CEN/TC 23/SC 1/WG 2 - Welded/brazed cylinders excluding cylinders for LPG

This document specifies minimum requirements concerning material, design, construction and workmanship, manufacturing processes and testing of refillable transportable welded carbon steel gas cylinders of water capacities up to and including 150 l for compressed, liquefied and dissolved gases.
For acetylene service, additional requirements for the cylinder and basic requirements for the porous material are given in EN ISO 3807. For cylinder shells for acetylene service manufactured from high frequency induction (HFI) welded steel tubes by spinning of the end, the requirements are given in Annex A.
This document is primarily applicable to industrial gases other than LPG but can also be applied for LPG. However for dedicated LPG cylinders, see EN 1442.

TC

This European Standard specifies minimum requirements concerning material, design, construction and workmanship, procedures and tests at manufacture of refillable transportable welded cylinders made of carbon steel, justified by experimental methods, of water capacities from 0,5 l up to and including 150 l for compressed or liquefied gases and of a test pressure up to 90 bar.
NOTE   This European Standard may also be used as a guideline for cylinders less than 0,5 l water capacity.
This European Standard is primarily intended for industrial gases other than LPG but may also be applied for LPG. However, for dedicated LPG cylinders see EN 14140 [5], prepared by CEN/TC 286.

No scope available

This European Standard gives minimum requirements concerning material, design, construction and workmanship, procedures and tests at manufacture of refillable transportable welded cylinders made of austenitic stainless steel, justified by experimental methods, of water capacities from 0,5 l up to and including 150 l for compressed or liquefied gases and of a test pressure up to 90 bar.
NOTE   This European Standard may also be used as a guideline for cylinders less than 0,5 litres water capacity.
This European Standard is primarily for industrial gases other than LPG but may also be applied for LPG. However for dedicated LPG cylinders, see EN 14140, Transportable refillable welded steel cylinders for liquefied petroleum gas (LPG)  Alternative design and construction prepared by CEN/TC 286 Liquefied petroleum gas equipment and accessories.

This European Standard specifies the minimum requirements for the material, design, construction and workmanship, inspection and testing at manufacture of refillable welded steel pressure drums, hereafter referred to as drums, of volumes of 150 litres up to 1 000 litres for compressed and liquefied gases. Cylindrical and spherical containers are covered.

This European Standard gives minimum requirements for certain aspects concerning material, design, construction and workmanship, procedure and test at manufacture of refillable welded stainless steel gas cylinders of water capacities from 0,5 l up to and including 150 l for compressed and liquefied gases. This standard is only applicable to cylinders with a maximum tensile strength of less than 1100 MPa.

2020-01-20: Originator of XML version: NEN (on behalf of NEN, ASI, DS, SFS, SIS, SN)

This European Standard gives minimum requirements for certain aspects concerning material, design, construction and workmanship, procedure and test at manufacture of refillable welded steel gas cylinders of water capacities from 0,5 l up to and including 150 l for compressed, liquefied or dissolved gases. For acetylene service, additional requirements for the cylinder and the basic requirements for the porous mass.