SIST EN ISO 7010:2020/A1:2020
(Amendment)Graphical symbols - Safety colours and safety signs - Registered safety signs - Amendment 1 (ISO 7010:2019/Amd 1:2020)
Graphical symbols - Safety colours and safety signs - Registered safety signs - Amendment 1 (ISO 7010:2019/Amd 1:2020)
Graphische Symbole - Sicherheitsfarben und Sicherheitszeichen - Registrierte Sicherheitszeichen - Änderung 1 (ISO 7010:2019/Amd 1:2020)
No scope available
Symboles graphiques - Couleurs de sécurité et signaux de sécurité - Signaux de sécurité enregistrés - Amendement 1 (ISO 7010:2019/Amd 1:2020)
Grafični simboli - Varnostne barve in varnostni znaki - Registrirani varnostni znaki - Dopolnilo A1 (ISO 7010:2019/Amd 1:2020)
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN ISO 7010:2020/A1:2020
01-december-2020
Grafični simboli - Varnostne barve in varnostni znaki - Registrirani varnostni znaki
- Dopolnilo A1 (ISO 7010:2019/Amd 1:2020)
Graphical symbols - Safety colours and safety signs - Registered safety signs -
Amendment 1 (ISO 7010:2019/Amd 1:2020)
Graphische Symbole - Sicherheitsfarben und Sicherheitszeichen - Registrierte
Sicherheitszeichen - Änderung 1 (ISO 7010:2019/Amd 1:2020)
Symboles graphiques - Couleurs de sécurité et signaux de sécurité - Signaux de sécurité
enregistrés - Amendement 1 (ISO 7010:2019/Amd 1:2020)
Ta slovenski standard je istoveten z: EN ISO 7010:2020/A1:2020
ICS:
01.080.10 Simboli za javno obveščanje. Public information symbols.
Znaki. Table. Označbe Signs. Plates. Labels
13.200 Preprečevanje nesreč in Accident and disaster control
katastrof
SIST EN ISO 7010:2020/A1:2020 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN ISO 7010:2020/A1:2020
---------------------- Page: 2 ----------------------
SIST EN ISO 7010:2020/A1:2020
EN ISO 7010:2020/A1
EUROPEAN STANDARD
NORME EUROPÉENNE
October 2020
EUROPÄISCHE NORM
ICS 01.080.10; 01.080.20
English Version
Graphical symbols - Safety colours and safety signs -
Registered safety signs - Amendment 1 (ISO
7010:2019/Amd 1:2020)
Symboles graphiques - Couleurs de sécurité et signaux Graphische Symbole - Sicherheitsfarben und
de sécurité - Signaux de sécurité enregistrés - Sicherheitszeichen - Registrierte Sicherheitszeichen -
Amendement 1 (ISO 7010:2019/Amd 1:2020) Änderung 1 (ISO 7010:2019/Amd 1:2020)
This amendment A1 modifies the European Standard EN ISO 7010:2020; it was approved by CEN on 4 October 2020.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of
this amendment into the relevant national standard without any alteration. Up-to-date lists and bibliographical references
concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN
member.
This amendment exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has the
same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and
United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2020 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 7010:2020/A1:2020 E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST EN ISO 7010:2020/A1:2020
EN ISO 7010:2020/A1:2020 (E)
Contents Page
European foreword . 3
2
---------------------- Page: 4 ----------------------
SIST EN ISO 7010:2020/A1:2020
EN ISO 7010:2020/A1:2020 (E)
European foreword
The text of ISO 7010:2019/Amd 1:2020 has been prepared by Technical Committee ISO/TC 145
"Graphical symbols” of the International Organization for Standardization (ISO) and has been taken
over as EN ISO 7010:2020/A1:2020 by Technical Committee CEN/SS F16 “Graphical symbols” the
secretariat of which is held by CCMC.
This European Standard shall be given the status of a national standard, either by publication of an
identical text or by endorsement, at the latest by April 2021, and conflicting national standards shall be
withdrawn at the latest by April 2021.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CEN shall not be held responsible for identifying any or all such patent rights.
According to the CEN-CENELEC Internal Regulations, the national standards organizations of the
following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria,
Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland,
Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Republic of
North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and the
United Kingdom.
Endorsement notice
The text of ISO 7010:2019/Amd 1:2020 has been approved by CEN as EN ISO 7010:2020/A1:2020
without any modification.
3
---------------------- Page: 5 ----------------------
SIST EN ISO 7010:2020/A1:2020
---------------------- Page: 6 ----------------------
SIST EN ISO 7010:2020/A1:2020
INTERNATIONAL ISO
STANDARD 7010
Third edition
2019-07-30
AMENDMENT 1
2020-01
Graphical symbols — Safety colours
and safety signs — Registered safety
signs
AMENDMENT 1
Symboles graphiques — Couleurs de sécurité et signaux de sécurité —
Signaux de sécurité enregistrés
AMENDEMENT 1
Reference number
ISO 7010:2019/Amd.1:2020(E)
©
ISO 2020
---------------------- Page: 7 ----------------------
SIST EN ISO 7010:2020/A1:2020
ISO 7010:2019/Amd.1:2020(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2020
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting
on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address
below or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Fax: +41 22 749 09 47
Email: copyright@iso.org
Website: www.iso.org
Published in Switzerland
ii © ISO 2020 – All rights reserved
---------------------- Page: 8 ----------------------
SIST EN ISO 7010:2020/A1:2020
ISO 7010:2019/Amd.1:2020(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1.
...
SLOVENSKI STANDARD
SIST EN ISO 7010:2020/oprA1:2020
01-junij-2020
Grafični simboli - Varnostne barve in varnostni znaki - Registrirani varnostni znaki
- Dopolnilo 1 (ISO 7010:2019/Amd 1:2020)
Graphical symbols - Safety colours and safety signs - Registered safety signs -
Amendment 1 (ISO 7010:2019/Amd 1:2020)
Symboles graphiques - Couleurs de sécurité et signaux de sécurité - Signaux de sécurité
enregistrés - Amendement 1 (ISO 7010:2019/Amd 1:2020)
Ta slovenski standard je istoveten z: EN ISO 7010:2020/prA1
ICS:
01.080.10 Simboli za javno obveščanje. Public information symbols.
Znaki. Table. Označbe Signs. Plates. Labels
13.200 Preprečevanje nesreč in Accident and disaster control
katastrof
SIST EN ISO 7010:2020/oprA1:2020 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN ISO 7010:2020/oprA1:2020
---------------------- Page: 2 ----------------------
SIST EN ISO 7010:2020/oprA1:2020
INTERNATIONAL ISO
STANDARD 7010
Third edition
2019-07-30
AMENDMENT 1
2020-01
Graphical symbols — Safety colours
and safety signs — Registered safety
signs
AMENDMENT 1
Symboles graphiques — Couleurs de sécurité et signaux de sécurité —
Signaux de sécurité enregistrés
AMENDEMENT 1
Reference number
ISO 7010:2019/Amd.1:2020(E)
©
ISO 2020
---------------------- Page: 3 ----------------------
SIST EN ISO 7010:2020/oprA1:2020
ISO 7010:2019/Amd.1:2020(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2020
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting
on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address
below or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Fax: +41 22 749 09 47
Email: copyright@iso.org
Website: www.iso.org
Published in Switzerland
ii © ISO 2020 – All rights reserved
---------------------- Page: 4 ----------------------
SIST EN ISO 7010:2020/oprA1:2020
ISO 7010:2019/Amd.1:2020(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular, the different approval criteria needed for the
different types of ISO documents should be noted. This document was drafted in accordance with the
editorial rules of the ISO/IEC Directives, Part 2 (see www .iso .org/ directives).
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Details of
any patent rights identified during the development of the document will be in the Introduction and/or
on the ISO list of patent declarations received (see www .iso .org/ patents).
Any trade name used in this document is information given for the convenience of users and does not
constitute an endorsement.
For an explanation of the voluntary nature of standards, the meaning of ISO specific terms and
expressions related to conformity assessment, as well as information about ISO's adherence to the
World Trade Organization (WTO) principles in the Technical Barriers to Trade (TBT) see www .iso .org/
iso/ foreword .html.
This document was prepared by Technical Committee ISO/TC 145, Graphical symbols, Subcommittee
SC 2, Safety identification, signs, shapes, symbols and colours.
Any feedback or questions on this document should be directed to the user’s national standards body. A
complete listing of these bodies can be found at www .iso .org/ members .html.
© ISO 2020 – All rights reserved iii
---------------------- Page: 5 ----------------------
SIST EN ISO 7010:2020/oprA1:2020
---------------------- Page: 6 ----------------------
SIST EN ISO 7010:2020/oprA1:2020
ISO 7010:2019/Amd.1:2020(E)
Graphical symbols — Safety colours and safety signs —
Registered safety signs
AMENDMENT 1
IMPORTANT — The colours represented in the electronic file of this document can be neither
viewed on screen nor printed as true representations. For the purposes of colour matching,
see ISO 3864-4 which provides colorimetric and photometric properties together with, as a
guideline, references from colour order systems.
Add the following safety signs:
— P045: No c
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.