SIST EN 15182-2:2007+A1:2010
(Main)Hand-held branchpipes for fire service use - Part 2: Combination branchpipes PN 16
Hand-held branchpipes for fire service use - Part 2: Combination branchpipes PN 16
In addition to the requirements given in EN 15182-1, this Part of this European Standard applies to hand-held combination branchpipes (nozzles) PN 16 with a maximum flow rate of 1 000 l/min at a reference pressure of 6 bar (0,6 MPa). It deals with: safety requirements; performance requirements; test methods; classification and designation; operating instructions; marking and maintenance. This part of this European Standard applies to branchpipes as defined in Annex A of EN 15182-1:2007.
Strahlrohre für die Brandbekämpfung - Teil 2: Hohlstrahlrohre PN 16
Zusätzlich zu den in EN 15182-1 angegebenen Anforderungen gilt der vorliegende Teil dieser Europäischen
Norm für Hohlstrahlrohre (Mundstücke) PN 16 mit einer maximalen Durchflussmenge von 1 000 l/min bei
einem Referenzdruck von 6 bar (0,6MPa). Behandelt werden:
- Sicherheitsanforderungen;
- Anforderungen an die Funktion;
- Prüfverfahren;
- Klassifizierung und Bezeichnung;
- Betriebsanleitung;
- Kennzeichnung und Instandhaltung.
Der vorliegende Teil dieser Europäischen Norm gilt für Strahlrohre nach EN 15182-1:2007, Anhang A.
Lances à main destinées aux services d'incendie et de secours - Partie 2: Lances mixtes à débit et jet réglables PN 16
En complément des prescriptions données dans l’EN 15182-1, la présente partie de la présente Norme européenne
s‘applique aux lances mixtes à main, à débit et jet réglables PN 16 d’un débit maximum de 1 000 l/min à une pression
de référence de 6 bar (0,6 MPa). Elle traite :
- des prescriptions de sécurité ;
- des prescriptions de performance ;
- des méthodes d’essai ;
- du classement et de la désignation ;
- de la notice d’instructions ;
- du marquage et de l’entretien.
Cette partie de la présente Norme européenne s’applique aux lances définies dans l’Annexe A de l’EN 15182-1:2007.
Gasilski ročniki - 2. del. Kombinirani ročniki PN 16
General Information
Relations
Standards Content (Sample)
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Strahlrohre für die Brandbekämpfung - Teil 2: Hohlstrahlrohre PN 16Lances à main destinées aux services d'incendie et de secours - Partie 2: Lances mixtes à débit et jet réglables PN 16Hand-held branchpipes for fire service use - Part 2: Combination branchpipes PN 1613.220.10Gašenje požaraFire-fightingICS:Ta slovenski standard je istoveten z:EN 15182-2:2007+A1:2009SIST EN 15182-2:2007+A1:2010en,fr,de01-januar-2010SIST EN 15182-2:2007+A1:2010SLOVENSKI
STANDARD
SIST EN 15182-2:2007+A1:2010
EUROPEAN STANDARD NORME EUROPÉENNE EUROPÄISCHE NORM
EN 15182-2:2007+A1
November 2009 ICS 13.220.10 Supersedes EN 15182-2:2007English Version
Hand-held branchpipes for fire service use - Part 2: Combination branchpipes PN 16
Lances à main destinées aux services d'incendie et de secours - Partie 2: Lances mixtes à débit et jet réglables PN 16
Strahlrohre für die Brandbekämpfung - Teil 2: Hohlstrahlrohre PN 16 This European Standard was approved by CEN on 23 December 2006 and includes Amendment 1 approved by CEN on 29 September 2009.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN Management Centre or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre:
Avenue Marnix 17,
B-1000 Brussels © 2009 CEN All rights of exploitation in any form and by any means reserved worldwide for CEN national Members. Ref. No. EN 15182-2:2007+A1:2009: ESIST EN 15182-2:2007+A1:2010
EN 15182-2:2007+A1:2009 (E) 2 Contents Page Foreword . 31Scope . 42Normative references . 43Terms and definitions . 44Requirements . 54.1General . 54.2Mechanical characteristics . 54.3Hydraulic characteristics . 64.4Leak-tightness . 94.5Hydrostatic requirements . 95Testing and proofs. 95.1General . 95.2Jet spray angle . 95.3Flow and throw test . 125.4Tightness test . 125.5Hydrostatic test . 12
SIST EN 15182-2:2007+A1:2010
EN 15182-2:2007+A1:2009 (E) 3 Foreword This document (EN 15182-2:2007+A1:2009) has been prepared by Technical Committee CEN/TC 192 “Fire service equipment”, the secretariat of which is held by BSI. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by May 2010, and conflicting national standards shall be withdrawn at the latest by May 2010. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. CEN [and/or CENELEC] shall not be held responsible for identifying any or all such patent rights. This document includes Amendment 1, approved by CEN on 2009-09-29. This document supersedes EN 15182-2:2007. The start and finish of text introduced or altered by amendment is indicated in the text by tags !". EN 15182 consists of the following parts, under the general title Hand-held branchpipes for fire service use: Part 1 : Common requirements; Part 2 : Combination branchpipes PN 16; Part 3 : Smooth bore jet and/or one fixed spray jet angle branchpipes PN 16; Part 4 : High pressure branchpipes PN 40. According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom. SIST EN 15182-2:2007+A1:2010
EN 15182-2:2007+A1:2009 (E) 4 1 Scope In addition to the requirements given in EN 15182-1, this Part of this European Standard applies to hand-held combination branchpipes (nozzles) PN 16 with a maximum flow rate of 1 000 l/min at a reference pressure of 6 bar (0,6 MPa). It deals with: safety requirements; performance requirements; test methods; classification and designation; operating instructions; marking and maintenance. This part of this European Standard applies to branchpipes as defined in Annex A of EN 15182-1:2007. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. EN 15182-1:2007, Hand-held branchpipes for fire service use — Part 1: Common requirements 3 Terms and definitions For the purposes of this document, the terms and definitions given in EN 15182-1:2007 and the following apply. 3.1 combination branchpipe branchpipe including a shut-off device and !an adjustable pattern", corresponding to the following definitions
NOTE Branchpipe is defined in 3.1 of EN 15182-1:2007. 3.1.1 combination branchpipe – type 1 combination branchpipe with !adjustable pattern" at variable flow NOTE Changing pattern changes the flow. 3.1.2 combination branchpipe – type 2 combination branchpipe with !adjustable pattern" at constant flow NOTE Changing pattern does not change the flow. 3.1.3 combination branchpipe – type 3 combination br
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.