ISO 11961:2018/Amd 1:2020
(Amendment)Petroleum and natural gas industries — Steel drill pipe — Amendment 1
Petroleum and natural gas industries — Steel drill pipe — Amendment 1
Industries du pétrole et du gaz naturel — Tiges de forage en acier — Amendement 1
General Information
Relations
Standards Content (Sample)
INTERNATIONAL ISO
STANDARD 11961
Third edition
2018-10
AMENDMENT 1
2020-03
Petroleum and natural gas
industries — Steel drill pipe
AMENDMENT 1
Industries du pétrole et du gaz naturel — Tiges de forage en acier
AMENDEMENT 1
Reference number
ISO 11961:2018/Amd.1:2020(E)
©
ISO 2020
---------------------- Page: 1 ----------------------
ISO 11961:2018/Amd.1:2020(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2020
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting
on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address
below or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Fax: +41 22 749 09 47
Email: copyright@iso.org
Website: www.iso.org
Published in Switzerland
ii © ISO 2020 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 11961:2018/Amd.1:2020(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular, the different a
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.