Superconductivity - Part 18: Mechanical properties measurement - Room temperature tensile test of Ag- and/or Ag alloy-sheathed Bi-2223 and Bi-2212 composite superconductors

IEC 61788-18:2013 specifies a test method detailing the tensile test procedures to be carried out on Ag/Bi-2223 and Ag/Bi-2212 superconductive composite wires at room temperature. This test is used to measure the modulus of elasticity and to determine the 0,2 % proof strength. When the 0,2 % proof strength could not be determined due to earlier failure, the stress level at apparent strains of 0,05 %, 0,1 %, 0,15 %, 0,2 %, 0,25 % with increment of 0,05 % is measured. The values for elastic limit, fracture strength, percentage elongation after fracture and the fitted type of 0,2 % proof strength serve only as a reference. The sample covered by this test procedure should have a round or rectangular cross-section with an area of 0,3 mm2 to 2,0 mm2 (corresponding to the tape-shaped wires with width of 2,0 mm to 5,0 mm and thickness of 0,16 mm to 0,4 mm). Key words: superconductivity, mechanical properties measurement

Supraleitfähigkeit - Teil 18: Messung der mechanischen Eigenschaften - Zugversuch von Ag und/oder Ag-Legierung ummantelten Bi-2223 und Bi-2212 Verbundsupraleitern bei Raumtemperatur

Supraconductivité - Partie 18: Mesure des propriétés mécaniques - Essai de traction à température ambiante des supraconducteurs composites Bi-2223 et Bi-2212 avec gaine Ag et/ou en alliage d'Ag

La CEI 61788-18:2013 spécifie une méthode d'essai détaillant les modes opératoires d'essai de traction à exécuter sur des fils composites supraconducteurs d'Ag/Bi-2223 et d'Ag/Bi-2212 à température ambiante. Cet essai est utilisé pour mesurer le module d'élasticité et pour déterminer la charge d'épreuve à 0,2 %. Lorsqu'on ne peut pas déterminer la charge d'épreuve à 0,2 % en raison d'une défaillance antérieure, on mesure le niveau de contrainte pour des déformations apparentes de 0,05 %, 0,1 %, 0,15 %, 0,2 %, 0,25 % avec un incrément de 0,05 %. Les valeurs de la limite élastique, de la résistance à la rupture, du pourcentage d'allongement après fracture et du type ajusté de charge d'épreuve à 0,2 % ne servent que de référence. Il convient que l'échantillon couvert par ce mode opératoire d'essai ait une section circulaire ou rectangulaire d'une surface de 0,3 mm2 à 2,0 mm2 (correspondant aux fils en forme de bande d'une largeur de 2,0 mm à 5,0 mm et d'une épaisseur de 0,16 mm à 0,4 mm). Mots clé: supraconductivité, propriétés mécaniques

Superprevodnost - 18. del: Merjenje mehanskih lastnosti - Natezni preskus Ag- in/ali z Ag zlitino oplaščenih Bi-2223 in Bi-2212 kompozitnih superprevodnikov pri sobni temperaturi (IEC 61788-18:2013)

General Information

Status
Published
Publication Date
12-Dec-2013
Withdrawal Date
16-Oct-2016
Technical Committee
Drafting Committee
Current Stage
6060 - Document made available - Publishing
Start Date
13-Dec-2013
Completion Date
13-Dec-2013

Buy Standard

Standard
EN 61788-18:2014
English language
41 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN 61788-18:2014
01-marec-2014
6XSHUSUHYRGQRVWGHO0HUMHQMHPHKDQVNLKODVWQRVWL1DWH]QLSUHVNXV$J
LQDOL]$J]OLWLQRRSODãþHQLK%LLQ%LNRPSR]LWQLKVXSHUSUHYRGQLNRYSUL
VREQLWHPSHUDWXUL ,(&
Superconductivity - Part 18: Mechanical properties measurement - Room temperature
tensile test of Ag- and/or Ag alloy-sheathed Bi-2223 and Bi-2212 composite
superconductors
Supraconductivité - Partie 18: Mesure des propriétés mécaniques - Essai de traction à
température ambiante des supraconducteurs composites Bi-2223 et Bi-2212 avec gaine
Ag et/ou en alliage d'Ag
Ta slovenski standard je istoveten z: EN 61788-18:2013
ICS:
29.050 Superprevodnost in prevodni Superconductivity and
materiali conducting materials
SIST EN 61788-18:2014 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN 61788-18:2014

---------------------- Page: 2 ----------------------

SIST EN 61788-18:2014


EUROPEAN STANDARD
EN 61788-18

NORME EUROPÉENNE
December 2013
EUROPÄISCHE NORM

ICS 29.050



English version


Superconductivity -
Part 18: Mechanical properties measurement -
Room temperature tensile test of Ag- and/or Ag alloy-sheathed Bi-2223
and Bi-2212 composite superconductors
(IEC 61788-18:2013)


Supraconductivité -  Supraleitfähigkeit -
Partie 18: Mesure des propriétés mécaniques - Teil 18: Messung der mechanischen
Essai de traction à température ambiante des Eigenschaften -
supraconducteurs composites Bi-2223 et Zugversuch von Ag und/oder Ag-Legierung
Bi-2212 avec gaine Ag et/ou en alliage d'Ag ummantelten Bi-2223 und Bi-2212
(CEI 61788-18:2013) Verbundsupraleitern bei Raumtemperatur
(IEC 61788-18:2013)





This European Standard was approved by CENELEC on 2013-10-17. CENELEC members are bound to comply
with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard
the status of a national standard without any alteration.

Up-to-date lists and bibliographical references concerning such national standards may be obtained on
application to the CEN-CENELEC Management Centre or to any CENELEC member.

This European Standard exists in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CENELEC member into its own language and notified
to the CEN-CENELEC Management Centre has the same status as the official versions.

CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus,
the Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany,
Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and the United Kingdom.
CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung

CEN-CENELEC Management Centre: Avenue Marnix 17, B - 1000 Brussels


© 2013 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 61788-18:2013 E

---------------------- Page: 3 ----------------------

SIST EN 61788-18:2014
EN 61788-18:2013 - 2 -
Foreword
The text of document 90/326/FDIS, future edition 1 of IEC 61788-18, prepared by IEC/TC 90
"Superconductivity" was submitted to the IEC-CENELEC parallel vote and approved by CENELEC as
EN 61788-18:2013.
The following dates are fixed:
– latest date by which the document has to be implemented at (dop) 2014-07-17
national level by publication of an identical national
standard or by endorsement
– latest date by which the national standards conflicting with (dow) 2016-10-17
the document have to be withdrawn

Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC [and/or CEN] shall not be held responsible for identifying any or all such
patent rights.
Endorsement notice
The text of the International Standard IEC 61788-18:2013 was approved by CENELEC as a European
Standard without any modification.
In the official version, for Bibliography, the following notes have to be added for the standards indicated:
IEC 61788-6 NOTE Harmonized as EN 61788-6.
ISO 3611:2010 NOTE Harmonized as EN ISO 3611:2010 (not modified).

---------------------- Page: 4 ----------------------

SIST EN 61788-18:2014
- 3 - EN 61788-18:2013
Annex ZA
(normative)

Normative references to international publications
with their corresponding European publications
The following documents, in whole or in part, are normatively referenced in this document and are
indispensable for its applicat
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.