IEC 60811-505:2012
(Main)Electric and optical fibre cables - Test methods for non-metallic materials - Part 505: Mechanical tests - Elongation at low temperature for insulations and sheaths
Electric and optical fibre cables - Test methods for non-metallic materials - Part 505: Mechanical tests - Elongation at low temperature for insulations and sheaths
IEC 60811-505:2012 gives the procedure for performing elongation tests at low temperature on extruded insulations and sheaths. IEC 60811-505:2012 cancels and replaces 8.3 and 8.4 of IEC 60811-1-4:1985, which is withdrawn. Full details of the replacements are shown in Annex A of IEC 60811-100:2012. There are no specific technical changes with respect to the previous edition, but see the Foreword to IEC 60811-100:2012.
This publication is to be read in conjunction with IEC 60811-100:2012.
Câbles électriques et à fibres optiques - Méthodes d'essai pour les matériaux non-métalliques - Partie 505: Essais mécaniques - Essai d'allongement à basse température pour les enveloppes isolantes et les gaines
La CEI 60811-505:2012 décrit la procédure à suivre pour réaliser les essais d'allongement à basse température sur les enveloppes isolantes et les gaines extrudées. La CEI 60811-505:2012 annule et remplace 8.3 et 8.4 de la CEI 60811-1-4:1985, qui est supprimée. L'ensemble des informations relatives aux remplacements figure dans l'Annexe A de la CEI 60811-100:2012. Aucune modification technique n'a été effectuée par rapport à l'édition précédente; voir cependant l'avant-propos de la CEI 60811-100:2012.
Cette publication doit être lue conjointement avec la CEI 60811-100:2012.
Alarm systems - Part 2: Requirements for intruder alarm systems - Section 7: Passive glass break detectors for use in buildings
General Information
Buy Standard
Standards Content (Sample)
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Alarm systems - Part 2: Requirements for intruder alarm systems - Section 7: Passive glass break detectors for use in buildingsSystèmes d'alarme - Partie 2: Prescriptions pour les systèmes d'alarme anti-intrusion - Section 7: Détecteurs passifs de bris de glace dans les bâtimentsAlarm systems - Part 2: Requirements for intruder alarm systems - Section 7: Passive glass-break detectors for use in buildings13.320Alarmni in opozorilni sistemiAlarm and warning systemsICS:Ta slovenski standard je istoveten z:IEC 60839-2-7SIST IEC 60839-2-7:1995en01-september-1995SIST IEC 60839-2-7:1995SLOVENSKI
STANDARD
SIST IEC 60839-2-7:1995
NORMECEIINTERNATIONALEIECINTERNATIONAL60839-2-7STANDARDPremière éditionFirst edition1994-12Systèmes d'alarmePartie 2:Prescriptions pour les systèmes d'alarmeanti-intrusionSection 7 – Détecteurs passifs de bris de glacedans les bâtimentsAlarm systemsPart 2:Requirements for intruder alarm systemsSection 7 – Passive glass-break detectorsfor use in buildings© IEC 1994 Droits de reproduction réservés — Copyright - all rights reservedAucune partie de cette publication ne peut être reproduite niNo part of this publication may be reproduced or utilized inutilisée sous quelque forme que ce soit et par aucunany form or by any means, electronic or mechanical,procédé, électronique ou mécanique, y compris la photo-including photocopying and microfilm, without permission incopie et les microfilms, sans l'accord écrit de l'éditeur.writing from the publisher.International Electrotechnical Commission3, rue de Varembé Geneva, SwitzerlandTelefax: +41 22 919 0300e-mail: inmail@iec.chIEC web site http: //www.iec.chIEC•Commission Electrotechnique InternationaleInternational Electrotechnical CommissionMekfayHapoaHaa 3nenrporexHH4ecnaa HOMHCCHfl•CODE PRIXPRICE CODEPour prix, voir catalogue en vigueurFor price, see current catalogueSIST IEC 60839-2-7:1995
839-2-7 © IEC:1994— 3 —CONTENTSPageFOREWORD 5Clause1 Scope 72Normative references 73Definitions94General considerations95 Requirements 95.1Functional95.2Environmental 115.3 Safety
135.4Reliability 135.5Interface
135.6 Construction 135.7 Marking 135.8Manufacturer's specifications 135.9 Enhancements 135.10 Installation test equipment 156 Test methods
156.1Sensitivity, reproducibility and sorting 156.2 Test matrix
156.3Group 1 tests
176.4 Group 2 tests
216.5 Group 3 tests
256.6Installation test equipment 29Figures
31SIST IEC 60839-2-7:1995
839-2-7 © IEC:1994— 5 —INTERNATIONAL ELECTROTECHNICAL COMMISSIONALARM SYSTEMS –Part 2: Requirements for intruder alarm systems –Section 7: Passive glass-break detectors for use in buildingsFOREWORD1)The IEC (International Electrotechnical Commission) is a worldwide organization for standardizationcomprising all national electrotechnical committees (IEC National Committees). The object of the IEC is topromote international cooperation on all questions concerning standardization in the electrical andelectronic fields. To this end and in addition to other activities, the IEC publishes International Standards.Their preparation is entrusted to technical committees; any IEC National Committee interested inthe subject dealt with may participate in this preparatory work. International, governmental andnon-governmental organizations liaising with the IEC also participate in this preparation. The IECcollaborates closely with the International Organization for Standardization (ISO) in accordance withconditions determined by agreement between the two organizations.2)The formal decisions or agreements of the IEC on technical matters, prepared by technical committees onwhich all the National Committees having a special interest therein are represented, express, as nearly aspossible, an international consensus of opinion on the subjects dealt with.3)They have the form of recommendations for international use published in the form of standards, technicalreports or guides and they are accepted by the National Committees in that sense.4)In order to promote international unification, IEC National Committees undertake to apply IEC InternationalStandards transparently to the maximum extent possible in their national and regional standards. Anydivergence between the IEC Standard and the corresponding national or regional standard shall be clearlyindicated in the latter.International Standard IEC 839-2-7 has been prepared by IEC technical committee 79:Alarm systems.The text of this standard is based on the following documents:DISReport on voting
79(CO)5279/136/RVDFull information on the voting for the approval of this standard can be found in the reporton voting indicated in the above table.SIST IEC 60839-2-7:1995
839-2-7 © IEC:1994–7-ALARM SYSTEMS -Part 2: Requirements for intruder alarm systems -Section 7: Passive glass-break detectors for use in buildings1 ScopeThis section of IEC 839-2 gives the specific requirements and test meth
...
IEC 60811-505
®
Edition 1.0 2012-03
INTERNATIONAL
STANDARD
NORME
INTERNATIONALE
Electric and optical fibre cables – Test methods for non-metallic materials –
Part 505: Mechanical tests – Elongation at low temperature for insulations
and sheaths
Câbles électriques et à fibres optiques – Méthodes d’essai pour les matériaux
non-métalliques –
Partie 505: Essais mécaniques – Essai d’allongement à basse température
pour les enveloppes isolantes et les gaines
IEC 60811-505:2012
---------------------- Page: 1 ----------------------
THIS PUBLICATION IS COPYRIGHT PROTECTED
Copyright © 2012 IEC, Geneva, Switzerland
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form
or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from
either IEC or IEC's member National Committee in the country of the requester.
If you have any questions about IEC copyright or have an enquiry about obtaining additional rights to this publication,
please contact the address below or your local IEC member National Committee for further information.
Droits de reproduction réservés. Sauf indication contraire, aucune partie de cette publication ne peut être reproduite ni
utilisée sous quelque forme que ce soit et par aucun procédé, électronique ou mécanique, y compris la photocopie et les
microfilms, sans l'accord écrit de la CEI ou du Comité national de la CEI du pays du demandeur.
Si vous avez des questions sur le copyright de la CEI ou si vous désirez obtenir des droits supplémentaires sur cette
publication, utilisez les coordonnées ci-après ou contactez le Comité national de la CEI de votre pays de résidence.
IEC Central Office Tel.: +41 22 919 02 11
3, rue de Varembé Fax: +41 22 919 03 00
CH-1211 Geneva 20 info@iec.ch
Switzerland www.iec.ch
About the IEC
The International Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes
International Standards for all electrical, electronic and related technologies.
About IEC publications
The technical content of IEC publications is kept under constant review by the IEC. Please make sure that you have the
latest edition, a corrigenda or an amendment might have been published.
Useful links:
IEC publications search - www.iec.ch/searchpub Electropedia - www.electropedia.org
The advanced search enables you to find IEC publications The world's leading online dictionary of electronic and
by a variety of criteria (reference number, text, technical electrical terms containing more than 30 000 terms and
committee,…). definitions in English and French, with equivalent terms in
It also gives information on projects, replaced and additional languages. Also known as the International
withdrawn publications. Electrotechnical Vocabulary (IEV) on-line.
IEC Just Published - webstore.iec.ch/justpublished Customer Service Centre - webstore.iec.ch/csc
Stay up to date on all new IEC publications. Just Published If you wish to give us your feedback on this publication
details all new publications released. Available on-line and or need further assistance, please contact the
also once a month by email. Customer Service Centre: csc@iec.ch.
A propos de la CEI
La Commission Electrotechnique Internationale (CEI) est la première organisation mondiale qui élabore et publie des
Normes internationales pour tout ce qui a trait à l'électricité, à l'électronique et aux technologies apparentées.
A propos des publications CEI
Le contenu technique des publications de la CEI est constamment revu. Veuillez vous assurer que vous possédez
l’édition la plus récente, un corrigendum ou amendement peut avoir été publié.
Liens utiles:
Recherche de publications CEI - www.iec.ch/searchpub Electropedia - www.electropedia.org
La recherche avancée vous permet de trouver des Le premier dictionnaire en ligne au monde de termes
publications CEI en utilisant différents critères (numéro de électroniques et électriques. Il contient plus de 30 000
référence, texte, comité d’études,…). termes et définitions en anglais et en français, ainsi que
Elle donne aussi des informations sur les projets et les les termes équivalents dans les langues additionnelles.
publications remplacées ou retirées. Egalement appelé Vocabulaire Electrotechnique
International (VEI) en ligne.
Just Published CEI - webstore.iec.ch/justpublished
Service Clients - webstore.iec.ch/csc
Restez informé sur les nouvelles publications de la CEI.
Just Published détaille les nouvelles publications parues. Si vous désirez nous donner des commentaires sur
Disponible en ligne et aussi une fois par mois par email. cette publication ou si vous avez des questions
contactez-nous: csc@iec.ch.
---------------------- Page: 2 ----------------------
IEC 60811-505
®
Edition 1.0 2012-03
INTERNATIONAL
STANDA
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.