ISO 13105-2:2014/Amd 1:2017

Building construction machinery and equipment — Machinery for concrete surface floating and finishing — Part 2: Safety requirements and verification — Amendment 1

Machines et matériels pour la construction des bâtiments — Talocheuses-lisseuses de mortier — Partie 2: Les exigences de sécurité et de vérification — Amendement 1

General Information

• Status: Withdrawn
• Publication Date: 04-Dec-2017
• ICS: 13.110 - Safety of machinery
• ICS: 91.220 - Construction equipment
• Technical Committee: ISO/TC 195/SC 1 - Machinery and equipment for concrete work
• Drafting Committee: ISO/TC 195/SC 1/WG 2 - Concrete floating machines

Relations

• Amends: ISO 13105-2:2014 - Building construction machinery and equipment — Machinery for concrete surface floating and finishing — Part 2: Safety requirements and verification
• Effective Date: 11-Dec-2021
• Revised: ISO 13105-2:2023 - Building construction machinery and equipment — Machinery for concrete surface floating and finishing — Part 2: Safety requirements and verification
• Effective Date: 06-Jun-2022

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 13105-2
First edition
2014-12-01
AMENDMENT 1
2017-11
Building construction machinery and
equipment — Machinery for concrete
surface floating and finishing —
Part 2:
Safety requirements and verification
AMENDMENT 1
Machines et matériels pour la construction des bâtiments —
Talocheuses-lisseuses de mortier —
Partie 2: Les exigences de sécurité et de vérification
AMENDEMENT 1
Reference number
ISO 13105-2:2014/Amd.1:2017(E)
©
ISO 2017

---------------------- Page: 1 ----------------------
ISO 13105-2:2014/Amd.1:2017(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2017, Published in Switzerland
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Ch. de Blandonnet 8 • CP 401
CH-1214 Vernier, Geneva, Switzerland
Tel. [phone]
Fax [phone]
[e-mail]
www.iso.org
ii © ISO 2017 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 13105-2:2014/Amd.1:2017(E)

Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular the different approval criteria needed for the
different types of ISO documents should be noted. This document was drafted in accordance with the
editorial rules of the ISO/IE
...