EN 50193-1:2016/A1:2020

Electric instantaneous water heaters - Methods for measuring the Performance - Part 1: General requirements

This European Standard applies to electric instantaneous water heaters for domestic hot water heating for household and similar applications, which show both of the following characteristics: – fulfilling at least one load pattern from Annex A; – heating up to temperatures below the boiling temperature. This European Standard specifies terms, definitions and measurement methods for the assessment of energy efficiency. This European Standard does not take into account requirements regarding the safety of the appliances.

Elektro-Durchfluss-Wassererwärmer - Prüfverfahren zur Messung der Gebrauchseigenschaften - Teil 1: Allgemeine Anforderungen

Chauffe-eau électriques instantanés - Méthodes de mesure de l'aptitude à la fonction - Partie 1: Exigences générales

Električni pretočni grelniki vode - Metode za merjenje lastnosti - 1. del: Splošne zahteve - Dopolnilo A1

General Information

• Status: Published
• Publication Date: 20-Aug-2020
• ICS: 91.140.65 - Water heating equipment
• Technical Committee: CLC/TC 59X - Consumer information related to household electrical appliances
• Drafting Committee: CLC/TC 59X - Consumer information related to household electrical appliances
• Current Stage: 6060 - Document made available - Publishing
• Start Date: 21-Aug-2020
• Completion Date: 21-Aug-2020
• Directive: 812/2013 - Commission Delegated Regulation (EU) No 812/2013 of 18 February 2013 supplementing Directive 2010/30/EU of the European Parliament and of the Council with regard to the energy labelling of water heaters, hot water storage tanks and packages of water heater and solar device
• Directive: 814/2013 - Commission Regulation (EU) No 814/2013 of 2 August 2013 implementing Directive 2009/125/EC of the European Parliament and of the Council with regard to ecodesign requirements for water heaters and hot water storage tanks
• Mandate: M/324 - Mandate to CEN and CENELEC for the elaboration and adoption of measurement standards for household appliances : Water-heaters, hot-water storage appliances and water heating systems
• Mandate: M/534 - [C(2015)2625] Standardisation request to the European standardisation organisations pursuant to Article 10(1) of Regulation (EU) No 1025/2012 of the European Parliament and of the Council in support of implementation of Commission Regulation (EU) No 814/2013 of 2 August 2013 implementing Directive 2009/125/EC of the European Parliament and of the Council with regard to ecodesign requirements for water heaters and hot water storage tanks and Commission Delegated Regulation (EU) No 812/2013 of 18 February 2013 supplementing Directive 2010/30/EU of the European Parliament and of the Council with regard to the energy labelling of water heaters, hot water storage tanks and packages of water heater and solar device
• Ref Project: SIST EN 50193-1:2016/A1:2020 - Electric instantaneous water heaters - Methods for measuring the Performance - Part 1: General requirements

Relations

• Amends: EN 50193-1:2016 - Electric instantaneous water heaters - Methods for measuring the Performance - Part 1: General requirements
• Effective Date: 30-Jun-2020

Standards Content (Sample)

SLOVENSKI STANDARD
01-oktober-2020
Električni pretočni grelniki vode - Metode za merjenje lastnosti - 1. del: Splošne
zahteve - Dopolnilo A1
Electric instantaneous water heaters - Methods for measuring the Performance - Part 1:
General requirements
Elektro-Durchfluss-Wassererwärmer - Prüfverfahren zur Messung der
Gebrauchseigenschaften - Teil 1: Allgemeine Anforderungen
Chauffe-eau électriques instantanés - Méthodes de mesure de l'aptitude à la fonction -
Partie 1: Exigences générales
Ta slovenski standard je istoveten z: EN 50193-1:2016/A1:2020
ICS:
91.140.65 Oprema za ogrevanje vode Water heating equipment
97.100.10 Električni grelniki Electric heaters
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

EUROPEAN STANDARD EN 50193-1:2016/A1

NORME EUROPÉENNE
EUROPÄISCHE NORM
August 2020
ICS 91.140.65
English Version
Electric instantaneous water heaters - Methods for measuring
the Performance - Part 1: General requirements
Chauffe-eau électriques instantanés - Méthodes de mesure Elektro-Durchfluss-Wassererwärmer - Prüfverfahren zur
de l'aptitude à la fonction - Partie 1: Exigences générales Messung der Gebrauchseigenschaften - Teil 1: Allgemeine
Anforderungen
This amendment A1 modifies the European Standard EN 50193-1:2016; it was approved by CENELEC on 2020-06-17. CENELEC
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this amendment the
status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC
Management Centre or to any CENELEC member.
This amendment exists in three official versions (English, French, German). A version in any other language made by translation under the
responsibility of a CENELEC member into its own language and notified to the CEN-CENELEC Management Centre has the same status as
the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus, the Czech Republic,
Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the
Netherlands, Norway, Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and the United Kingdom.

European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2020 CENELEC All rights of exploitation in any form and by any means reserved worldwide for CENELEC Members.
Ref. No. EN 50193-1:2016/A1:2020 E

European foreword
This document (EN 50193-1:2016/A1:2020) has been prepared by CLC/TC 59X “Performance of
household and similar electrical appliances”.
The following dates are fixed:
• latest date by which this document has (dop) 2021–06–17
to be implemented at national level by
publication of an identical national
standard or by endorsement
• latest date by which the national (dow) 2023–06–17
standards conflicting with this document
have to be withdrawn
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC shall not be held responsible for identifying any or all such patent rights.
This document has been prepared under a mandate given to CENELEC by the European Commission
and the European Free Trade Association, and supports essential requirements of EU Directive(s).
For the relationship with EU Directive(s) see informative Annex ZZ, which is an integral part of this
document.
1 Modification to Annex ZZA, “Relationship between this European Standard
and the energy labelling requirements of Commission Delegated Regulation
(EU) No 812/2013 aimed to be covered” and Annex ZZB, “Relationship
between this European Standard and the ecodesign requirements of
Commission Regulation (EU) No 814/2013 aimed to be covered”
Replace the Annexes ZZA and ZZB with the following:
“Annex ZZA
(informative)
Relationship between this European Standard and the energy labelling
requirements of Commission Delegated Regulation (EU) No 812/2013 aimed to be
covered
This European standard has been prepared under a Commission’s standardization request, M/534
C(2015) 2625 final to provide one voluntary means of conforming to the energy labelling requirements of
Commission Delegated Regulation (EU) No 812/2013 of 18 February 2013 supplementing Directive
2010/30/EU of the European Parliament and of the Council with regard to energy labelling of water
heaters, hot water storage tanks and packages of water heater and solar device, OJ L239, 6.9.2013.
Once this standard is cited in the Official Journal of the European Union under that Regulation,
compliance with the normative clauses of this standard given in Table ZZA.1 confers, within the limits of
the scope of this standard, a presumption of conformity with the corresponding energy labelling
requirements of that Regulation and associated EFTA Regulations.
Table
...