Utility connections in port — Part 1: High voltage shore connection (HVSC) systems — General requirements — Amendment 2

Alimentation des navires à quai — Partie 1: Systèmes de connexion à quai à haute tension — Exigences générales — Amendement 2

General Information

Status
Published
Publication Date
05-Sep-2023
Current Stage
6060 - International Standard published
Start Date
31-Aug-2023
Due Date
07-Feb-2024
Completion Date
06-Sep-2023
Ref Project

Relations

Buy Standard

Standard
IEC/IEEE 80005-1:2019/Amd 2:2023 - Utility connections in port — Part 1: High voltage shore connection (HVSC) systems — General requirements — Amendment 2 Released:9/6/2023
English language
6 pages
sale 15% off
Preview
sale 15% off
Preview
Draft
IEC/IEEE 80005-1:2019/FDAmd 2 - Utility connections in port — Part 1: High voltage shore connection (HVSC) systems — General requirements — Amendment 2 Released:13. 01. 2023
English language
5 pages
sale 15% off
Preview
sale 15% off
Preview

Standards Content (Sample)

IEC/IEEE 80005-1
Edition 2.0 2023-08
INTERNATIONAL

STANDARD

AMENDMENT 2

Utility connections in port –
Part 1: High voltage shore connection (HVSC) systems – General requirements

IEC/IEEE 80005-1:2019-03/AMD2:2023-08 (en)

---------------------- Page: 1 ----------------------
THIS PUBLICATION IS COPYRIGHT PROTECTED
Copyright © 2023 IEC/ISO/IEEE

All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or
by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from IEC,
ISO or IEEE at the respective address given below.

IEC Secretariat ISO copyright office Institute of Electrical and Electronics Engineers, Inc.

3, rue de Varembé Case postale 56 3 Park Avenue
CH-1211 Geneva 20 CH-1211 Geneva 20 New York, NY 10016-5997
Switzerland Switzerland United States of America
Tel.: +41 22 919 02 11 Tel.: +41 22 749 01 11 stds.info@ieee.org
info@iec.ch copyright@iso.org www.ieee.org
www.iec.ch www.iso.org

About the IEC
The International Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes
International Standards for all electrical, electronic and related technologies.

About IEC publications
The technical content of IEC publications is kept under constant review by the IEC. Please make sure that you have the
latest edition, a corrigendum or an amendment might have been published.

IEC publications search - webstore.iec.ch/advsearchform IEC Products & Services Portal - products.iec.ch
The advanced search enables to find IEC publications by a Discover our powerful search engine and read freely all the
variety of criteria (reference number, text, technical publications previews. With a subscription you will always have
committee, …). It also gives information on projects, replaced access to up to date content tailored to your needs.
and withdrawn publications.

Electropedia - www.electropedia.org
IEC Just Published - webstore.iec.ch/justpublished
The world's leading online dictionary on electrotechnology,
Stay up to date on all new IEC publications. Just Published
containing more than 22 300 terminological entries in English
details all new publications released. Available online and once
and French, with equivalent terms in 19 additional languages.
a month by email.
Also known as the International Electrotechnical Vocabulary

(IEV) online.
IEC Customer Service Centre - webstore.iec.ch/csc


If you wish to give us your feedback on this publication or need
further assistance, please contact the Customer Service
Centre: sales@iec.ch.

---------------------- Page: 2 ----------------------
IEC/IEEE 80005-1


Edition 2.0 2023-08








INTERNATIONAL


STANDARD








AMENDMENT 2






Utility connections in port –

Part 1: High voltage shore connection (HVSC) systems – General requirements



























INTERNATIONAL

ELECTROTECHNICAL

COMMISSION





ICS 47.020.60 ISBN 978-2-8322-7299-2




  Warning! Make sure that you obtained this publication from an authorized distributor.

---------------------- Page: 3 ----------------------
– 2 – IEC/IEEE 80005-1:2019/AMD2:2023
© IEC/IEEE 2023
UTILITY CONNECTIONS IN PORT –

Part 1: High voltage shore connection (HVSC) systems –
General requirements

FOREWORD
1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising
all national electrotechnical committees (IEC National Committees). The object of IEC is to promote international
co-operation on all questions concerning standardization in the electrical and electronic fields. To this end and
in addition to other activities, IEC publishes International Standards, Technical Specifications, Technical
Reports, Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC Publication(s)”). Their
preparation is entrusted to technical committees; any IEC National Committee interested in the subject dealt
with may participate in this preparatory work. International, governmental and nongovernmental organizations
liaising with the IEC also participate in this preparation.
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies
(ISO member bodies). The work of preparing International Standards is normally carried out through
ISO technical committees. Each member body interested in a subject for which a technical committee has been
established has the right to be represented on that committee. International organizations, governmental and
non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International
Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
IEEE Standards documents are developed within IEEE Societies and Standards Coordinating Committees of the
IEEE Standards Association (IEEE-SA) Standards Board. IEEE develops its standards through a consensus
development process, approved by the American National Standards Institute, which brings together volunteers
representing varied viewpoints and interests to achieve the final product. Volunteers are not necessarily
members of IEEE and serve without compensation. While IEEE administers the process and establishes rules
to promote fairness in the consensus development process, IEEE does not independently evaluate, test, or verify
the accuracy of any of the information contained in its standards. Use of IEEE Standards documents is wholly
voluntary. IEEE documents are made available for use subject to important notices and legal disclaimers (see
http://standards.ieee.org/IPR/disclaimers.html for more information).
IEC collaborates closely with ISO and IEEE in accordance with conditions determined by agreement between
the organizations. This Triple Logo International Standard was jointly developed by the IEC, ISO and IEEE under
the terms of that agreement.
2) The formal decisions of IEC on technical matters express, as nearly as possible, an international consensus of
opinion on the relevant subjects since each technical committee has representation from all interested IEC
National Committees. In the ISO, Draft International Standards adopted by the technical committees are
circulated to the member bodies for voting. Publication as an International Standard requires approval by at least
75 % of the member bodies casting a vote. The formal decisions of IEEE on technical matters, once consensus
within IEEE Societies and Standards Coordinating Committees has been reached, is determined by a balanced
ballot of materially interested parties who indicate interest in reviewing the proposed standard. Final approval of
the IEEE Standard document is given by the IEEE Standards Association (IEEE SA) Standards Board.
3) IEC/ISO/IEEE Publications have the form of recommendations for international use and are accepted by IEC
National Committees/ISO member bodies /IEEE Societies in that sense. While all reasonable efforts are made
to ensure that the technical content of IEC/ISO/IEEE Publications is accurate, IEC, ISO or IEEE cannot be held
responsible for the way in which they are used or for any misinterpretation by any end user.
4) In order to promote international uniformity, IEC National Committees undertake to apply IEC Publications
(including IEC/ISO/IEEE Publications) transparently to the maximum extent possible in their national and
regional publications. Any divergence between any IEC/ISO/IEEE Publication and the corresponding national or
regional publication shall be clearly indicated in the latter.
5) IEC, ISO, and IEEE do not provide any attestation of conformity. Independent certification bodies provide
conformity assessment services and, in some areas, access to IEC marks of conformity. IEC, ISO and IEEE are
not responsible for any services carried out by independent certification bodies.
6) All users should ensure that they have the latest edition of this publication.
7) No liability shall attach to IEC, ISO or IEEE or their directors, employees, servants or agents including individual
experts and members of technical committees and IEC National Committees and ISO member bodies, or
volunteers of IEEE Societies and the Standards Coordinating Committees of the IEEE Standards Association
(IEEE SA) Standards Board, for any personal injury, property damage or other damage of any nature whatsoever,
whether direct or indirect, or for costs (including legal fees) and expenses arising out of the publication, use of,
or reliance upon, this IEC/ISO/IEEE Publication or any other IEC, ISO or IEEE Publications.
8) Attention is drawn to the normative references cited in this publication. Use of the referenced publications is
indispensable for the correct application of this publication.

---------------------- Page: 4 ----------------------
IEC/IEEE 80005-1:2019/AMD2:2023 – 3 –
© I
...

AMENDMENT IEC/IEEE
80005-
1:2019
FDAM 2
Second edition
2019-03
AMENDMENT 2
ISO/TC 8/SC 3
Utility connections in port —
Secretariat: ANSI
Voting begins on:
Part 1:
2023-01-16
High voltage shore connection (HVSC)
Voting terminates on:
systems — General requirements
2023-03-13
AMENDMENT 2
Alimentation des navires à quai —
Partie 1: Systèmes de connexion à quai à haute tension — Exigences
générales
AMENDEMENT 2
RECIPIENTS OF THIS DRAFT ARE INVITED TO
SUBMIT, WITH THEIR COMMENTS, NOTIFICATION
OF ANY RELEVANT PATENT RIGHTS OF WHICH
THEY ARE AWARE AND TO PROVIDE SUPPOR TING
DOCUMENTATION.
IN ADDITION TO THEIR EVALUATION AS
Reference number
BEING ACCEPTABLE FOR INDUSTRIAL, TECHNO-
IEC/IEEE 80005-1:2019/FDAM 2:2023(E)
LOGICAL, COMMERCIAL AND USER PURPOSES,
DRAFT INTERNATIONAL STANDARDS MAY ON
OCCASION HAVE TO BE CONSIDERED IN THE
LIGHT OF THEIR POTENTIAL TO BECOME STAN-
DARDS TO WHICH REFERENCE MAY BE MADE IN
NATIONAL REGULATIONS. © ISO 2023

---------------------- Page: 1 ----------------------
IEC/IEEE 80005-1:2019/FDAM 2:2023(E)
AMENDMENT IEC/IEEE
80005-
1:2019
FDAM 2
Second edition
2019-03
AMENDMENT 2
ISO/TC 8/SC 3
Utility connections in port —
Secretariat: ANSI
Voting begins on:
Part 1:
2023-01-16
High voltage shore connection (HVSC)
Voting terminates on:
systems — General requirements
2023-03-13
AMENDMENT 2
Alimentation des navires à quai —
Partie 1: Systèmes de connexion à quai à haute tension — Exigences
générales
AMENDEMENT 2
COPYRIGHT PROTECTED DOCUMENT
© ISO 2023
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester.
RECIPIENTS OF THIS DRAFT ARE INVITED TO
ISO copyright office
SUBMIT, WITH THEIR COMMENTS, NOTIFICATION
OF ANY RELEVANT PATENT RIGHTS OF WHICH
CP 401 • Ch. de Blandonnet 8
THEY ARE AWARE AND TO PROVIDE SUPPOR TING
CH-1214 Vernier, Geneva
DOCUMENTATION.
Phone: +41 22 749 01 11
IN ADDITION TO THEIR EVALUATION AS
Reference number
Email: copyright@iso.org
BEING ACCEPTABLE FOR INDUSTRIAL, TECHNO-
IEC/IEEE 80005-1:2019/FDAM 2:2023(E)
Website: www.iso.org
LOGICAL, COMMERCIAL AND USER PURPOSES,
DRAFT INTERNATIONAL STANDARDS MAY ON
Published in Switzerland
OCCASION HAVE TO BE CONSIDERED IN THE
LIGHT OF THEIR POTENTIAL TO BECOME STAN-
DARDS TO WHICH REFERENCE MAY BE MADE IN
ii
  © ISO 2023 – All rights reserved
NATIONAL REGULATIONS. © ISO 2023

---------------------- Page: 2 ----------------------
IEC/IEEE CDV 80005-1:2019/AMD2 – 3 –
© IEC/IEEE 2022
rights, and the risk of infringement of such rights, is entirely their own responsibility. Further information may be
obtained from ISO or the IEEE Standards Association.
This amendment has been prepared by IEC technical committee 18: Electrical installations of
ships and of mobile and fixed offshore units, in cooperation with
• IEC subcommittee 23H: Plugs, socket-outlets and couplers for industrial and similar
applications, and for electric vehicles, of IEC technical committee 23: Electrical accessories,
• ISO subcommittee 3: Piping and machinery, of ISO technical committee 8: Ships and marine
technology, and
• IEEE IAS Petroleum and chemical industry committee.
This document is published as a triple logo (IEC, ISO and IEEE) standard.
The text of this amendment is based on the following documents:
Draft Report on voting
18/XX/FDIS 18/XX/RVD

Full information on the voting for the approval of this amendment can be found in the report on
voting indicated in the above table. In ISO, the amendment has been approved by XXX
P members out of YYY having cast a vote.
The language used for the development of this Amendment is English.
This document was drafted in accordance with ISO/IEC Directives, Part 2, and developed in
accordance with ISO/IEC Directives, Part 1 and ISO/IEC Directives, IEC Supplement, available
at www.iec.ch/members_experts/refdocs. The main document types developed by IEC are
described in greater detail at www.iec.ch/standardsdev/publications.
The committee has decided that the contents of this amendment and the base publication will
remain unchanged until the stability date indicated on the IEC website under
"http://webstore.iec.ch" in the data related to the specific publication. At this date, the
publication will be
• reconfirmed,
• withdrawn,
• replaced by a revised edition, or
• amended.

4 General requirements
Add, after the existing 4.9, the following new subclause:
4.10 Ship specifc annexes
Annex B to Annex G are ship specific annexes that include additional requirements to safety
and compatibility for compliant ships at different compliant berths.

---------------------- Page: 3 ----------------------
– 4 – IEC/IEEE CDV 80005-1:2019/AMD2
 © IEC/IEEE 2022
Additional annex:
Annex G
(normative)

Additional requirements for vehicle carriers
G.1 General
Annex G describes the additional requirements to HVSC systems of vehicle carriers, meaning
multi-deck roll-on, roll-off cargo ships designed to carry empty cars and trucks, other than those
vessel types in Annex B.
The clause numbering of Anne
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.