EN ISO 10239:2014
(Main)Small craft - Liquefied petroleum gas (LPG) systems (ISO 10239:2014)
Small craft - Liquefied petroleum gas (LPG) systems (ISO 10239:2014)
ISO 10239:2014 covers the installation of permanently installed liquefied petroleum gas LPG systems and LPG burning appliances on small craft of up to 24 m length of hull.
It does not cover devices used for LPG-fuelled propulsion engines or LPG-driven generators.
It covers cooking appliances with internal LPG cartridges, with a capacity of 225 g or less (See Annex D).
It covers storage of all LPG cylinders but is not intended to regulate the technical requirements for such cylinders that are subject to national regulations
It does not contain procedures for commissioning the LPG installation.
Kleine Wasserfahrzeuge - Flüssiggas-Anlagen (LPG) (ISO 10239:2014)
Petits navires - Installations alimentées en gaz de pétrole liquéfiés (GPL) (ISO 10239:2014)
L'ISO 10239:2014 couvre l'installation des systèmes alimentées en gaz de pétrole liquéfié (GPL) installés à demeure et les appareils brûlant du GPL installés sur les petits navires d'une longueur de coque inférieure ou égale à 24 m.
Elle ne couvre pas les dispositifs utilisés pour les moteurs de propulsion alimentés en GPL ou les générateurs alimentés au GPL.
Elle couvre les appareils comportant des cartouches de GPL d'une capacité inférieure ou égale à 225 g.
Elle couvre le stockage de toutes les bouteilles de GPL mais n'est pas destinée à réglementer les exigences techniques des bouteilles de GPL, soumises aux réglementations nationales.
Elle ne comprend pas de procédures de mise en service des installations au GPL.
Mala plovila - Sistemi za utekočinjeni naftni plin (LPG) (ISO 10239:2014)
Ta mednarodni standard zajema namestitev trajno nameščenih sistemov za utekočinjeni naftni plin (LPG) in aparatov na utekočinjeni naftni plin na malih plovilih z dolžino trupa do 24 m. Ne zajema naprav, ki se uporabljajo v pogonskih motorjih na utekočinjeni naftni plin ali generatorjih na utekočinjeni naftni plin. Ta mednarodni standard zajema aparate za pripravo hrane z notranjimi kartušami z utekočinjenim naftnim plinom s prostornino
225 g ali manj (glej dodatek D). Zajema shranjevanje vseh jeklenk za utekočinjeni naftni plin, ni pa namenjen urejanju tehničnih zahtev za take jeklenke, za katere veljajo nacionalni predpisi. Ne vsebuje postopkov za začetek obratovanja inštalacije za utekočinjeni naftni plin. OPOMBA Za nove oblike, materiale in metode sestavljanja, ki zagotavljajo vsaj enakovredne rezultate, se lahko šteje, da izpolnjujejo zahteve tega mednarodnega standarda, ko jih odobri ustrezni organ.
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
01-marec-2015
1DGRPHãþD
SIST EN ISO 10239:2008
0DODSORYLOD6LVWHPL]DXWHNRþLQMHQLQDIWQLSOLQ /3* ,62
Small craft - Liquefied petroleum gas (LPG) systems (ISO 10239:2014)
Kleine Wasserfahrzeuge - Flüssiggas-Anlagen (LPG) (ISO 10239:2014)
Petits navires - Installations alimentées en gaz de pétrole liquéfiés (GPL) (ISO
10239:2014)
Ta slovenski standard je istoveten z: EN ISO 10239:2014
ICS:
47.080 ýROQL Small craft
75.160.30 Plinska goriva Gaseous fuels
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
EUROPEAN STANDARD
EN ISO 10239
NORME EUROPÉENNE
EUROPÄISCHE NORM
December 2014
ICS 47.080 Supersedes EN ISO 10239:2008
English Version
Small craft - Liquefied petroleum gas (LPG) systems (ISO
10239:2014)
Petits navires - Installations alimentées en gaz de pétrole Kleine Wasserfahrzeuge - Flüssiggas-Anlagen (LPG) (ISO
liquéfiés (GPL) (ISO 10239:2014) 10239:2014)
This European Standard was approved by CEN on 13 September 2014.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has the same
status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and United
Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2014 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 10239:2014 E
worldwide for CEN national Members.
Contents Page
Foreword .3
Annex ZA (informative) Relationship between this European Standard and the Essential
Requirements of EU Directive 94/25/EC as amended by Directive 2003/44/EC .4
Foreword
This document (EN ISO 10239:2014) has been prepared by Technical Committee ISO/TC 188 “Small craft”
This European Standard shall be given the status of a national standard, either by publication of an identical
text or by endorsement, at the latest by June 2015, and conflicting national standards shall be withdrawn at
the latest by December 2015.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. CEN [and/or CENELEC] shall not be held responsible for identifying any or all such patent rights.
This document supersedes EN ISO 10239:2008.
This document has been prepared under a mandate given to CEN by the European Commission and the
European Free Trade Association, and supports essential requirements of EU Directive.
For relationship with EU Directive, see informative Annex ZA, which is an integral part of this document.
According to the CEN-CENELEC Internal Regulations, the national standards organizations of the following
countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech
Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece,
Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,
Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and the United Kingdom.
Endorsement notice
The text of ISO 10239:2014 has been approved by CEN as EN ISO 10239:2014 without any modification.
Annex ZA
(informative)
Relationship between this European Standard
and the Essential Requirements of
EU Directive 94/25/EC as amended by Directive 2003/44/EC
This European standard has been prepared under a mandate given to CEN by the European Commission to
provide one means of conforming to Essential Requirements of the New Approach Directive 94/25/EC as
amended by Directive 2003/44/EC.
Once this standard is cited in the Official Journal of the European Communities under that Directive and has
been implemented as a national standard in at least one member state, compliance with the normative
clauses of this standard given in Table ZA.1 confers, within the limits of the scope of this standard, a
presumption of conformity with the relevant Essential Requirements of that Directive and associated EFTA
regulations.
Table ZA.1 - Correspondence between this European Standard and Directive 94/25/EC as amended by
Directive 2003/44/EC
Clauses/sub-clauses of this Corresponding annexes/ Comments
European Standard Paragraphs of Directive
94/25/EC as amended by
Directive 2003/44/EC
4.2 Annex IA 5.5 Gas system
Gas systems for domestic use
shall be ‘vapour-withdrawal’ type
4, 5, 6, 7, 8, 11 Designed and installed to avoid Annex D applies in respect of
leaks and risk of explosion cooking appliances with integral
LPG cartridges with a capacity of
225 g or less
4.5, 10, Annex C.3 Capable of being tested for leaks The use of a pressure gauge in
the high pressure side of the
system will not detect cylinder
valve ‘let by’ or ’creep’ which, if
suspected, should be tested for
separately.
6.1.1, 6.2.1, 6.2.4, 6.3.1, 6.4, Materials and components shall
6.5.8, 7.1 be suitable for the specific gas
used
4.1, 5.6, 5.7, 6.1.2, 6.2.1, 6.2.3, Materials and components to
6.2.5, 6.4, 6.5.1, 6.5.4, 6.5.5, withstand the stresses and
6.5.7, 7.1, 7.2, 8.1 exposures found in the marine
environment
7.3 Flame failure device effective on
all burners
6.6 Each gas-consuming appliance
must be supplied by a separate
branch of the distribution system,
and each appliance must be
controlled by a separate closing
device
Clauses/sub-clauses of this Corresponding annexes/ Comments
European Standard Paragraphs of Directive
94/25/EC as amended by
Directive 2003/44/EC
5.2, 6.6.2, 8 Adequate ventilation to prevent
hazards from leaks
7.4, 7.6, 9, 13, Adequate ventilation to prevent
hazards from products of
Annex B
combustion
4.3, 4.4, 8.1 An enclosure shall contain all gas
cylinders permanently installed.
8 The enclosure containing all gas
cylinders shall be:
• separated from the
living quarters,
• accessible only from the
outside, and
• ventilated to the outside
so that any escaping
gas drains overboard.
10 Gas system(s) shall be tested
after installation
Annex IA 5.6.1 Fire protection,
6.2.2, 6.2.3, 6.5.2, 6.5.3, 7.3, 7.7, Annex D applies in respect of
7.9, 11, 13.6 general cooking appliances with integral
LPG cartridges with a capacity of
225 g or less
4.4, 7.5, 12, Annex C Annex IA 2.5 Owner’s manual Annex D applies in respect of
cooking appliances with integral
LPG cartridges with a capacity of
225 g or less
WARNING: Other requirements and other EU Directives may be applicable to the product(s) falling within the
scope of this standard.
INTERNATIONAL ISO
STANDARD 10239
Third edition
2014-12-01
Small craft — Liquefied petroleum gas
(LPG) systems
Petits navires — Installations alimentées en gaz de pétrole
liquéfiés (GPL)
Reference number
ISO 10239:2014(E)
©
ISO 2014
ISO 10239:2014(E)
© ISO 2014
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2014 – All rights reserved
ISO 10239:2014(E)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 2
4 General provisions. 3
5 Pressure regulation device . 4
6 LPG supply line . 5
6.1 General . 5
6.2 Piping . 5
6.3 Hoses and hose lines . 6
6.4 Materials . 6
6.5 Installation . 6
6.6 Shut-off valves . 7
7 Appliances . 8
8 Location and installation of LPG cylinders. 9
9 Ventilation . 9
10 LPG installation tightness tests .10
11 Ignition protection from electrical devices .10
12 Owner’s manual.10
13 Ducts and flues for air intake and combustion product discharge .10
Annex A (informative) Design guidelines for pressure drop due to pipe resistance .12
Annex B (normative) Ventilation.13
Annex C (normative) Instructions to be included with the owner’s manual .14
Annex D (normative) Cooking appliances with integral LPG cartridges with a capacity of
225 g or less .16
Bibliography .
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.