SIST EN 343:2003+A1:2007
(Main)Protective clothing - Protection against rain
Protective clothing - Protection against rain
This European Standard specifies requirements and test methods applicable to materials and seams of protective clothing against the influence of precipitation (e. g. rain, snowflakes), fog and ground humidity.
The testing of rain proofness of ready made garments is excluded in this standard at this time because a separate test method for such a property is currently being prepared.
Schutzkleidung - Schutz gegen Regen
Diese Europäische Norm legt die Anforderungen und Prüfverfahren für Materialien und Nähte von Schutzkleidung gegen den Einfluss von Niederschlag (z. B. Regen, Schneeflocken), Nebel und Bodenfeuchtigkeit fest.
Das Prüfen von wasserdichter Konfektionsbekleidung ist in dieser Norm ausgeschlossen, da zurzeit eine separate Prüfmethode für dieses Merkmal erarbeitet wird.
Vetements de protection - Protection contre la pluie
La présente Norme européenne spécifie les exigences et les méthodes d'essai applicables aux matériaux et aux coutures des vêtements de protection contre les intempéries (par exemple précipitations sous forme de pluie ou neige), brouillard et humidité du sol.
L’essai de résistance à la pluie d’articles de vêtements prêts à porter est exclu de cette norme car une méthode d’essai séparée pour une telle propriété est actuellement en cours de préparation.
Varovalna obleka - Zaščita pred dežjem
General Information
Relations
Standards Content (Sample)
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Protective clothing - Protection against rainVetements de protection - Protection contre la pluieSchutzkleidung - Schutz gegen RegenTa slovenski standard je istoveten z:EN 343:2003+A1:2007SIST EN 343:2003+A1:2007en,fr,de13.340.10Varovalna oblekaProtective clothingICS:SLOVENSKI
STANDARDSIST EN 343:2003+A1:200701-november-2007
EUROPEAN STANDARD NORME EUROPÉENNE EUROPÄISCHE NORM
EN 343:2003+A1
August 2007 ICS 13.340.10 Supersedes EN 343:2003 English Version
Protective clothing - Protection against rain
Vêtements de protection - Protection contre la pluie
Schutzkleidung - Schutz gegen Regen This European Standard was approved by CEN on 2 July 2003 and includes Amendment 1 approved by CEN on 25 July 2007.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN Management Centre or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36
B-1050 Brussels © 2007 CEN All rights of exploitation in any form and by any means reserved worldwide for CEN national Members. Ref. No. EN 343:2003+A1:2007: E
EN 343:2003+A1:2007 (E) 2
Content Page Foreword.3 Introduction.4 1 Scope.5 2 Normative references.5 3 Terms and definitions.6 4 Performance requirements.6 5 Testing requirements.9 6 Sizes.11 7 Marking and care labelling.12 8 Information supplied by the manufacturer.12 Annex A (informative)
Recommendations for wearing time.13 Annex B (informative)
Test device for one-sided exposure to fuel and oil.14 Annex C (informative)
Some examples of textile laminates or thermal liners.15 Annex ZA (informative)
Clauses of this European Standard addressing essential requirements or other provisions of EU Directives.17 Bibliography.18
EN 343:2003+A1:2007 (E) 3 Foreword This document (EN 343:2003+A1:2007) has been prepared by Technical Committee CEN/TC 162 "Protective clothing including hand and arm protection and lifejackets", the secretariat of which is held by DIN. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by February 2008 and conflicting national standards shall be withdrawn at the latest by February 2008. This document includes Amendment 1, approved by CEN on 2007-07-25. This document supersedes !EN 343:2003". The start and finish of text introduced or altered by amendment is indicated in the text by tags ! ". This document has been prepared under a mandate given to CEN by the European Commission and the European Free Trade Association, and supports essential requirements of EU Directive(s). For relationship with EU Directive(s), see informative Annex ZA, which is an integral part of this document. According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EN 343:2003+A1:2007 (E) 4 Introduction In this European Standard the measured properties of materials and seams of protective clothing and their subsequent classification are intended to ensure an adequate protection level. Water proofness and water vapour resistance are the essential properties to be tested and marked on the label. Water proofness is the most important property and it is measured on material of the outer garment layer. Tests are made on new and pretreated fabric samples and on parts with seams. Some waterproof materials are impermeable to water vapour transmission. However other materials on the market combine water proofness with water vapour permeability. This property expressed by low water vapour resistance enhances sweat evaporation and significantly contribute to body cooling. This is valuable, because it contributes to better comfort and less physiological strain and prolongs the wearing time in certain climatic conditions (see annex A).
EN 343:2003+A1:2007 (E) 5
1 Scope This European Standard specifies requirements and test methods applicable to materials and seams of protective clothing against the influence of precipitation (e. g. rain, snowflakes), fog and ground humidity. The testing of rain proofness of ready made garments is excluded in this standard at this time because a separate test method for such a property is currently being prepared. 2 Normative references This European Standard incorporates by dated or undated reference, provisions from other publications. These normative references are cited at the appropriate places in the text and the publications are listed hereafter. For dated references, subsequent amendments to or revisions of any of these publications apply to this European Standard only when incorporated in it by amendment or revision. For undated references the latest edition of the publication referred to applies (including amendments). EN 340, Protective clothing — General requirements EN 388, Protective gloves against mechanical risks EN 530:1994, Abrasion resistance of protective clothing material — Test methods EN 20811, Textiles — Determination of resistance to water penetration — Hydrostatic pressure test EN 31092, Textiles — Determination of physiological properties — Measurement of thermal and water-vapour resistance under steady-state conditions (sweating guarded - hotplate test) (ISO 11092:1993) EN ISO 1421, Rubber- or plastics-coated fabrics — Determination of tensile strength and elongation at break (ISO 1421:1998) EN ISO 7854:1997, Rubber- or plastics-coated fabrics — Determination of resistance to damage by flexing (ISO 7854:1995) !EN ISO 12947-1, Textiles — Determination of the abrasion resistance of fabrics by the Martindale method — Part 1: Martindale abrasion testing apparatus EN ISO 12947-2, Textiles — Determination of the abrasion resistance of fabrics by the Martindale method — Part 2: Determination of specimen breakdown" EN ISO 13934-1, Textiles — Tensile properties of fabrics — Part 1: Determination of maximum force and elongation at maximum force using the strip method (ISO 13934-1:1999) EN ISO 13935-2, Textiles — Tensile properties of fabrics — Part 2: Determination of maximum force using the grab method !(ISO 13935-2:1999)" ISO 1817, Rubber, vulcanized — Determination of the effect of liquids !ISO 4674, Rubber- or plastics-coated fabrics — Determination of tear resistance "
EN 343:2003+A1:2007 (E) 6 3 Terms and definitions For the purposes of this European Standard, the following terms and definitions apply. 3.1 water vapour resistance []WPamRet⋅² water vapour pressure difference between the two faces of a material divided by the resultant evaporative heat flux per unit area in the direction of the gradient. The evaporative heat flux may consist of both diffusive and convective components Water vapour resistance Ret, expressed in square metres pascal per watt, is a quantity specific to textile materials or composites which determines the "latent" evaporative heat flux across a given area in response to a steady applied water vapour pressure gradient. 3.2 water penetration resistance Wp [Pa] hydrostatic pressure supported by a material is a measure of the opposition to the passage of water through the material 3.3 outer shell material outermost material of which the protective clothing is made 3.4 liner insert with a watertight property 3.5 thermal liner layer with a watertight property providing additional thermal insulation 3.6 lining innermost material without watertight property. 4 Performance requirements 4.1 General The ergonomic requirements of EN 340 shall be applied. The components of the garment (see also annex C) are tested in accordance with the following requirements. The application of the single tests to each component is shown in Table 1.
EN 343:2003+A1:2007 (E) 7
Table 1 — Application of performance tests on the components
Property Reference clause Outer shell material Liner or thermal liner Lining
X X
Resistance to water penetration (before and/or after pretreat-ment) 4.1 (in combination if applicable
Water vapour resistance 4.2 X X X
(in combination if applicable) Tensile strength 4.3 X
Tear resistance 4.4 X
X X X Dimensional change 4.5 (in combination if applicable) Seam strength 4.6 X
4.2 Resistance to water penetration When tested in accordance with 5.1, resistance to water penetration of the outer shell material together with any applied watertight layer shall be in accordance with Table 2. If a specimen gets different classes of classification in the different tests for marking in accordance with clause 6, the lowest class shall be indic
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.