SIST EN 15376:2008
(Main)Automotive fuels - Ethanol as a blending component for petrol - Requirements and test methods
Automotive fuels - Ethanol as a blending component for petrol - Requirements and test methods
This document specifies requirements and test methods for marketed and delivered ethanol to be used as an extender for automotive fuel for petrol engine vehicles in accordance with the requirements of EN 228.
NOTE 1 For further explanation on blending and applicability see Foreword
NOTE 2 For the purposes of this European Standard, the term "% (m/m)" and "% (V/V)" are used to represent the mass fraction and the volume fraction respectively.
Kraftstoffe für Kraftfahrzeuge - Ethanol zur Verwendung als Blendkomponente in Ottokraftstoff - Anforderungen und Prüfverfahren
Dieses Dokument legt Anforderungen und Prüfverfahren fest für angeliefertes bzw. vermarktetes Ethanol, das als Blendkomponente für Kraftstoffe in Ottomotoren in Übereinstimmung mit den Anforderungen von EN 228 Verwendung findet.
ANMERKUNG 1 Weitere Anmerkungen zu Blendkomponenten für Kraftstoffe und zur Anwendbarkeit sind im Vorwort aufgeführt.
ANMERKUNG 2 Für die Zwecke dieser Europäischen Norm werden „% (m/m)“ und „% (V/V)“ anstelle der Begriffe „Massenanteil in Prozent“ oder „Volumenanteil in Prozent“ verwendet.
Carburants pour automobiles - Ethanol comme base de mélange à l'essence - Exigences et méthodes d'essais
Le présent document prescrit des exigences et des méthodes d’essais pour l’éthanol mis sur le marché et livré
pour etre utilisé comme composant du carburant automobile pour véhicules a moteur a essence conformément
aux exigences de l'EN 228.
NOTE 1 Pour plus d’informations sur le mélange et l’applicabilité, voir l’Avant-propos.
NOTE 2 Dans le cadre de la présente Norme européenne, les expressions "% (m/m)" et "% (V/V)" sont utilisées pour
désigner respectivement les fractions massiques et les fractions volumiques.
Goriva za motorna vozila - Etanol kot komponenta za dodajanje motornemu bencinu - Zahteve in preskusne metode
General Information
Relations
Standards Content (Sample)
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Goriva za motorna vozila - Etanol kot komponenta za dodajanje motornemu bencinu - Zahteve in preskusne metodeKraftstoffe für Kraftfahrzeuge - Ethanol zur Verwendung als Blendkomponente in Ottokraftstoff - Anforderungen und PrüfverfahrenCarburants pour automobiles - Ethanol comme base de mélange à l'essence - Exigences et méthodes d'essaisAutomotive fuels - Ethanol as a blending component for petrol - Requirements and test methods75.160.20Liquid fuels71.080.60Alkoholi. EtriAlcohols. EthersICS:Ta slovenski standard je istoveten z:EN 15376:2007SIST EN 15376:2008en,fr,de01-marec-2008SIST EN 15376:2008SLOVENSKI
STANDARD
SIST EN 15376:2008
EUROPEAN STANDARDNORME EUROPÉENNEEUROPÄISCHE NORMEN 15376December 2007ICS 75.160.20 English VersionAutomotive fuels - Ethanol as a blending component for petrol -Requirements and test methodsCarburants pour automobiles - Ethanol comme base demélange à l'essence - Exigences et méthodes d'essaisKraftstoffe für Kraftfahrzeuge - Ethanol zur Verwendung alsBlendkomponente in Ottokraftstoff - Anforderungen undPrüfverfahrenThis European Standard was approved by CEN on 10 November 2007.CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this EuropeanStandard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such nationalstandards may be obtained on application to the CEN Management Centre or to any CEN member.This European Standard exists in three official versions (English, French, German). A version in any other language made by translationunder the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as theofficial versions.CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.EUROPEAN COMMITTEE FOR STANDARDIZATIONCOMITÉ EUROPÉEN DE NORMALISATIONEUROPÄISCHES KOMITEE FÜR NORMUNGManagement Centre: rue de Stassart, 36
B-1050 Brussels© 2007 CENAll rights of exploitation in any form and by any means reservedworldwide for CEN national Members.Ref. No. EN 15376:2007: ESIST EN 15376:2008
EN 15376:2007 (E) 2 Contents Page Foreword.3 1 Scope.4 2 Normative references.4 3 Sampling.5 4 Requirements and test methods.5 4.1 Dyes and markers.5 4.2 Additives.5 4.3 Denaturing.5 4.4 Generally applicable requirements and related test methods.6 4.5 Climate dependent requirements and related test methods.8 4.6 Precision and dispute.8 Bibliography.9
SIST EN 15376:2008
EN 15376:2007 (E) 3 Foreword This document (EN 15376:2007) has been prepared by Technical Committee CEN/TC 19 “Gaseous and liquid fuels, lubricants and related products of petroleum, synthetic and biological origin”, the secretariat of which is held by NEN. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by June 2008, and conflicting national standards shall be withdrawn at the latest by June 2008. This document has been prepared under mandate M/344 given to CEN by the European Commission and the European Free Trade Association along with other standards intended to be complementary to the regulatory measures contained in various EU Directives [1], [2] and [3]. If bio-ethanol is meant for use as automotive fuel component, this document applies. It is intended to call up this European Standard in EN 228, in order to define the quality of (bio)ethanol which is added/blended to the petrol. Some of the test methods included in this document are the subject of inter-laboratory testing to determine the applicability of the method and its precision in relation to different sources of ethanol. At this moment in time, some precision statements are yet unknown and identified test methods and limits may change in future revisions of this document. According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and the United Kingdom.
SIST EN 15376:2008
EN 15376:2007 (E) 4 1 Scope This document specifies requirements and test methods for marketed and delivered ethanol to be used as an extender for automotive fuel for petrol engine vehicles in accordance with the requirements of EN 228. NOTE 1 This document gives all relevant characteristics, requirements and test methods for (bio)ethanol, which are known at this time to be necessary to define the product to be used up to a maximum 5 % (V/V) blending component for automotive petrol fuel. If the percentage or use is expanded, the requirements need to be restudied. NOTE 2 For the purposes of this document, the term “% (m/m)” and “% (V/V)” are used to represent the mass fraction and the volume fraction respectively. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. EN 228, Automotive fuels — Unleaded petrol — Requirements and test methods EN 15484:2007, Ethanol as a blending component for petrol — Determination of inorganic chloride — Potentiometric method EN 15485:2007, Ethanol as a blending component for petrol — Determination of sulfur content — Wavelength dispersive X-ray fluorescence spectrometric method EN 15486:2007, Ethanol as a blending component for petrol — Determination of sulfur content — Ultraviolet fluorescence method EN 15487:2007, Ethanol as a blending component for petrol — Determination of phosphorus content — Ammonium molybdate spectrometric method EN 15488:2007, Ethanol as a blending component for petrol — Determination of copper content — Graphite furnace atomic absorption spectrometric method EN 15489:2007, Ethanol as a blending component for petrol — Determination of water content — Karl-Fischer coloumetric titration method EN 15491:2007, Ethanol as a blending component for petrol — Determination of total acidity — Colour indicator titration method EN 15492:2007 Ethanol as a blending component for petrol — Determination of inorganic chloride content — Ion chromatographic method EN ISO 3170:2004, Petroleum liquids — Manual sampling (ISO 3170:2004) EN ISO 4259:2006, Petroleum products — Determination and application of precision data in relation to methods of test (ISO 4259:2006) EC/2870/2000 - Method I,
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.