Cycles - Safety requirements for bicycles for young children (ISO 8098:2023, Corrected version 2023-08)

This document specifies safety and performance requirements and test methods for the design, assembly and testing of fully assembled bicycles and sub-assemblies for young children. It also provides guidelines for instructions on the use and care of the bicycles.
This document is applicable to bicycles with a maximum saddle height of more than 435 mm and less than 635 mm, propelled by a transmitted drive to the rear wheel.
It is not applicable to special bicycles intended for performing stunts (e.g. BMX bicycles).
NOTE      For bicycles with a maximum saddle height of 435 mm or less, see national regulations for ride-on toys, and with a maximum saddle height of 635 mm or more, see ISO 4210-1 to ISO 4210-9.

Fahrräder - Sicherheitstechnische Anforderungen an Kinderfahrräder (ISO 8098:2023, korrigierte Fassung 2023-08)

Dieses Dokument legt sicherheitstechnische Anforderungen und Leistungsanforderungen sowie Prüfverfah¬ren hinsichtlich der konstruktiven Ausführung, Montage und Prüfung von vollständig zusammengebauten Kinderfahrrädern und deren Baugruppen fest. Gleichfalls wird eine Leitlinie für die Anleitungen zur Benut¬zung und Pflege der Fahrräder bereitgestellt.
Dieses Dokument ist anwendbar für Fahrräder, deren maximale Sattelhöhe mehr als 435 mm und weniger als 635 mm beträgt und die durch Kraftübertragung auf das Hinterrad angetrieben werden.
Dieses Dokument ist anwendbar nicht für spezielle Fahrräder, die für Trickfahrten bestimmt sind (z. B. BMX Fahrräder).
ANMERKUNG   Bei Fahrrädern mit einer maximalen Sattelhöhe von 435 mm oder weniger siehe die nationalen Vorschriften für Fahrspielzeuge und bei Fahrrädern mit einer maximalen Sattelhöhe von 635 mm oder mehr siehe ISO 4210 1 bis ISO 4210 9 [5] bis [13].

Cycles - Exigences de sécurité pour les bicyclettes pour jeunes enfants (ISO 8098:2023, Version corrigée 2023-08)

Le présent document spécifie les méthodes d'essai et les exigences de sécurité et de performance à observer lors de la conception, de l’assemblage et des essais des bicyclettes pour jeunes enfants et de leurs sous-ensembles, et précise les lignes directrices concernant l'utilisation et l'entretien de celles-ci.
Le présent document est applicable aux bicyclettes qui ont une hauteur maximale de selle comprise entre 435 mm et 635 mm et qui sont propulsées par une force transmise à la roue arrière.
La présente norme ne s'applique pas aux bicyclettes spéciales prévues pour effectuer des acrobaties (p. ex., les bicyclettes BMX).
NOTE       Pour les bicyclettes dont la hauteur maximale de la selle est inférieure ou égale à 435 mm, voir les réglementations nationales relatives aux jouets à enfourcher, et pour celles dont la hauteur maximale de la selle est supérieure ou égale à 635 mm, voir l'ISO 4210‑1 à ISO 4210‑9.

Kolesa - Varnostne zahteve za kolesa za mlajše otroke (ISO 8098:2023)

Ta dokument določa varnostne in tehnične zahteve ter preskusne metode za zasnovo, sestavo in preskušanje sestavljenih koles in njihovih podsestavov za mlajše otroke. Podaja tudi smernice za navodila za uporabo in nego koles.
Ta dokument se uporablja za kolesa z maksimalno višino sedeža najmanj 435 mm in največ 635 mm ter z verižnim prenosom vrtenja na zadnje kolo.
Ne velja za posebna kolesa, namenjena za izvajanje trikov (npr. kolesa BMX).
OPOMBA:   Za kolesa z maksimalno višino sedeža 435 mm ali manj glej nacionalne predpise za otroška igralna vozila, za kolesa z maksimalno višino sedeža največ 635 mm pa glej standarde od ISO 4210-1 do ISO 4210-9.

General Information

Status
Published
Publication Date
17-Jan-2023
Technical Committee
Drafting Committee
Current Stage
6060 - Definitive text made available (DAV) - Publishing
Start Date
18-Jan-2023
Completion Date
18-Jan-2023

Relations

Buy Standard

Standard
EN ISO 8098:2023
English language
51 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day
Draft
prEN ISO 8098:2022
English language
52 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN ISO 8098:2023
01-maj-2023
Nadomešča:
SIST EN ISO 8098:2014
Kolesa - Varnostne zahteve za kolesa za mlajše otroke (ISO 8098:2023)
Cycles - Safety requirements for bicycles for young children (ISO 8098:2023)
Fahrräder - Sicherheitstechnische Anforderungen an Kinderfahrräder (ISO 8098:2023)
Cycles - Exigences de sécurité pour les bicyclettes pour jeunes enfants(ISO 8098:2023)
Ta slovenski standard je istoveten z: EN ISO 8098:2023
ICS:
43.150 Kolesa Cycles
97.190 Otroška oprema Equipment for children
SIST EN ISO 8098:2023 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------
SIST EN ISO 8098:2023

---------------------- Page: 2 ----------------------
SIST EN ISO 8098:2023


EN ISO 8098
EUROPEAN STANDARD

NORME EUROPÉENNE

January 2023
EUROPÄISCHE NORM
ICS 43.150; 97.190 Supersedes EN ISO 8098:2014
English Version

Cycles - Safety requirements for bicycles for young
children (ISO 8098:2023)
Cycles - Exigences de sécurité pour les bicyclettes pour Fahrräder - Sicherheitstechnische Anforderungen an
jeunes enfants(ISO 8098:2023) Kinderfahrräder (ISO 8098:2023)
This European Standard was approved by CEN on 30 December 2022.

CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this
European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references
concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN
member.

This European Standard exists in three official versions (English, French, German). A version in any other language made by
translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Türkiye and
United Kingdom.





EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2023 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 8098:2023 E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------
SIST EN ISO 8098:2023
EN ISO 8098:2023 (E)
Contents Page
European foreword . 3

2

---------------------- Page: 4 ----------------------
SIST EN ISO 8098:2023
EN ISO 8098:2023 (E)
European foreword
This document (EN ISO 8098:2023) has been prepared by Technical Committee ISO/TC 149 "Cycles" in
collaboration with Technical Committee CEN/TC 333 “Cycles” the secretariat of which is held by UNI.
This European Standard shall be given the status of a national standard, either by publication of an
identical text or by endorsement, at the latest by July 2023, and conflicting national standards shall be
withdrawn at the latest by July 2023.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CEN shall not be held responsible for identifying any or all such patent rights.
This document supersedes EN ISO 8098:2014.
Any feedback and questions on this document should be directed to the users’ national standards
body/national committee. A complete listing of these bodies can be found on the CEN website.
According to the CEN-CENELEC Internal Regulations, the national standards organizations of the
following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria,
Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland,
Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Republic of
North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Türkiye and the
United Kingdom.
Endorsement notice
The text of ISO 8098:2023 has been approved by CEN as EN ISO 8098:2023 without any modification.

3

---------------------- Page: 5 ----------------------
SIST EN ISO 8098:2023

---------------------- Page: 6 ----------------------
SIST EN ISO 8098:2023
INTERNATIONAL ISO
STANDARD 8098
Fourth edition
2023-01
Cycles — Safety requirements for
bicycles for young children
Cycles — Exigences de sécurité pour les bicyclettes pour je
...

SLOVENSKI STANDARD
oSIST prEN ISO 8098:2022
01-januar-2022
Kolesa - Varnostne zahteve za kolesa za mlajše otroke (ISO/DIS 8098:2021)
Cycles - Safety requirements for bicycles for young children (ISO/DIS 8098:2021)
Fahrräder - Sicherheitstechnische Anforderungen an Kinderfahrräder (ISO/DIS
8098:2021)
Cycles - Exigences de sécurité relatives aux bicyclettes pour jeunes enfants (ISO/DIS
8098:2021)
Ta slovenski standard je istoveten z: prEN ISO 8098
ICS:
43.150 Kolesa Cycles
97.190 Otroška oprema Equipment for children
oSIST prEN ISO 8098:2022 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------
oSIST prEN ISO 8098:2022

---------------------- Page: 2 ----------------------
oSIST prEN ISO 8098:2022
DRAFT INTERNATIONAL STANDARD
ISO/DIS 8098
ISO/TC 149/SC 1 Secretariat: JISC
Voting begins on: Voting terminates on:
2021-11-08 2022-01-31
Cycles — Safety requirements for bicycles for young
children
Cycles — Exigences de sécurité relatives aux bicyclettes pour jeunes enfants
ICS: 43.150; 97.190
THIS DOCUMENT IS A DRAFT CIRCULATED
This document is circulated as received from the committee secretariat.
FOR COMMENT AND APPROVAL. IT IS
THEREFORE SUBJECT TO CHANGE AND MAY
NOT BE REFERRED TO AS AN INTERNATIONAL
STANDARD UNTIL PUBLISHED AS SUCH.
IN ADDITION TO THEIR EVALUATION AS
ISO/CEN PARALLEL PROCESSING
BEING ACCEPTABLE FOR INDUSTRIAL,
TECHNOLOGICAL, COMMERCIAL AND
USER PURPOSES, DRAFT INTERNATIONAL
STANDARDS MAY ON OCCASION HAVE TO
BE CONSIDERED IN THE LIGHT OF THEIR
POTENTIAL TO BECOME STANDARDS TO
WHICH REFERENCE MAY BE MADE IN
Reference number
NATIONAL REGULATIONS.
ISO/DIS 8098:2021(E)
RECIPIENTS OF THIS DRAFT ARE INVITED
TO SUBMIT, WITH THEIR COMMENTS,
NOTIFICATION OF ANY RELEVANT PATENT
RIGHTS OF WHICH THEY ARE AWARE AND TO
©
PROVIDE SUPPORTING DOCUMENTATION. ISO 2021

---------------------- Page: 3 ----------------------
oSIST prEN ISO 8098:2022
ISO/DIS 8098:2021(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2021
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting
on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address
below or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Email: copyright@iso.org
Website: www.iso.org
Published in Switzerland
ii © ISO 2021 – All rights reserved

---------------------- Page: 4 ----------------------
oSIST prEN ISO 8098:2022
ISO/DIS 8098:2021(E)

Contents Page
Foreword .v
Introduction .vi
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Requirements and test methods . 3
4.1 Brake tests and strength tests — Special requirements . 3
4.1.1 Definition of brake tests . 3
4.1.2 Definition of strength tests . 3
4.1.3 Numbers and condition of specimens for the strength tests . 3
4.1.4 Tolerances . 3
4.1.5 Fatig
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.