iTeh StandardsiTeh Standards
EURUSD
Your shopping cart is empty.
CLC

EN 61144:1993

(Main)

Test method for the determination of oxygen index of insulating liquids

Test method for the determination of oxygen index of insulating liquids

Describes a method for measuring the oxygen index of insulating liquids. This test method is applicable to all liquids, the viscosity of which is lower than or equal to 50 mm2/s at 40°C ± 1°C.

Meßverfahren zur Bestimmung des Sauerstoff-Kennwertes von Isolierflüssigkeiten

Méthode d'essai pour la détermination de l'indice d'oxygène des isolants liquides

Décrit une méthode pour mesurer l'indice d'oxygène des isolants liquides. Cette méthode d'essai est applicable à tous liquides dont la viscosité est inférieure ou égale à 50 mm2/s à 40 °C ± 1 °C.

Test methods for the determination of oxygen index of insulatingliquids (IEC 1144:1992)

General Information

Status
Published
Publication Date
03-Feb-1993
Withdrawal Date
30-Nov-1993
ICS
17.220.99 - Other standards related to electricity and magnetism
29.040.10 - Insulating oils
Technical Committee
CLC/SR 10 - Fluids for electrotechnical applications
Drafting Committee
IEC/TC 10 - IEC_TC_10
Parallel Committee
IEC/TC 10 - IEC_TC_10
Current Stage
6060 - Document made available - Publishing
Start Date
04-Feb-1993
Completion Date
04-Feb-1993
Ref Project
SIST EN 61144:1997 - Test method for the determination of oxygen index of insulatingliquids

Buy Standard

EN 61144:1997EN 61144:1997
PreviousNext
Standard
EN 61144:1997
English language
14 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)


SLOVENSKI STANDARD
01-avgust-1997
Test methods for the determination of oxygen index of insulatingliquids (IEC
1144:1992)
Test method for the determination of oxygen index of insulatingliquids
Meßverfahren zur Bestimmung des Sauerstoff-Kennwertes von Isolierflüssigkeiten
Méthode d'essai pour la détermination de l'indice d'oxygène des isolants liquides
Ta slovenski standard je istoveten z: EN 61144:1993
ICS:
29.040.01 Izolacijski fluidi na splošno Insulating fluids in general
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

SIST EN 61144
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.

This May Also Interest You

CLC
EN IEC 60599:2022(Main)
Mineral oil-filled electrical equipment in service - Guidance on the interpretation of dissolved and free gases analysis
SIST EN IEC 60599:2022

This document describes how the concentrations of dissolved gases or free gases can be interpreted to diagnose the condition of oil-filled electrical equipment in service and suggest future action. This document is applicable to electrical equipment filled with mineral insulating oil and insulated with cellulosic paper or pressboard-based solid insulation. Information about specific types of equipment such as transformers (power, instrument, industrial, railways, distribution), reactors, bushings, switchgear and oil-filled cables is given only as an indication in the application notes. This document can be applied, but only with caution, to other liquid-solid insulating systems. In any case, the indications obtained are given only as guidance with resulting action undertaken only with proper engineering judgment.

  • Standard
    42 pages
    English language
    sale 10% off
    e-Library read for
    1 day
CLC
EN 60599:2016(Main)
Mineral oil-filled electrical equipment in service - Guidance on the interpretation of dissolved and free gases analysis
SIST EN 60599:2016

IEC 60599:2015 is available as IEC 60599:2015 RLV which contains the International Standard and its Redline version, showing all changes of the technical content compared to the previous edition. IEC 60599:2015 describes how the concentrations of dissolved gases or free gases may be interpreted to diagnose the condition of oil-filled electrical equipment in service and suggest future action. This standard is applicable to electrical equipment filled with mineral insulating oil and insulated with cellulosic paper or pressboard-based solid insulation. Information about specific types of equipment such as transformers (power, instrument, industrial, railways, distribution), reactors, bushings, switchgear and oil-filled cables is given only as an indication in the application notes. This standard may be applied, but only with caution, to other liquid-solid insulating systems. This third edition cancels and replaces the second edition published in 1999 and Amendment 1:2007. This edition constitutes a technical revision. This edition includes the following significant technical changes with respect to the previous edition: a) revision of 5.5, 6.1, 7, 8, 9, 10, A.2.6, A.3, A.7; b) addition of new sub-clause 4.3; c) expansion of the Bibliography; d) revision of Figure 1; e) addition of Figure B.4.

  • Standard
    41 pages
    English language
    sale 10% off
    e-Library read for
    1 day
CLC
EN 60666:2010(Main)
Detection and determination of specified additives in mineral insulating oils
SIST EN 60666:2010

IEC 60666:2010 provides methods concerning the detection and determination of specified additives in unused and used mineral insulating oils. The detection methods may be applied to assess whether or not a mineral insulating oil contains an additive as specified by the supplier. The determination methods are used for the quantitative determination of additives known to be present or previously detected by the appropriate detection method. The main changes with respect to the previous edition are listed below: - a change in the title from 'Detection and determination of specified anti-oxidant additives in insulating oils'; - new Annexes B and C which provide methods for the determination of two additives different from the anti-oxidants.

  • Standard
    35 pages
    English language
    sale 10% off
    e-Library read for
    1 day
CLC
EN 60970:2007(Main)
Insulating liquids - Methods for counting and sizing particles
SIST EN 60970:2007

Describes the sampling procedures and methods for the determination of particle concentration and size distribution. Three methods are specified. One uses an automatic particle size analyser, working on the light interruption principle. The other two use an optical microscope, in either the transmitted light or incident light mode, to count particles collected on the surface of a membrane filter. The optical microscope methods are described in ISO 4407. All three methods are applicable to both used and unused insulating liquids. Annex A contains an alternative sampling procedure using a syringe and Annex B reports a reference for the calibration of automatic particle counters. The significant technical changes with respect to the previous edition are as follows: - new calibration procedures for automated laser particle; - three figures contamination code; - new procedure of sample pre-treatment when automated laser counter method are used.

  • Standard
    21 pages
    English language
    sale 10% off
    e-Library read for
    1 day
CLC
EN 60247:2004(Main)
Insulating liquids - Measurement of relative permittivity, dielectric dissipation factor (tan d) and d.c. resistivity
SIST EN 60247:2004

Describes methods for the determination of the dielectric dissipation factor, relative permittivity and d.c. resistivity of any insulating liquid material at the test temperature. The methods are primarily intended for making reference tests on unused liquids. They can also be applied to liquids in service in transformers, cables and other electrical apparatus. However the method is applicable to a single phase liquid only. When it is desired to make routine determinations, simplified procedures, as described in Annex C, may be adopted. With insulating liquids other than hydrocarbons, alternative cleaning procedures may be required. The main changes from the previous edition deal with the preferred measurement method.

  • Standard
    30 pages
    English language
    sale 10% off
    e-Library read for
    1 day
CLC
EN 61868:1999(Main)
Mineral insulating oils - Determination of kinematic viscosity at very low temperatures
SIST EN 61868:1999

Specifies a procedure for the determination of the kinematic viscosity of mineral insulating oils, both transparent and opaque, at very low temperatures, after a cold soaking period of at least 20 h, by measuring the time for a volume of liquid to flow under gravity throught a calibrated glass capillary viscometer. Applies at all temperatures to both Newtonian and non-Newtonian liquids having viscosities of up to 20 000 mm2/s.

  • Standard
    13 pages
    English language
    sale 10% off
    e-Library read for
    1 day
CLC
EN 61065:1993(Main)
Method for evaluating the low temperature flow properties of mineral insulating oils after ageing
SIST EN 61065:1997

Describes a method for assessing the changes in activity of pour point depressant additives in inhibited and uninhibited mineral insulating oils when aged in the presence of insulating kraft paper.

  • Standard
    11 pages
    English language
    sale 10% off
    e-Library read for
    1 day
CLC
HD 488 S1:1987(Main)
Gassing of insulating liquids under electrical stress and ionization
SIST HD 488 S1:1999

Describes two procedures each using different apparatus to measure the tendency of insulating liquids to evolve or absorb gas when subjected to electrical stress.

  • Standardization document
    23 pages
    English language
    sale 10% off
    e-Library read for
    1 day
CLC
EN IEC 60599:2022(Main)
Mineral oil-filled electrical equipment in service - Guidance on the interpretation of dissolved and free gases analysis
SIST EN IEC 60599:2022

This document describes how the concentrations of dissolved gases or free gases can be interpreted to diagnose the condition of oil-filled electrical equipment in service and suggest future action. This document is applicable to electrical equipment filled with mineral insulating oil and insulated with cellulosic paper or pressboard-based solid insulation. Information about specific types of equipment such as transformers (power, instrument, industrial, railways, distribution), reactors, bushings, switchgear and oil-filled cables is given only as an indication in the application notes. This document can be applied, but only with caution, to other liquid-solid insulating systems. In any case, the indications obtained are given only as guidance with resulting action undertaken only with proper engineering judgment.

  • Standard
    42 pages
    English language
    sale 10% off
    e-Library read for
    1 day
CLC
EN 60599:2016(Main)
Mineral oil-filled electrical equipment in service - Guidance on the interpretation of dissolved and free gases analysis
SIST EN 60599:2016

IEC 60599:2015 is available as IEC 60599:2015 RLV which contains the International Standard and its Redline version, showing all changes of the technical content compared to the previous edition. IEC 60599:2015 describes how the concentrations of dissolved gases or free gases may be interpreted to diagnose the condition of oil-filled electrical equipment in service and suggest future action. This standard is applicable to electrical equipment filled with mineral insulating oil and insulated with cellulosic paper or pressboard-based solid insulation. Information about specific types of equipment such as transformers (power, instrument, industrial, railways, distribution), reactors, bushings, switchgear and oil-filled cables is given only as an indication in the application notes. This standard may be applied, but only with caution, to other liquid-solid insulating systems. This third edition cancels and replaces the second edition published in 1999 and Amendment 1:2007. This edition constitutes a technical revision. This edition includes the following significant technical changes with respect to the previous edition: a) revision of 5.5, 6.1, 7, 8, 9, 10, A.2.6, A.3, A.7; b) addition of new sub-clause 4.3; c) expansion of the Bibliography; d) revision of Figure 1; e) addition of Figure B.4.

  • Standard
    41 pages
    English language
    sale 10% off
    e-Library read for
    1 day