014 on the harmonisation of the laws of the Member States relating to the making available on the market of radio equipment and repealing Directive 1999/5/EC
• Ref Project: SIST EN 50525-2-83:2011 - Electric cables - Low voltage energy cables of rated voltages up to and including 450/750 V (U0/U) - Part 2-83: Cables for general applications - Multicore cables with crosslinked silicone rubber insulation

Relations

• Replaces: HD 22.15 S2:2007 - Cables of rated voltages up to and including 450/750 V and having cross-linked insulation - Part 15: Multicore cables insulated and sheathed with heat resistant silicone rubber
• Effective Date: 28-Jan-2023

Standards Content (Sample)

2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Kabel und Leitungen - Starkstromleitungen mit Nennspannungen bis 450/750 V (U0/U) - Teil 2-83: Starkstromleitungen für allgemeine Anwendungen - Mehradrige Leitungen mit vernetzter Silikon-IsolierungCâbles électriques - Câbles d’énergie basse tension de tension assignée au plus égale à 450/750 V (U0/U) - Partie 2-83: Câbles pour applications générales - Câbles multiconducteurs isolés au silicone réticuléElectric cables - Low voltage energy cables of rated voltages up to and including 450/750 V (U0/U) - Part 2-83: Cables for general applications - Multicore cables with crosslinked silicone rubber insulation29.060.20KabliCablesICS:Ta slovenski standard je istoveten z:EN 50525-2-83:2011SIST EN 50525-2-83:2011en01-september-2011SIST EN 50525-2-83:2011SLOVENSKI
STANDARD
EUROPEAN STANDARD EN 50525-2-83 NORME EUROPÉENNE
EUROPÄISCHE NORM May 2011
CENELEC European Committee for Electrotechnical Standardization Comité Européen de Normalisation Electrotechnique Europäisches Komitee für Elektrotechnische Normung
Management Centre: Avenue Marnix 17, B - 1000 Brussels
© 2011 CENELEC -
All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 50525-2-83:2011 E
ICS 29.060.20 Supersedes HD 22.15 S2:2007
English version
Electric cables -
Low voltage energy cables of rated voltages up to and including 450/750 V (U0/U) -
Part 2-83: Cables for general applications -
Multicore cables with crosslinked silicone rubber insulation
Câbles électriques -
Câbles d’énergie basse tension de tension assignée au plus égale à 450/750 V (U0/U) -
Partie 2-83: Câbles pour applications générales -
Câbles multiconducteurs isolés au siliconeréticulé
Kabel und Leitungen -
Starkstromleitungen mit Nennspannungen bis 450/750 V (U0/U) -
Teil 2-83: Starkstromleitungen für allgemeine Anwendungen -
Mehradrige Leitungen mit vernetzter Silikon-Isolierung
This European Standard was approved by CENELEC on 2011-01-17. CENELEC members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the Central Secretariat or to any CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CENELEC member into its own language and notified to the Central Secretariat has the same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus, the Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and the United Kingdom.
The text of the draft was submitted to the formal vote and was accepted by CENELEC as EN 50525-2-83 on 2011-01-17.
This document, which is one of a multipart series, supersedes HD 22.15 S2:2007.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. CEN and CENELEC shall not be held responsible for identifying any or all such patent rights.
The following dates are proposed:
– latest date by which the EN has to be implemented at national level by publication of an identical national standard or by endorsement
(dop)
2012-01-17 – latest date by which the national standards conflicting with the EN have to be withdrawn
(dow)
2014-01-17
____________ SIST EN 50525-2-83:2011

- 3 - EN 50525-2-83:2011
Contents Page 1Scope . 42Normative references . 43Terms and definitions . 54Heat resistant cables (180 °C) . 54.1Cables H05SS-F and braided cables H05SST-F . 54.2Cables H05SSD3-K and braided cables H05SSD3T-K, with strain-bearing element . 6Annex A (normative)
Tests for cables to EN 50525-2-83 . 8Annex B (normative)
General data . 10Annex C (normative)
Requirements for compatibility test . 11C.1Test conditions . 11C.2Requirements . 11Bibliography . 12 Tables Table A.1 . 8Table B.1 . 10Table C.1
Requirements . 11 SIST EN 50525-2-83:2011

- for flexible use under low mechanical stress (cables to 4.2). The maximum conductor operating temperature for each of the cables in this standard is 180 °C. NOTE HD 516 contains extensive guidance on the safe use of cables in this standard. This EN 50525-2-83 should be read in conjunction with EN 50525-1, which specifies general requirements. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
NOTE One or more references to the standards below are in respect of a specific sub-division of that standard, for instance a clause, a table, a class or a type. Cross-references to these standards are undated and, at all times, the latest version applies.
EN 50363-1
Insulating, sheathing and covering materials for low voltage energy cables − Part 1: Cross-linked elastomeric insulating compounds EN 50363-2-1
Insulating, sheathing and covering materials for low voltage energy cables − Part 2-1: Cross-linked elastomeric sheathing compounds EN 50395
Electrical test methods for low voltage energy cables EN 50396
Non electrical test methods for low voltage energy cables EN 50525-1
Electric cables − Low voltage energy cables of rated voltages up to and including 450/750 V (U0/U) − Part 1: General requirements EN 60228
Conductors of insulated cables (IEC 60228) EN 60332-1-2
Tests on electric and optical fibre cables under fire conditions −
Part 1-2: Test for vertical flame propagation for a single insulated wire or cable − Procedure for 1 kW pre-mixed flame (IEC 60332-1-2) EN 60811-1-2
Insulating and sheathing materials of electric
and optical cables − Common test methods − Part 1-2: General application − Thermal ageing methods (IEC 60811-1-2) EN 60811-1-4
Insulating and sheathing materials of electric and optical cables − Common test methods − Part 1-4: General application − Tests at low temperature (IEC 60811-1-4) EN ISO 6892-1 2009 Metallic materials − Tensile testing − Part 1: Method of test at room temperature (ISO 6892-1:2009) SIST EN 50525-2-83:2011

- 5 - EN 50525-2-83:2011
3 Terms and definitions For
...