EN ISO 16000-15:2008
(Main)Indoor air - Part 15: Sampling strategy for nitrogen dioxide (NO2) (ISO 16000-15:2008)
Indoor air - Part 15: Sampling strategy for nitrogen dioxide (NO2) (ISO 16000-15:2008)
ISO 16000-15:2008 specifies the planning of nitrogen dioxide indoor pollution measurements. In the case of indoor air measurements, the careful planning of sampling and the entire measurement strategy are of particular significance since the result of the measurement may have far-reaching consequences, for example, with regard to ascertaining the need for remedial action or the success of such an action.
An inappropriate measurement strategy may lead to misrepresentation of the true conditions or, worse, to erroneous results.
Innenraumluftverunreinigungen - Teil 15: Probenahmestrategie für Stickstoffdioxid (NO2) (ISO 16000-15:2008)
Dieser Teil der ISO 16000 legt die Planung von Messungen von Stickstoffdioxid als Innenraumluftschadstoff fest. Die sorgfältige Planung der Probenahme und der gesamten Messstrategie sind bei Innenraum-luftuntersuchungen von besonderer Tragweite, da das Untersuchungsergebnis erhebliche Konsequenzen haben kann, so z. B. hinsichtlich eines Sanierungsbedarfs oder des Erfolgs einer Sanierung.
Eine ungeeignete Messstrategie kann zu einer erheblichen Gesamtunsicherheit oder sogar zu fehlerhaften Messergebnissen beitragen.
Air intérieur - Partie 15: Stratégie d'échantillonnage du dioxyde d'azote (NO2) (ISO 16000-15:2008)
L'ISO 16000-15:2008 spécifie la planification des mesurages de la pollution de l'air intérieur par du dioxyde d'azote. Dans le cas des mesurages relatifs à l'air intérieur, la planification minutieuse de l'échantillonnage et l'ensemble de la stratégie de mesurage sont d'une importance particulière car le résultat du mesurage peut avoir des conséquences de grande portée, par exemple en ce qui concerne la détermination de la nécessité de mesures correctives ou le succès de telles mesures.
Une stratégie de mesurage inadéquate peut conduire à une mauvaise interprétation des conditions réelles ou, pire, à des résultats erronés.
Notranji zrak - 15. del: Strategija vzorčenja za dušikov dioksid (NO2) (ISO 16000-15:2008)
General Information
Standards Content (Sample)
SLOVENSKI STANDARD
01-marec-2009
1RWUDQML]UDNGHO6WUDWHJLMDY]RUþHQMD]DGXãLNRYGLRNVLG12,62
Indoor air - Part 15: Sampling strategy for nitrogen dioxide (NO2) (ISO 16000-15:2008)
Innenraumluftverunreinigungen - Teil 15: Probenahmestrategie für Stickstoffdioxid (NO2)
(ISO 16000-15:2008)
Air intérieur - Partie 15: Stratégie d'échantillonnage du dioxyde d'azote (NO2) (ISO
16000-15:2008)
Ta slovenski standard je istoveten z: EN ISO 16000-15:2008
ICS:
13.040.20 Kakovost okoljskega zraka Ambient atmospheres
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
EUROPEAN STANDARD
EN ISO 16000-15
NORME EUROPÉENNE
EUROPÄISCHE NORM
July 2008
ICS 13.040.20
English Version
Indoor air - Part 15: Sampling strategy for nitrogen dioxide
(NO2) (ISO 16000-15:2008)
Air intérieur - Partie 15: Stratégie d'échantillonnage du Innenraumluftverunreinigungen - Teil 15:
dioxyde d'azote (NO2) (ISO 16000-15:2008) Probenahmestrategie für Stickstoffdioxid (NO2) (ISO
16000-15:2008)
This European Standard was approved by CEN on 11 July 2008.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the CEN Management Centre or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as the
official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,
France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,
Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36 B-1050 Brussels
© 2008 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 16000-15:2008: E
worldwide for CEN national Members.
Contents Page
Foreword.3
Foreword
This document (EN ISO 16000-15:2008) has been prepared by Technical Committee ISO/TC 146 "Air quality"
in collaboration with Technical Committee CEN/TC 264 “Air quality” the secretariat of which is held by DIN.
This European Standard shall be given the status of a national standard, either by publication of an identical
text or by endorsement, at the latest by January 2009, and conflicting national standards shall be withdrawn at
the latest by January 2009.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. CEN [and/or CENELEC] shall not be held responsible for identifying any or all such patent rights.
According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following
countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Cyprus, Czech
Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia,
Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain,
Sweden, Switzerland and the United Kingdom.
Endorsement notice
The text of ISO 16000-15:2008 has been approved by CEN as a EN ISO 16000-15:2008 without any
modification.
INTERNATIONAL ISO
STANDARD 16000-15
First edition
2008-07-15
Indoor air —
Part 15:
Sampling strategy for nitrogen dioxide
(NO )
Air intérieur —
Partie 15: Stratégie d'échantillonnage du dioxyde d'azote (NO )
Reference number
ISO 16000-15:2008(E)
©
ISO 2008
ISO 16000-15:2008(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but
shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In
the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.
© ISO 2008
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2008 – All rights reserved
ISO 16000-15:2008(E)
Contents Page
Foreword. iv
Introduction . vi
1 Scope .1
2 Normative references .1
3 Properties, origin and occurrence of nitrogen dioxide.1
4 Regulations .2
5 Measurement technique.3
5.1 General.3
5.2 Short-term measurements .3
5.3 Long-term measurements.3
5.4 Pre-testing .4
6 Measurement planning.4
6.1 General.4
6.2 Measurement objective and boundary conditions.4
6.3 Measurement time .6
6.4 Sampling period and measurement frequency .6
6.5 Measurement location.7
6.6 Measurement uncertainty and presentation of result.7
6.7 Quality assurance.7
Annex A (informative) Information on diffusive samplers .9
Annex B (informative) Examples of screening tests .10
Bibliography .11
ISO 16000-15:2008(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies
(ISO member bodies). The work of preparing International Standards is normally carried out through ISO
technical committees. Each member body interested in a subject for which a technical committee has been
established has the right to be represented on that committee. International organizations, governmental and
non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the
International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
The main task of technical committees is to prepare International Standards. Draft International Standards
adopted by the technical committees are circulated to the member bodies for voting. Publication as an
International Standard requires approval by at least 75 % of the member bodies casting a vote.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. ISO shall not be held responsible for identifying any or all such patent rights.
ISO 16000-15 was prepared by Technical Committee ISO/TC 146, Air quality, Subcommittee SC 6, Indoor air.
ISO 16000 consists of the following parts, under the general title Indoor air :
⎯ Part 1: General aspects of sampling strategy
⎯ Part 2: Sampling strategy for formaldehyde
⎯ Part 3: Determination of formaldehyde and other carbonyl compounds — Active sampling method
⎯ Part 4: Determination of formaldehyde — Diffusive sampling method
⎯ Part 5: Sampling strategy for volatile organic compounds (VOCs)
⎯ Part 6: Determination of volatile organic compounds in indoor and test chamber air by active sampling on ®
Tenax TA sorbent, thermal desorption and gas chromatography using MS/FID
⎯ Part 7: Sampling strategy for determination of airborne asbestos fibre concentrations
⎯ Part 8: Determination of local mean ages of air in buildings for characterizing ventilation conditions
⎯ Part 9: Determination of the emission of volatile organic compounds from building products and
furnishing — Emission test chamber method
⎯ Part 10: Determination of the emission of volatile organic compounds from building products and
furnishing — Emission test cell method
⎯ Part 11: Determination of the emission of volatile organic compounds from building products and
furnishing — Sampling, storage of samples and preparation of test specimens
⎯ Part 12: Sampling strategy for polychlorinated biphenyls (PCBs), polychlorinated dibenzo-p-dioxins
(PCDDs), polychlorinated dibenzofurans (PCDFs) and polycyclic aromatic hydrocarbons (PAHs)
⎯ Part 13: Determination of total (gas and particle-phase) polychlorinated dioxin-like biphenyls (PCBs) and
polychlorinated dibenzo-p-dioxins/dibenzofurans (PCDDs/PCDFs) — Collection on sorbent-backed filters
iv © ISO 2008 – All rights reserved
ISO 16000-15:2008(E)
⎯ Part 14: Determination of total (gas and particle-phase) polychlorinated dioxin-like biphenyls (PCBs) and
polychlorinated dibenzo-p-dioxins/dibenzofurans (PCDDs/PCDFs) — Extraction, clean-up and analysis by
high-resolution gas chromatography/mass spectrometry
⎯ Part 15: Sampling strategy for nitrogen dioxide (NO )
⎯ Part 16: Detection and enumeration of moulds — Sampling by filtration
⎯ Part 17: Detection and enumeration of moulds — Culture-based method
⎯ Part 23: Performance test for evaluating the reduction of formaldehyde concentrations by sorptive
building materials
The following parts are under preparation:
⎯ Part 18: Detection and enumeration of moulds — Sampling by impaction
⎯ Part 19: Sampling strategy for moulds
⎯ Part 24: Performance test for evaluating the reduction of the concentrations of volatile organic
compounds and carbonyl compounds without formaldehyde concentrations by sorptive building materials
⎯ Part 25: Determination of the emission of semi-volatile organic compounds by building products — Micro-
chamber method
⎯ Part 28: Sensory evaluation of emissions from building materials and products
The following parts are planned:
⎯ Part 20: Detection and enumeration of moulds — Sampling from house dust
⎯ Part 21: Detection and enumeration of moulds — Sampling from materials
⎯ Part 22: Detection and enumeration of moulds — Molecular methods
⎯ Part 27: Standard method for the quantitative analysis of asbestos fibres in settled dust
Furthermore,
1)
⎯ ISO 12219-1 , Indoor air — Road vehicles — Part 1: Whole vehicle test chamber — Specification and
method for the determination of volatile organic compounds in car interiors, and
[44]
⎯ the two International Standards for indoor air, ambient air and workplace atmosphere, ISO 16017-1 on
[45]
pumped sampling and ISO 16017-2 on diffusive sampling
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.