ISO 16000-9:2024

Indoor air — Part 9: Determination of the emission of volatile organic compounds from samples of building products and furnishing — Emission test chamber method

This document specifies a general laboratory test method for the determination of the area specific emission rate of volatile organic compounds (VOCs) from samples of newly produced building products or furnishing under defined climate conditions. The method can also, in principle, be applied to samples of aged products. The emission data obtained can be used to calculate concentrations in a model room (see Table B.1). This document is applicable to various emission test chambers used for the determination of the emission of VOCs from building products or furnishing. This document is also applicable to samples of wood-based panels and other building products, in order to determine the emission rate of formaldehyde. NOTE In principle, this document can be applied to the study of any gas phase emissions from samples of building products and furnishing.

Air intérieur — Partie 9: Dosage de l'émission de composés organiques volatils d'échantillons de produits de construction et d'objets d'équipement ― Méthode de la chambre d'essai d'émission

Le présent document spécifie une méthode générale d’essai en laboratoire pour la détermination du débit d’émission spécifique par unité de surface des composés organiques volatils (COV) provenant d’échantillons de produits de construction nouvellement fabriqués ou d’objets d’équipement, dans des conditions climatiques définies. En principe, la méthode peut être également appliquée aux échantillons de produits anciens. Les données obtenues sur les émissions peuvent être utilisées pour calculer les concentrations dans une pièce modèle (voir Tableau B.1). Le présent document est applicable à différentes chambres d’essai d’émission utilisées pour la détermination des émissions de COV provenant des produits de construction ou d’objets d’équipement. Le présent document est également applicable aux échantillons de panneaux à base de bois et d’autres produits de construction afin de déterminer le débit d’émission du formaldéhyde. NOTE En principe, le présent document peut être appliqué à l’étude des émissions de gaz provenant d’échantillons de produits de construction et d’objets d’équipement.

General Information

• Status: Published
• Publication Date: 19-Mar-2024
• ICS: 13.040.20 - Ambient atmospheres
• Technical Committee: ISO/TC 146/SC 6 - Indoor air
• Drafting Committee: ISO/TC 146/SC 6/WG 3 - Determination of volatile organic compounds (VOCs) in indoor air
• Current Stage: 6060 - International Standard published
• Start Date: 20-Mar-2024
• Due Date: 01-Oct-2023
• Completion Date: 20-Mar-2024

Relations

• Consolidates: ISO/IEC 23001-4:2017 - Information technology — MPEG systems technologies — Part 4: Codec configuration representation
• Effective Date: 06-Jun-2022
• Revises: ISO 16000-9:2006 - Indoor air — Part 9: Determination of the emission of volatile organic compounds from building products and furnishing — Emission test chamber method
• Effective Date: 23-Apr-2020

Standards Content (Sample)

International
Standard
ISO 16000-9
Second edition
Indoor air —
2024-03
Part 9:
Determination of the emission of
volatile organic compounds from
samples of building products
and furnishing — Emission test
chamber method
Air intérieur —
Partie 9: Dosage de l'émission de composés organiques
volatils d'échantillons de produits de construction et d'objets
d'équipement ― Méthode de la chambre d'essai d'émission
Reference number
ISO 16000-9:2024(en) © ISO 2024

---------------------- Page: 1 ----------------------
ISO 16000-9:2024(en)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2024
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: [phone]
Email: [e-mail]
Website: www.iso.org
Published in Switzerland

© ISO 2024 – All rights reserved
ii

---------------------- Page: 2 ----------------------
ISO 16000-9:2024(en)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Symbols and abbreviated terms. 3
4.1 Symbols .3
4.2 Abbreviated terms .4
5 Principle . 4
6 Emission test chamber system. 4
6.1 General .4
6.2 Emission test chamber materials .4
6.3 Air supply and mixing facilities .4
6.4 Air tightness .5
6.5 Air sampling devices .5
6.6 Recovery and sink effects .5
7 Apparatus .
...

Norme
internationale
ISO 16000-9
Deuxième édition
Air intérieur —
2024-03
Partie 9:
Dosage de l'émission de composés
organiques volatils d'échantillons
de produits de construction et
d'objets d'équipement ― Méthode
de la chambre d'essai d'émission
Indoor air —
Part 9: Determination of the emission of volatile organic
compounds from samples of building products and furnishing —
Emission test chamber method
Numéro de référence
ISO 16000-9:2024(fr) © ISO 2024

---------------------- Page: 1 ----------------------
ISO 16000-9:2024(fr)
DOCUMENT PROTÉGÉ PAR COPYRIGHT
© ISO 2024
Tous droits réservés. Sauf prescription différente ou nécessité dans le contexte de sa mise en œuvre, aucune partie de cette
publication ne peut être reproduite ni utilisée sous quelque forme que ce soit et par aucun procédé, électronique ou mécanique,
y compris la photocopie, ou la diffusion sur l’internet ou sur un intranet, sans autorisation écrite préalable. Une autorisation peut
être demandée à l’ISO à l’adresse ci-après ou au comité membre de l’ISO dans le pays du demandeur.
ISO copyright office
Case postale 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Genève
Tél.: [phone]
E-mail: [e-mail]
Web: www.iso.org
Publié en Suisse

© ISO 2024 – Tous droits réservés
ii

---------------------- Page: 2 ----------------------
ISO 16000-9:2024(fr)
Sommaire Page
Avant-propos .iv
Introduction .v
1 Domaine d’application . 1
2 Références normatives . 1
3 Termes et définitions . 1
4 Symboles et abréviations . 4
4.1 Symboles .4
4.2 Abréviations.4
5 Principe. 4
6 Système de chambre d’essai d’émission . 4
6.1 Généralités .4
6.2 Matériaux de la chambre d’essai d’émission .5
6.3 Dispositifs d’alimentation et de mélange d’air .5
6.4 Étanchéité à l’air .5
6.5 Dispositifs de prélèvement de l’air .5
6.6 Récupération et effets de puits .6
7 Appareillage .
...

FINAL
INTERNATIONAL ISO/FDIS
DRAFT
STANDARD 16000-9
ISO/TC 146/SC 6
Indoor air —
Secretariat: DIN
Voting begins on:
Part 9:
2023-12-20
Determination of the emission of
Voting terminates on:
volatile organic compounds from
2024-02-14
samples of building products and
furnishing — Emission test chamber
method
ISO/CEN PARALLEL PROCESSING
RECIPIENTS OF THIS DRAFT ARE INVITED TO
SUBMIT, WITH THEIR COMMENTS, NOTIFICATION
OF ANY RELEVANT PATENT RIGHTS OF WHICH
THEY ARE AWARE AND TO PROVIDE SUPPOR TING
DOCUMENTATION.
IN ADDITION TO THEIR EVALUATION AS
Reference number
BEING ACCEPTABLE FOR INDUSTRIAL, TECHNO-
ISO/FDIS 16000-9:2023(E)
LOGICAL, COMMERCIAL AND USER PURPOSES,
DRAFT INTERNATIONAL STANDARDS MAY ON
OCCASION HAVE TO BE CONSIDERED IN THE
LIGHT OF THEIR POTENTIAL TO BECOME STAN-
DARDS TO WHICH REFERENCE MAY BE MADE IN
NATIONAL REGULATIONS. © ISO 2023

---------------------- Page: 1 ----------------------
ISO/FDIS 16000-9:2023(E)
FINAL
INTERNATIONAL ISO/FDIS
DRAFT
STANDARD 16000-9
ISO/TC 146/SC 6
Indoor air —
Secretariat: DIN
Voting begins on:
Part 9:
Determination of the emission of
Voting terminates on:
volatile organic compounds from
samples of building products and
furnishing — Emission test chamber
method
COPYRIGHT PROTECTED DOCUMENT
© ISO 2023
ISO/CEN PARALLEL PROCESSING
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester.
RECIPIENTS OF THIS DRAFT ARE INVITED TO
ISO copyright office
SUBMIT, WITH THEIR COMMENTS, NOTIFICATION
OF ANY RELEVANT PATENT RIGHTS OF WHICH
CP 401 • Ch. de Blandonnet 8
THEY ARE AWARE AND TO PROVIDE SUPPOR TING
CH-1214 Vernier, Geneva
DOCUMENTATION.
Phone: [phone]
IN ADDITION TO THEIR EVALUATION AS
Reference number
Email: [e-mail]
BEING ACCEPTABLE FOR INDUSTRIAL, TECHNO-
ISO/FDIS 16000-9:2023(E)
Website: www.iso.org
LOGICAL, COMMERCIAL AND USER PURPOSES,
DRAFT INTERNATIONAL STANDARDS MAY ON
Published in Switzerland
OCCASION HAVE TO BE CONSIDERED IN THE
LIGHT OF THEIR POTENTIAL TO BECOME STAN-
DARDS TO WHICH REFERENCE MAY BE MADE IN
ii
  © ISO 2023 – All rights reserved
NATIONAL REGULATIONS. © ISO 2023

---------------------- Page: 2 ----------------------
ISO/FDIS 16000-9:2023(E)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Symbols and abbreviated terms.3
4.1 Symbols . 3
4.2 Abbreviated terms . 4
5 Principle . 4
6 Emission test chamber system. 4
6.1 General . 4
6.2 Em
...

ISO/FDIS 16000-9:2023(E)
ISO/TC 146/SC 6
Secretariat: DIN
Date: 2023-12-06
Indoor air —
Part 9:
Determination of the emission of volatile organic compounds
from samples of building products and furnishing — Emission test
chamber method
Second edition
Date: 2023-09-29

---------------------- Page: 1 ----------------------
FDIS stage

---------------------- Page: 2 ----------------------
ISO/FDIS 16000-9:2023(E)
© ISO 2023
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this
publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical,
including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can
be requested from either ISO at the address below or ISO'sISO’s member body in the country of the requester.
ISO Copyright Office copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: + 41 22 749 01 11
Email: E-mail: [e-mail]
Website: www.iso.org
Published in Switzerland.
© ISO 2023 – All rights reserved iii
© ISO 2023 – All rights reserved iii

---------------------- Page: 3 ----------------------
ISO/FDIS 16000-9:2023(E)
Contents
Foreword . vi
Introduction .vi i
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 2
4 Symbols and abbreviated terms . 4
4.1 Symbols . 4
4.2 Abbreviated terms . 4
5 Principle . 5
6 Emission test chamber system . 5
6.1 General . 5
6.2 Emission test chamber materials . 5
6.3 Air supply and mixing facilities . 5
6.4 Air tightness . 5
6.5 Air sampling devices . 6
6.6 Recovery and sink effects . 6
7 Apparatus . 6
8 Test conditions . 7
8.1 Temperature and relative air humidity . 7
8.2 Supply air quality and background concentration . 7
8.3 Air velocity .
...