Resilient floor coverings - Polyvinyl chloride floor coverings for use in special wet areas - Specification

This European standard specifies the minimum additional characteristics which are necessary for:
-   polyvinyl chloride floor coverings in roll form according to EN ISO 10581 or EN ISO 10582 and
-   polyvinyl chloride floor coverings with foam backing in roll form to EN 651
to be installed satisfactorily in special wet areas to form a watertight installation with a long life. It specifies two categories (A and B) for use on different substrates.

Elastische Bodenbeläge - Polyvinylchlorid-Bodenbeläge zur Anwendung in besonderen Nassräumen - Spezifikation

Diese Europäische Norm legt ergänzende Mindesteigenschaften fest, die notwendig sind für:
-   Polyvinylchlorid-Bodenbeläge in Form von Rollen nach EN ISO 10581 oder EN ISO 10582;
-   Polyvinylchlorid-Bodenbeläge mit einem Schaumrücken in Form von Rollen nach EN 651,
-   Polyvinylchlorid-Bodenbeläge mit partikelbasiertem erhöhten Gleitwiderstand in Form von Rollen nach EN 13845,
die zur Anwendung in besonderen Nassräumen sorgfältig installiert werden, um eine langandauernde, wasserdichte Installation zu bilden. Die Norm legt zwei Klassen (A und B) zur Anwendung auf verschiedenen Untergründen fest.

Revêtements de sol résilients - Revêtements de sol à base de polychlorure de vinyle pour zones humides spéciales - Spécification

La présente Norme européenne spécifie les caractéristiques minimales additionnelles nécessaires pour que :
-   les revêtements de sol à base de polychlorure de vinyle, sous forme de rouleaux, conformes à l'EN ISO 10581 ou à l'EN ISO 10582 ;
-   les revêtements de sol à base de polychlorure de vinyle, sous forme de rouleaux, avec sous-couche en mousse, conformes à l'EN 651 ;
-   les revêtements de sol à base de polychlorure de vinyle à résistance accrue au glissement, sous forme de rouleaux, conformes à l’EN 13845 ;
puissent être installés de manière satisfaisante dans les zones humides spéciales de façon à constituer des installations durables étanches à l'eau. Elle spécifie deux catégories (A et B) à utiliser sur différents supports.

Netekstilne talne obloge - Polivinilkloridne talne obloge za uporabo na izjemno vlažnih površinah - Specifikacija

Ta evropski standard določa minimalne dodatne lastnosti, ki se zahtevajo za:
– polivinilkloridne talne obloge v zvitku, skladne s standardom EN ISO 10581 ali EN ISO 10582, in
– polivinilkloridne talne obloge s penastim hrbtiščem v zvitku, skladne s standardom EN 651,
ki se zadovoljivo namestijo na izjemno vlažnih površinah in oblikujejo vodotesen sestav z dolgo življenjsko dobo. Standard določa dve kategoriji (A in B) za uporabo na različnih podlagah.

General Information

Status
Published
Public Enquiry End Date
07-Aug-2016
Publication Date
04-Sep-2017
Current Stage
6060 - National Implementation/Publication (Adopted Project)
Start Date
30-Aug-2017
Due Date
04-Nov-2017
Completion Date
05-Sep-2017

Relations

Buy Standard

Standard
EN 13553:2017
English language
13 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)

2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Netekstilne talne obloge - Polivinilkloridne talne obloge za uporabo na izjemno vlažnih površinah - SpecifikacijaElastische Bodenbeläge - Polyvinylchlorid-Bodenbeläge zur Anwendung in besonderen Nassräumen - SpezifikationRevêtements de sol résilients - Revêtements de sol à base de polychlorure de vinyle pour zones humides spéciales - SpécificationResilient floor coverings - Polyvinyl chloride floor coverings for use in special wet areas - Specification97.150Talne oblogeFloor coveringsICS:Ta slovenski standard je istoveten z:EN 13553:2017SIST EN 13553:2017en,fr,de01-oktober-2017SIST EN 13553:2017SLOVENSKI
STANDARDSIST EN 13553:20151DGRPHãþD



SIST EN 13553:2017



EUROPEAN STANDARD NORME EUROPÉENNE EUROPÄISCHE NORM
EN 13553
August
t r s y ICS
{ yä s w r Supersedes EN
s u w w uã t r s wEnglish Version
Resilient floor coverings æ Polyvinyl chloride floor coverings for use in special wet areas æ Specification Revêtements de sol résilients æ Revêtements de sol à base de polychlorure de vinyle pour zones humides spéciales æ Spécification
Elastische Bodenbeläge æ PolyvinylchloridæBodenbeläge zur Anwendung in besonderen Nassräumen æ Spezifikation This European Standard was approved by CEN on
t t May
t r s yä
egulations which stipulate the conditions for giving this European Standard the status of a national standard without any alterationä Upætoædate lists and bibliographical references concerning such national standards may be obtained on application to the CENæCENELEC Management Centre or to any CEN memberä
translation under the responsibility of a CEN member into its own language and notified to the CENæCENELEC Management Centre has the same status as the official versionsä
CEN members are the national standards bodies of Austriaá Belgiumá Bulgariaá Croatiaá Cyprusá Czech Republicá Denmarká Estoniaá Finlandá Former Yugoslav Republic of Macedoniaá Franceá Germanyá Greeceá Hungaryá Icelandá Irelandá Italyá Latviaá Lithuaniaá Luxembourgá Maltaá Netherlandsá Norwayá Polandá Portugalá Romaniaá Serbiaá Slovakiaá Sloveniaá Spainá Swedená Switzerlandá Turkey and United Kingdomä
EUROPEAN COMMITTEE FOR STANDARDIZATION COMITÉ EUROPÉEN DE NORMALISATION EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre:
Avenue Marnix 17,
B-1000 Brussels
9
t r s y CEN All rights of exploitation in any form and by any means reserved worldwide for CEN national Membersä Refä Noä EN
s u w w uã t r s y ESIST EN 13553:2017



EN 13553:2017 (E) 2 Contents Page European foreword . 3 1 Scope . 4 2 Normative references . 4 3 Terms and definitions . 4 4 Requirements . 5 4.1 General requirements . 5 4.2 Additional performance requirements . 5 4.3 Installation . 5 5 Marking . 6 Annex A (normative)
Water tightness test . 7 A.1 Scope . 7 A.2 Apparatus . 7 A.3 Test specimen . 7 A.4 Conditioning . 8 A.5 Testing . 8 A.6 Test report . 9 Annex B (informative)
Choice of floor covering category. 10 Annex C (informative)
Installation . 11 Annex D (informative)
Determination of elongation at break (optional property) . 12 D.1 Apparatus, sampling and preparation of test pieces . 12 D.2 Procedure. 12 D.3 Calculation and expression of result . 12 D.4 Requirement . 12 D.5 Test report . 12
SIST EN 13553:2017



EN 13553:2017 (E) 3 European foreword This document (EN 13553:2017) has been prepared by Technical Committee CEN/TC 134 “Resilient, textile and laminate floor coverings”, the secretariat of which is held by NBN. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by February 2018, and conflicting national standards shall be withdrawn at the latest by February 2018. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. CEN shall not be held responsible for identifying any or all such patent rights. This document supersedes EN 13553:2015. The main changes in this revision relate to including the reference to EN 13845 in the scope and relevant parts of the standard. According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and the United Kingdom. SIST EN 13553:2017



EN 13553:2017 (E) 4 1 Scope This European standard specifies the minimum additional characteristics which are necessary for: — polyvinyl chloride floor coverings in roll form according to EN ISO 10581 or EN ISO 10582, — polyvinyl chloride floor coverings with foam backing in roll form to EN 651, — polyvinyl chloride floor coverings with particle based enhanced slip resistance in roll form to EN 13845 to be installed satisfactorily in special wet areas to form a watertight installation with a long life. It specifies two categories (A and B) for use on different substrates. 2 Normative references The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its appl
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.