Commercial vehicles and buses -- Cross-tooth gearbox flanges, type T

Véhicules utilitaires et autobus -- Brides de boîtes de vitesses à dents croisées, type T

General Information

Status
Replaced
Publication Date
09-Jul-1986
Withdrawal Date
09-Jul-1986
Technical Committee
Drafting Committee
Current Stage
6060 - International Standard published
Completion Date
10-Jul-1986
Ref Project

RELATIONS

Buy Standard

Standard
ISO 8667:1986 - Commercial vehicles and buses -- Cross-tooth gearbox flanges, type T
English language
3 pages
sale 15% off
Preview
sale 15% off
Preview

Standards Content (sample)

International Standard @ 8667

INTERNATIONAL ORGANIZATION FOR STANDARDIZATION*MEXPYHAPOPHAR OPrAHHBAUHR no CTAHJlAPTM3AUHH.ORGANISATlON INTERNATIONALE DE NORMALISATION

Commercial vehicles and buses - Cross-tooth gearbox
flanges, type T

Véhicules utilitaires et autobus - Brides de boîtes de vitesses à dents croisées, type T

First edition - 1986-07-01
UDC 621.825.24 : 629.114.4/.5 Ref. No. IS0 8667-1986 (E)

Descriptors : road vehicles, commercial road vehicles, buses (vehicles), gear boxes, flanges, dimensions, designation.

Price based on 3 pages
---------------------- Page: 1 ----------------------
Foreword

IS0 (the International Organization for Standardization) is a worldwide federation of

national standards bodies (IS0 member bodies). The work of preparing International

Standards is normally carried out through IS0 technical committees. Each member

body interested in a subject for which a technical committee has been established has

the right to be represented on that committee. International organizations, govern-

mental and non-governmental, in liaison with ISO, also take part in the work.

Draft International Standards adopted by the technical committees are circulated to

the member bodies for approval before their acceptance as International Standards by

the IS0 Council. They are approved in accordance with IS0 procedures requiring at

least 75 % approval by the member bodies voting.
International Standard IS0 8667 was prepared by Technical Committee ISO/TC 22,
Road vehicles.

Users should note that all International Standards undergo revision from time to time

and that any reference made herein to any other International Standard implies its

latest edition, unless otherwise stated.
O International Organization for Standardization, 1986 0
Printed in Switzerland
---------------------- Page: 2 ----------------------
INTERNATIONAL STANDARD IS0 8667-1986 (E)
Commercial vehicles and buses - Cross-tooth gearbox
flanges, type T
pli
1s d field of ation 3 Dimensi nd toleran
Nominal dimensions and tolerances which affect the inter-
This International Standard specifies the nominal dimensions
changeability of type T gearbox flanges shall be as shown in the
and tolerances which affect interchangeability between cross-
table and figure.
tooth gearbox flanges, type T, and mating parts used on com-
mercial vehicles and buses.
Where the flange is formed by forging, an additional groove
either side of the driving teeth is permissible. In this case the

Dimensions and tolerances of the mating parts, other than additional grooves do not form part of the drive.

those occurring at the interface of the two flanges, are left to
the discretion of the manufacturer of that component.
4 Designation
Gearbox flanges meeting the requirements of this International
Standard shall be identified by a certain number of elements, to
2 References
be given in the following order:
IS0 1 101, Technical drawings - Geometrical tolerancing -
a) reference to this International Standard;
Tolerancing of form, orientation, location and run-out -
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.