SIST EN 233:2017
(Main)Wallcoverings in roll form - Specification for finished wallpapers, wall vinyls and plastics wallcoverings
Wallcoverings in roll form - Specification for finished wallpapers, wall vinyls and plastics wallcoverings
This European Standard:
- specifies requirements for finished wallpapers, wall vinyls and plastics wallcoverings;
- specifies requirements for marking;
- gives the designation system.
The marking requirements of this standard are primarily for the consumer's information to enable optimum selection of the product.
This standard applies to finished wallpapers, wall vinyls and plastics wallcoverings not intended for subsequent decoration supplied in rolls for hanging on indoor walls and ceilings by means of an adhesive covering the whole of the interface between the wallcovering and the support surface.
Excluded from this standard are rigid materials, materials not attached or not wholly attached by adhesive, wallcoverings for subsequent decoration, textile wallcoverings and non-decorative wallcoverings such as wall linings or those with special properties, e.g. thermal or acoustic insulation.
Wandbekleidungen in Rollen - Festlegungen für fertige Papier-, Vinyl- und Kunststoffwandbekleidungen
Diese Europäische Norm:
-— legt Anforderungen an fertige Papier-, Vinyl- und Kunststoffwandbekleidungen und
- an die Kennzeichnung fest und
- enthält das Bezeichnungssystem.
Die Anforderungen dieser Norm an die Kennzeichnung dienen hauptsächlich der Verbraucherinformation zur Ermöglichung einer optimalen Auswahl des Produktes.
Diese Norm gilt für fertige Papier-, Vinyl- und Kunststoffwandbekleidungen in Rollen, für die keine nachträgliche Behandlung vorgesehen ist, die beim Tapezieren von Wänden und Decken mit einem Klebstoff angeklebt werden, der die gesamte Grenzfläche zwischen Wandbekleidung und Untergrund bedeckt.
Harte Werkstoffe, Werkstoffe, die nicht oder unvollständig angeklebt werden, Wandbekleidungen zur nachträglichen Behandlung, Textilwandbekleidungen und Wandbekleidungen ohne dekorative Funktion, wie Wandbeläge, oder Wandbekleidungen mit besonderen Eigenschaften, z. B. Wärme- oder Schalldämmvermögen, sind nicht Gegenstand dieser Norm.
Revêtements muraux en rouleaux - Spécification des papiers peints finis, des revêtements muraux vinyles et des revêtements muraux en plastique
La présente Norme européenne :
- spécifie les exigences pour les papiers peints finis, les revêtements muraux vinyles et les revêtements muraux en plastique ;
- spécifie les exigences pour le marquage ;
- donne un système de désignation.
Les spécifications de marquage de la présente norme visent, en premier lieu, l’information du consommateur afin de permettre un choix optimal du produit.
La présente norme s’applique aux papiers peints finis, aux revêtements muraux vinyles et aux revêtements muraux en plastique non destinés à une décoration ultérieure, vendus en rouleaux pour être appliqués sur les murs et les plafonds intérieurs à l’aide d’un adhésif couvrant la totalité de l’interface entre le revêtement mural et le subjectile.
Sont exclus de cette norme les matériaux rigides, les matériaux qui ne se fixent pas à l’aide d’adhésif ou pas sur toute leur surface, les revêtements muraux pour décoration ultérieure, les revêtements muraux textiles et les revêtements muraux non décoratifs, tels que les revêtements d’apprêt, ou ceux ayant des propriétés particulières, par exemple isolation thermique ou acoustique.
Stenske obloge v zvitkih - Specifikacija za tapete, stenske obloge iz vinila in umetne mase
Ta evropski standard:
– določa zahteve za tapete ter stenske obloge iz vinila in umetne mase;
– določa zahteve za označevanje;
– podaja sistem za označevanje.
Zahteve za označevanje tega standarda služijo predvsem kot informacija za potrošnike, ki jim omogoča lažjo izbiro najustreznejšega izdelka.
Ta standard se uporablja za tapete ter stenske obloge iz vinila in umetne mase v zvitkih, ki niso namenjene nadaljnjemu okraševanju in se uporabljajo za nanašanje na notranje stene in strop s pomočjo lepila, s katerim se prekrije celotno območje med stensko oblogo in podporno površino.
Iz tega standarda so izključeni togi materiali, ki delno ali v celoti niso pritrjeni z lepilom, stenske obloge, ki so namenjene nadaljnjemu okraševanju, stenske obloge iz blaga in stenske obloge, ki niso namenjene okraševanju ali ki imajo posebne lastnosti, npr. toplotna ali zvočna izolacija.
General Information
Relations
Standards Content (Sample)
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Stenske obloge v zvitkih - Specifikacija za tapete, stenske obloge iz vinila in umetne maseWandbekleidungen in Rollen - Festlegungen für fertige Papier-, Vinyl- und KunststoffwandbekleidungenRevêtements muraux en rouleaux - Spécification des papiers peints finis, des revêtements muraux vinyles et des revêtements muraux en plastiqueWallcoverings in roll form - Specification for finished wallpapers, wall vinyls and plastics wallcoverings91.180Interior finishingICS:Ta slovenski standard je istoveten z:EN 233:2016SIST EN 233:2017en,fr,de01-januar-2017SIST EN 233:2017SLOVENSKI
STANDARDSIST EN 233:20001DGRPHãþD
SIST EN 233:2017
EUROPEAN STANDARD NORME EUROPÉENNE EUROPÄISCHE NORM
EN 233
November
t r s x ICS
{ sä s z r Supersedes EN
t u uã s { { {English Version
Wallcoverings in roll form æ Specification for finished wallpapersá wall vinyls and plastics wallcoverings Revêtements muraux en rouleaux æ Spécification des papiers peints finisá des revêtements muraux vinyles et des revêtements muraux en plastique
Wandbekleidungen in Rollen æ Festlegungen für fertige Papieræá Vinylæ und Kunststoffwandbekleidungen This European Standard was approved by CEN on
t x May
t r s xä
egulations which stipulate the conditions for giving this European Standard the status of a national standard without any alterationä Upætoædate lists and bibliographical references concerning such national standards may be obtained on application to the CENæCENELEC Management Centre or to any CEN memberä
translation under the responsibility of a CEN member into its own language and notified to the CENæCENELEC Management Centre has the same status as the official versionsä
CEN members are the national standards bodies of Austriaá Belgiumá Bulgariaá Croatiaá Cyprusá Czech Republicá Denmarká Estoniaá Finlandá Former Yugoslav Republic of Macedoniaá Franceá Germanyá Greeceá Hungaryá Icelandá Irelandá Italyá Latviaá Lithuaniaá Luxembourgá Maltaá Netherlandsá Norwayá Polandá Portugalá Romaniaá Slovakiaá Sloveniaá Spainá Swedená Switzerlandá Turkey and United Kingdomä
EUROPEAN COMMITTEE FOR STANDARDIZATION COMITÉ EUROPÉEN DE NORMALISATION EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre:
Avenue Marnix 17,
B-1000 Brussels
9
t r s x CEN All rights of exploitation in any form and by any means reserved worldwide for CEN national Membersä Refä Noä EN
t u uã t r s x ESIST EN 233:2017
EN 233:2016 (E) 2 Contents
Page European foreword . 3 Introduction . 4 1 Scope . 5 2 Normative references . 5 3 Terms and definitions . 5 4 Categories . 5 5 Specifications . 6 5.1 General . 6 5.2 Dimensions . 6 5.2.1 General . 6 5.2.2 Category 1 . 6 5.2.3 Category 2 . 6 5.2.4 Category 3 (friezes) . 6 5.3 Straightness and parallelity of the edges . 6 5.4 Spongeability . 6 5.5 Washability . 7 5.6 Colour fastness to light . 7 5.7 Maximum migration of heavy metals and certain other elements . 7 5.7.1 Test method . 7 5.7.2 Requirements . 7 5.7.3 Interpretation of results . 7 5.8 Maximum vinyl chloride monomer (VCM) content . 8 5.8.1 Test method . 8 5.8.2 Requirements . 8 5.9 Maximum formaldehyde release . 8 5.9.1 Test method . 8 5.9.2 Requirements . 8 6 Matching, application of adhesive, removal and miscellaneous symbols . 8 7 Marking, Iabelling, packaging . 9 7.1 Visible marking . 9 7.2 Additional marking . 9 Annex A (normative)
Sampling for testing . 10
SIST EN 233:2017
EN 233:2016 (E) 3 European foreword This document (EN 233:2016) has been prepared by Technical Committee CEN/TC 99 “Wallcoverings”, the secretariat of which is held by AFNOR. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by May 2017, and conflicting national standards shall be withdrawn at the latest by May 2017. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. CEN [and/or CENELEC] shall not be held responsible for identifying any or all such patent rights. This document supersedes EN 233:1999. EN 233:2016 includes the following significant technical changes with respect to EN 233:1999: — Marking, labelling and packaging: Simplified to avoid duplication; — Classification and designation: Withdrawn as system is obsolete; — Annex A, Sampling for testing: Changed from "not more than 14 days"; — Annex B, A-deviation: Withdrawn as requirement is obsolete. According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and the United Kingdom. SIST EN 233:2017
EN 233:2016 (E) 4 Introduction A finished wallcovering is one that is not intended to be decorated after hanging. There are many types of wallcovering and varied processes used in their manufacture. To ensure satisfactory performance, it is important that the installers follow the manufacturer's recommended hanging instructions for each particular product. Various grades of washability and colour fastness to light of finished wallcoverings are permitted. These grades will facilitate the selection by the consumer or specifier of an appropriate wallcovering. Other European Standards on the vocabulary used in the wallcovering industry, wallcoverings for subsequent decoration, textile wallcoverings and heavy duty wallcoverings are also published: — EN 235, Wallcoverings in roll form – Vocabulary and symbols — EN 234, Wallcoverings in roll form – Specification for wallcoverings for subsequent decoration — EN 259, Wall coverings in roll form – Specification for heavy duty wall coverings — EN 266, Wall coverings in roll form – Specification for textile wall coverings — EN 12956, Wallcoverings in roll form – Determination of dimensions, straightness, spongeability and washability — EN 15102, Decorative wallcoverings – Roll and panel form SIST EN 233:2017
EN 233:2016 (E) 5 1 Scope This European Standard: — specifies requirements for finished wallpapers, wall vinyls and plastics wallcoverings; — specifies requirem
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.