oSIST prEN 1993-5:2023

Eurocode 3 - Design of steel structures - Part 5: Piling

(1) EN 1993-5 provides rules for structural design of bearing piles and sheet piles made of steel.
(2) EN 1993-5 provides rules for the structural design of steel elements for foundations and retaining wall structures constructed using steel piles.
(3) EN 1993-5 is applicable to:
—   steel piled foundations for civil engineering works on land and over water;
—   temporary or permanent structures needed to carry out steel piling work;
—   temporary and permanent retaining structures made of continuous steel piling.
(4) EN1993-5 does not apply to:
—   offshore platforms;
—   dolphins;
—   ground reinforcing elements.
NOTE : Ground reinforcing elements include rock bolts; soil nails; sprayed concrete; wire mesh and facing elements.
(5) EN 1993-5 does not cover the following aspects :
—   geotechnical design;
—    seismic design.
NOTE 1 For geotechnical design refer to EN 1997 (all parts).
NOTE 2 For the effects of ground movement caused by earthquakes refer to EN 1998-5.
(6) EN 1993-5 provides methods for design by calculation and for design assisted by testing.

Eurocode 3 - Bemessung und Konstruktion von Stahlbauten - Teil 5: Pfähle und Spundwände

Eurocode 3 - Calcul des structures en acier - Partie 5: Pieux et palplanches

Evrokod 3 - Projektiranje jeklenih konstrukcij - 5. del: Pilotiranje

General Information

• Status: Not Published
• Public Enquiry End Date: 27-Dec-2023
• ICS: 91.010.30 - Technical aspects
• ICS: 91.080.13 - Steel structures
• Technical Committee: KON - Structures
• Current Stage: 4020 - Public enquire (PE) (Adopted Project)
• Start Date: 09-Oct-2023
• Due Date: 26-Feb-2024
• Directive: 305/2011 - Regulation (eu) No 305/2011 of the European Parliament and of the Council of 9 march 2011 laying down harmonised conditions for the marketing of construction products and repealing council directive 89/106/eec
• Mandate: M/515 - Mandate for amending existing Eurocodes and extending the scope of structural Eurocodes
• Mandate: M/517 - Mandate addressed to CEN, CENELEC and ETSI for the programming and development of Horizontal Service Standards
• Ref Project: prEN 1993-5 - Eurocode 3 - Design of steel structures - Part 5: Piling

Relations

• Replaces: SIST EN 1993-5:2007 - Eurocode 3 - Design of steel structures - Part 5: Piling
• Effective Date: 14-Nov-2018

Standards Content (Sample)

SLOVENSKI STANDARD
oSIST prEN 1993-5:2023
01-december-2023
Nadomešča:
SIST EN 1993-5:2007
Evrokod 3 - Projektiranje jeklenih konstrukcij - 5. del: Pilotiranje
Eurocode 3 - Design of steel structures - Part 5: Piling
Eurocode 3 - Bemessung und Konstruktion von Stahlbauten - Teil 5: Pfähle und
Spundwände
Eurocode 3 - Calcul des structures en acier - Partie 5: Pieux et palplanches
Ta slovenski standard je istoveten z: prEN 1993-5
ICS:
91.010.30 Tehnični vidiki Technical aspects
91.080.13 Jeklene konstrukcije Steel structures
oSIST prEN 1993-5:2023 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------
oSIST prEN 1993-5:2023

---------------------- Page: 2 ----------------------
oSIST prEN 1993-5:2023


DRAFT
EUROPEAN STANDARD
prEN 1993-5
NORME EUROPÉENNE

EUROPÄISCHE NORM

September 2023
ICS Will supersede EN 1993-5:2007
English Version

Eurocode 3 - Design of steel structures - Part 5: Piling
Eurocode 3 - Calcul des structures en acier - Partie 5: Eurocode 3 - Bemessung und Konstruktion von
Pieux et palplanches Stahlbauten - Teil 5: Pfähle und Spundwände
This draft European Standard is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee
CEN/TC 250.

If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations
which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.

This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC
Management Centre has the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Türkiye and
United Kingdom.

Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are
aware and to provide supporting documentation.

Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without
notice and shall not be referred to as a European Standard.


EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2023 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN 1993-5:2023 E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------
oSIST prEN 1993-5:2023
prEN 1993-5:2023 (E)
Contents Page
European foreword . 7
0 Introduction . 8
1 Scope .11
1.1 Scope of EN 1993-5 .11
1.2 Assumptions .11
2 Normative references .12
3 Terms, definitions, symbols .13
3.1 Terms and definitions .13
3.1.1 Terms and definitions for piles .13
3.1.2 Terms and definitions relating to anchors, tension piles and waling .16
3.2 Symbols .22
3.2.1 General .22
3.2.2 Latin upper-case symbols .
...