SIST EN ISO 15528:2014
(Main)Paints, varnishes and raw materials for paints and varnishes - Sampling (ISO 15528:2013)
Paints, varnishes and raw materials for paints and varnishes - Sampling (ISO 15528:2013)
This International Standard specifies procedures for the sampling of paints, varnishes and raw materials used in their manufacture. Such products include liquids and materials which, without undergoing chemical modification, are capable of being liquefied when heated up, and powdered, granulated and pasty materials. Samples may be taken from containers, e.g. cans, drums, tanks, tank wagons or ships? tanks, as well as from barrels, sacks, big-bags, silos or silo wagons, or from conveyor belts. This International Standard does not deal with the sample preparation for testing or reduction of the samples thus taken. This is dealt with in ISO 1513.
Beschichtungsstoffe und Rohstoffe für Beschichtungsstoffe - Probenahme (ISO 15528:2013)
Diese Internationale Norm legt Verfahren zur Probenahme von Beschichtungsstoffen und Rohstoffen für
Beschichtungsstoffe fest. Eingeschlossen sind Flüssigkeiten und solche Produkte, die sich beim Erhitzen
verflüssigen, ohne sich chemisch zu verändern, und auch pulverisierte, granulierte und pastenförmige
Produkte. Proben dürfen aus Behältern, z. B. Dosen, Trommeln, Tanks, Containern, Kesselwagen oder
Schiffskammern sowie Fässern, Säcken, Big-Bags, Silos oder Silofahrzeugen oder von Förderbändern
genommen werden.
Peintures, vernis et matières premières pour peintures et vernis - Échantillonnage (ISO 15528:2013)
L'ISO 15528:2013 spécifie des modes opératoires pour l'échantillonnage des peintures, des vernis et des matières premières pour peintures et vernis utilisés dans leur fabrication. Ces produits comprennent les produits liquides et les produits qui, sans subir de modification chimique, peuvent se liquéfier lorsqu'ils sont chauffés, ainsi que les produits sous forme de poudre, de granulés ou de pâte. Les échantillons peuvent être prélevés dans des récipients comme par exemple des bidons, des fûts, des réservoirs, des wagons-citernes ou des réservoirs de navire, ainsi que dans des tonneaux, des sacs, des grands sacs, des silos ou des wagons silos, ou sur des bandes transporteuses.
L'ISO 15528:2013 ne traite pas de la préparation des échantillons pour essais ou de la réduction des échantillons ainsi prélevés. Cela est traité dans l'ISO 1513.
Barve, laki ter surovine za barve in lake - Vzorčenje (ISO 15528:2013)
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN ISO 15528:2014
01-april-2014
1DGRPHãþD
SIST EN ISO 15528:2001
%DUYHODNLWHUVXURYLQH]DEDUYHLQODNH9]RUþHQMH ,62
Paints, varnishes and raw materials for paints and varnishes - Sampling (ISO
15528:2013)
Beschichtungsstoffe und Rohstoffe für Beschichtungsstoffe - Probenahme (ISO
15528:2013)
Peintures, vernis et matières premières pour peintures et vernis - Échantillonnage (ISO
15528:2013)
Ta slovenski standard je istoveten z: EN ISO 15528:2013
ICS:
87.040 Barve in laki Paints and varnishes
87.060.01 Sestavine barv na splošno Paint ingredients in general
SIST EN ISO 15528:2014 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN ISO 15528:2014
---------------------- Page: 2 ----------------------
SIST EN ISO 15528:2014
EUROPEAN STANDARD
EN ISO 15528
NORME EUROPÉENNE
EUROPÄISCHE NORM
September 2013
ICS 87.040 Supersedes EN ISO 15528:2000
English Version
Paints, varnishes and raw materials for paints and varnishes -
Sampling (ISO 15528:2013)
Peintures, vernis et matières premières pour peintures et Beschichtungsstoffe und Rohstoffe für Beschichtungsstoffe
vernis - Échantillonnage (ISO 15528:2013) - Probenahme (ISO 15528:2013)
This European Standard was approved by CEN on 17 August 2013.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has the same
status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and United
Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2013 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 15528:2013: E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST EN ISO 15528:2014
EN ISO 15528:2013 (E)
Contents
Page
Foreword .3
2
---------------------- Page: 4 ----------------------
SIST EN ISO 15528:2014
EN ISO 15528:2013 (E)
Foreword
This document (EN ISO 15528:2013) has been prepared by Technical Committee ISO/TC 35 “Paints and
varnishes” of the International Organization for Standardization (ISO) and has been taken over as
EN ISO 15528:2013 by Technical Committee CEN/TC 139 “Paints and varnishes” the secretariat of which is
held by DIN.
This European Standard shall be given the status of a national standard, either by publication of an identical
text or by endorsement, at the latest by March 2014, and conflicting national standards shall be withdrawn at
the latest by March 2014.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. CEN [and/or CENELEC] shall not be held responsible for identifying any or all such patent rights.
This document supersedes EN ISO 15528:2000.
According to the CEN-CENELEC Internal Regulations, the national standards organizations of the following
countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech
Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece,
Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,
Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and the United Kingdom.
Endorsement notice
The text of ISO 15528:2013 has been approved by CEN as EN ISO 15528:2013 without any modification.
3
---------------------- Page: 5 ----------------------
SIST EN ISO 15528:2014
---------------------- Page: 6 ----------------------
SIST EN ISO 15528:2014
INTERNATIONAL ISO
STANDARD 15528
Second edition
2013-09-01
Paints, varnishes and raw materials
for paints and varnishes — Sampling
Peintures, vernis et matières premières pour peintures et vernis —
Échantillonnage
Reference number
ISO 15528:2013(E)
©
ISO 2013
---------------------- Page: 7 ----------------------
SIST EN ISO 15528:2014
ISO 15528:2013(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2013
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2013 – All rights reserved
---------------------- Page: 8 ----------------------
SIST EN ISO 15528:2014
ISO 15528:2013(E)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 General requirements . 2
5 Sampling equipment . 2
5.1 Sampling devices . 2
5.2 Sample containers . 9
6 Sampling procedure . 9
6.1 General . 9
6.2 Pre-sampling inspection .10
6.3 Taking samples from containers .10
6.4 Reduction in sample size .10
6.5 Labelling .10
6.6 Storage .11
6.7 Sampling report .11
Bibliography .12
© ISO 2013 – All rights reserved iii
---------------------- Page: 9 ----------------------
SIST EN ISO 15528:2014
ISO 15528:2013(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular the different approval criteria needed for the
different types of ISO documents should be noted. This document was drafted in accordance with the
editorial rules of the ISO/IEC Directives, Part 2. www.iso.org/directives
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Details of
any patent rights identified during the development of the document will be in the Introduction and/or
on the ISO list of patent declarations received. www.iso.org/patents
Any trade name used in this document is information given for the convenience of users and does not
constitute an endorsement.
The committee responsible for this document is ISO/TC 35, Paints and varnishes, Subcommittee SC 9,
General test methods for paints and varnishes.
This second edition cancels and replaces the first edition (ISO 15528:2000), which has been technically
revised. The main changes are:
a) the detailed information on how to achieve homogeneity of the product to be sampled was removed;
b) the sampling procedure for large containers and small containers was merged;
c) the information on the minimum number of containers to be sampled was removed;
d) definitions for middle sample and all-layer sample were added.
iv © ISO 2013 – All rights reserved
---------------------- Page: 10 ----------------------
SIST EN ISO 15528:2014
ISO 15528:2013(E)
Introduction
Sampling depends on the product and the size of the container but not on the type of product, e.g. paint,
[1]
varnish, binder, pigment, extender or solvent. ISO 1513, specifies both the procedure for preliminary
examination of a single sample as received for testing, and the procedure for preparing a test sample by
blending and reduction of a series of samples representative of a consignment of paint, varnish or related
product. The samples of the product to be tested have been taken in accordance with this document.
Correct sampling forms the basis for the subsequent tests and their results. The various sampling
procedures need to be carried out with great care by operators having the required knowledge and
experience. The general instructions in this International Standard are intended to supplement this
knowledge and experience and are applicable to most situations. However, some products might require
special sampling precautions that are not given in this International Standard; therefore, special
vigilance will be necessary on the part of operators to take note of any unusual characteristics exhibited
by those products. It is also essential that operators adhere to any special precautions in accordance
with product specifications and national safety regulations.
© ISO 2013 – All rights reserved v
---------------------- Page: 11 ----------------------
SIST EN ISO 15528:2014
---------------------- Page: 12 ----------------------
SIST EN ISO 15528:2014
INTERNATIONAL STANDARD ISO 15528:2013(E)
Paints, varnishes and raw materials for paints and
varnishes — Sampling
1 Scope
This International Standard specifies procedures for the sampling of paints, varnishes and raw materials
used in their manufacture. Such products include liquids and materials which, without undergoing
chemical modification, are capable of being liquefied when heated up, and powdered, granulated and
pasty materials. Samples may be taken from containers, e.g. cans, drums, tanks, tank wagons or ships’
tanks, as well as from barrels, sacks, big-bags, silos or silo wagons, or from conveyor belts.
This International Standard does not deal with the sample preparation for testing or reduction of the
[1]
samples thus taken. This is dealt with in ISO 1513.
2 Normative references
The following documents, in whole or in part, are normatively referenced in this document and are
indispensable for its application. For dated references, only the edition cited applies. For undated
references, the latest edition of the referenced document (including any amendments) applies.
ISO 4618, Paints and varnishes — Terms and definitions
ISO 6206, Chemical products for industrial use — Sampling — Vocabulary
3 Terms and definitions
For the purposes of this document, the terms and definitions given in ISO 4618, ISO 6206 and the
following apply.
3.1
batch
definite quantity of a material which was produced under uniform
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.