EN IEC 61280-1-3:2021
(Main)Fibre optic communication subsystem test procedures - Part 1-3: General communication subsystems - Measurement of central wavelength, spectral width and additional spectral characteristics
Fibre optic communication subsystem test procedures - Part 1-3: General communication subsystems - Measurement of central wavelength, spectral width and additional spectral characteristics
This part of IEC 61280 provides definitions and measurement procedures for several wavelength and spectral width properties of an optical spectrum associated with a fibre optic communication subsystem, an optical transmitter, or other light sources used in the operation or test of communication subsystems. This document also provides definitions and measurement procedures for side mode suppression ratio and signal to source spontaneous emission ratio. The measurement is done for the purpose of system construction and/or maintenance. In the case of communication subsystem signals, the optical transmitter is typically under modulation. NOTE Different properties may be appropriate to different spectral types, such as continuous spectra characteristic of light-emitting diodes (LEDs), and multilongitudinal-mode (MLM), multitransverse-mode (MTM) and single-longitudinal mode (SLM) spectra, characteristic of laser diodes (LDs).
Prüfverfahren für Lichtwellenleiter-Kommunikationsuntersysteme - Teil 1-3: Allgemeine Kommunikationsuntersysteme - Messung von Mittenwellenlänge, Spektralbreite und weiteren Spektralkennwerten
Procédures d’essai des sous-systèmes de télécommunication à fibres optiques - Partie 1-3: Sous-systèmes généraux de télécommunication - Mesure de la longueur d'onde centrale, de la largeur spectrale et des caractéristiques spectrales supplémentaires
IEC 61280-1-3:2021 est disponible sous forme de IEC 61280-1-3:2021 RLV qui contient la Norme internationale et sa version Redline, illustrant les modifications du contenu technique depuis l'édition précédente.
Postopki preskušanja optičnega komunikacijskega podsistema - 1-3. del: Splošni komunikacijski podsistemi - Merjenje osrednje valovne dolžine, spektralne širine in dodatnih spektralnih značilnosti (IEC 61280-1-3:2021)
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
01-november-2021
Nadomešča:
SIST EN 61280-1-3:2010
Postopki preskušanja optičnega komunikacijskega podsistema - 1-3. del: Splošni
komunikacijski podsistemi - Merjenje osrednje valovne dolžine, spektralne širine
in dodatnih spektralnih značilnosti (IEC 61280-1-3:2021)
Fibre optic communication subsystem test procedures - Part 1-3: General
communication subsystems - Measurement of central wavelength, spectral width and
additional spectral characteristics (IEC 61280-1-3:2021)
Lichtwellenleiter-Kommunikationsuntersysteme - Grundlegende Prüfverfahren - Teil 1-3:
Prüfverfahren für allgemeine Kommunikationsuntersysteme - Messung von
Mittelwellenlänge und Spektralbreite (IEC 61280-1-3:2021)
Procédures d’essai des sous-systèmes de télécommunication à fibres optiques - Partie 1
-3: Sous-systèmes généraux de télécommunication - Mesure de la longueur d'onde
centrale, de la largeur spectrale et des caractéristiques spectrales supplémentaires (IEC
61280-1-3:2021)
Ta slovenski standard je istoveten z: EN IEC 61280-1-3:2021
ICS:
33.180.01 Sistemi z optičnimi vlakni na Fibre optic systems in
splošno general
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
EUROPEAN STANDARD EN IEC 61280-1-3
NORME EUROPÉENNE
EUROPÄISCHE NORM
August 2021
ICS 33.180.01 Supersedes EN 61280-1-3:2010 and all of its
amendments and corrigenda (if any)
English Version
Fibre optic communication subsystem test procedures - Part 1-3:
General communication subsystems - Measurement of central
wavelength, spectral width and additional spectral characteristics
(IEC 61280-1-3:2021)
Procédures d'essai des sous-systèmes de Lichtwellenleiter-Kommunikationsuntersysteme -
télécommunication à fibres optiques - Partie 1-3: Sous- Grundlegende Prüfverfahren - Teil 1-3: Prüfverfahren für
systèmes généraux de télécommunication - Mesure de la allgemeine Kommunikationsuntersysteme - Messung von
longueur d'onde centrale, de la largeur spectrale et des Mittelwellenlänge und Spektralbreite
caractéristiques spectrales supplémentaires (IEC 61280-1-3:2021)
(IEC 61280-1-3:2021)
This European Standard was approved by CENELEC on 2021-08-09. CENELEC members are bound to comply with the CEN/CENELEC
Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC
Management Centre or to any CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CENELEC member into its own language and notified to the CEN-CENELEC Management Centre has the
same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus, the Czech Republic,
Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the
Netherlands, Norway, Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and the United Kingdom.
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2021 CENELEC All rights of exploitation in any form and by any means reserved worldwide for CENELEC Members.
Ref. No. EN IEC 61280-1-3:2021 E
European foreword
The text of document 86C/1701/CDV, future edition 3 of IEC 61280-1-3, prepared by SC 86C “Fibre
optic systems and active devices” of IEC/TC 86 “Fibre optics” was submitted to the IEC-CENELEC
parallel vote and approved by CENELEC as EN IEC 61280-1-3:2021.
The following dates are fixed:
• latest date by which the document has to be implemented at national (dop) 2022–05–09
level by publication of an identical national standard or by endorsement
• latest date by which the national standards conflicting with the (dow) 2024–08–09
document have to be withdrawn
This document supersedes EN 61280-1-3:2010 and all of its amendments and corrigenda (if any).
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC shall not be held responsible for identifying any or all such patent rights.
Any feedback and questions on this document should be directed to the users’ national committee. A
complete listing of these bodies can be found on the CENELEC website.
Endorsement notice
The text of the International Standard IEC 61280-1-3:2021 was approved by CENELEC as a
European Standard without any modification.
In the official version, for Bibliography, the following note has to be added for the standard indicated:
IEC 62522 NOTE Harmonized as EN 62522
Annex ZA
(normative)
Normative references to international publications
with their corresponding European publications
The following documents are referred to in the text in such a way that some or all of their content
constitutes requirements of this document. For dated references, only the edition cited applies. For
undated references, the latest edition of the referenced document (including any amendments)
applies.
NOTE 1 Where an International Publication has been modified by common modifications, indicated by (mod), the
relevant EN/HD applies.
NOTE 2 Up-to-date information on the latest versions of the European Standards listed in this annex is available
here: www.cenelec.eu.
Publication Year Title EN/HD Year
IEC 60825-1 - Safety of laser products - Part 1: EN 60825-1 -
Equipment classification and requirements
IEC 62129-1 - Calibration of wavelength/optical frequency EN 62129-1 -
measurement instruments - Part 1: Optical
spectrum analyzers
IEC 62129-2 - Calibration of wavelength/optical frequency EN 62129-2 -
measurement instruments - Part 2:
Michelson interferometer single
wavelength meters
IEC 61280-1-3 ®
Edition 3.0 2021-07
INTERNATIONAL
STANDARD
colour
inside
Fibre optic communication subsystem test procedures –
Part 1-3: General communication subsystems – Measurement of central
wavelength, spectral width and additional spectral characteristics
INTERNATIONAL
ELECTROTECHNICAL
COMMISSION
ICS 33.180.01 ISBN 978-2-8322-9954-8
– 2 – IEC 61280-1-3:2021 © IEC 2021
CONTENTS
FOREWORD . 4
1 Scope . 6
2 Normative references . 6
3 Terms, definitions and abbreviated terms . 6
3.1 Wavelength . 6
3.2 Spectral width . 7
3.3 Additional spectral characteristics . 7
3.4 Abbreviated terms . 8
4 Apparatus . 8
4.1 Calibrated optical spectrum analyzer (OSA) . 8
4.2 Calibrated optical wavelength meter (OWM) . 8
4.3 Power supplies . 9
4.4 Input signal source or modulator . 9
4.5 Test cord . 9
5 Test sample . 9
6 Procedure (method A) . 9
6.1 General . 9
6.2 Setup . 10
6.3 Adjustment of spectrum analyzer controls . 10
6.4 Setting of optical wavelength meter. 11
7 Procedure (method B) . 11
7.1 Setup . 11
7.2 Adjustment of spectrum analyzer controls . 11
7.3 Setting of optical wavelength meter. 11
7.4 Continuous LED and SLM spectra . 12
7.5 Discrete MLM spectra . 12
7.6 SLM spectra. 12
8 Calculation . 13
8.1 General . 13
8.2 Centre wavelength . 13
8.2.1 Continuous LED spectra . 13
8.2.2 Discrete MLM spectra . 13
8.3 Centroidal wavelength . 13
8.4 Peak wavelength . 14
8.4.1 Continuous LED and SLM spectra . 14
8.4.2 Discrete MLM spectra . 14
8.5 RMS spectral width (Δλ ) . 14
rms
8.6 n-dB-down spectral width (Δλ ) . 14
n-dB
8.7 Full-width at half-maximum spectral width (Δλ ) . 14
fwhm
8.7.1 Continuous LED spectra . 14
8.7.2 Discrete MLM spectra . 15
8.8 Side-mode suppression ratio (SMSR) . 15
8.9 Signal-to-source spontaneous emission ratio (SSER) . 15
9 Test results . 15
9.1 Required information . 15
IEC 61280-1-3:2021 © IEC 2021 – 3 –
9.2 Information to be available on request . 16
10 Examples of results . 16
Bibliography . 21
Figure 1 – Example of a LED optical spectrum . 16
Figure 2 – Typical spectrum analyzer output for MLM laser . 18
Figure 3 – Δλ spectral width measurement for MLM laser. 18
fwhm
Figure 4 – Δλ spectral width calculation for MLM laser . 19
fwhm
Figure 5 – Peak emission wavelength and Δλ measurement for SLM laser . 19
30-dB
Figure 6 – Resolution bandwidth (RBW) dependence of SMSR for SLM laser . 20
Figure 7 – Signal-to-source spontaneous emission ratio measurement for SLM laser . 20
Table 1 – Measurement points for LED spectrum from Figure 1 . 17
Table 2 – RMS spectral characterization . 17
– 4 – IEC 61280-1-3:2021 © IEC 2021
INTERNATIONAL ELECTROTECHNICAL COMMISSION
____________
FIBRE OPTIC COMMUNICATION SUBSYSTEM TEST PROCEDURES –
Part 1-3: General communication subsystems – Measurement of central
wavelength, spectral width and additional spectral chara
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.