ISO 14722:1998/Amd 1:2011

Moped and moped-rider kinematics — Vocabulary — Amendment 1

Cinématique relative au cyclomoteur et à son conducteur — Vocabulaire — Amendement 1

General Information

• Status: Published
• Publication Date: 27-Apr-2011
• ICS: 01.040.43 - Road vehicle engineering (Vocabularies)
• ICS: 43.140 - Motorcycles and mopeds
• Technical Committee: ISO/TC 22/SC 38 - Motorcycles and mopeds
• Drafting Committee: ISO/TC 22/SC 38 - Motorcycles and mopeds
• Current Stage: 6060 - International Standard published
• Due Date: 05-Nov-2013
• Completion Date: 28-Apr-2011

Relations

• Amends: ISO 14722:1998 - Moped and moped-rider kinematics — Vocabulary
• Effective Date: 06-Mar-2021

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 14722
First edition
1998-12-15
AMENDMENT 1
2011-05-01


Moped and moped-rider kinematics —
Vocabulary
AMENDMENT 1
Cinématique relative au cyclomoteur et à son conducteur —
Vocabulaire
AMENDEMENT 1





Reference number
ISO 14722:1998/Amd.1:2011(E)
©
ISO 2011

---------------------- Page: 1 ----------------------
ISO 14722:1998/Amd.1:2011(E)

COPYRIGHT PROTECTED DOCUMENT


©  ISO 2011
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail [e-mail]
Web www.iso.org
Published in Switzerland

ii © ISO 2011 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 14722:1998/Amd.1:2011(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies
(ISO member bodies). The work of preparing International Standards is normally carried out through ISO
technical committees. Each member body interested in a subject for which a technical committee has been
established has the right to be represented on that committee. International organizations, governmental and
non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the
International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
The main task of technical committees is to prepare International Standards. Draft International Standards
adopted by the technical committees are circulated to the member bodies for voting. Publication as an
International Standard requires approval by at least 75 % of the member bodies casting a vote.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. ISO shall not be held responsible for identifying any or all such patent rights.
Amendment 1 to ISO 14722:1998 was prepared by Technical Committee ISO/TC 22, Road vehicles,
Subcommittee SC 23,
...