29.120.30 - Plugs, socket-outlets, couplers

The scope of this document is to define requirements for the shore supply system for auxiliaries and pre-conditioning and the related intermateable connector pairs.
Shore supplies to move the rolling stock are outside the scope of this document.

IEC 62966-2:2020 is dedicated to aisle containment techniques for information technology (IT) equipment typically used in data centres, describes the quantification of its air tightness, in particular the air loss ratio that describes the content of the volumetric flow not used for cooling the IT equipment. This ratio provides an index of efficiency, being inversely proportional to efficiency (the lower this ratio, the higher the efficiency). This document provides methods to measure an aisle co...view more

IEC TS 62196-3-1:2020(E) applies to accessories and cable assemblies with the same configuration as specified in IEC 62196-3:2014 with rated operating voltage not exceeding 1 500 V DC and a rated current not exceeding 500 A that employ
- thermal sensing, or
- thermal transport and thermal sensing with the system architecture described in 4.101.
These accessories and cable assemblies are intended to be used in conductive charging systems for circuits specified in IEC 61851-23.
NOTE Edition 2 ...view more

This part of 60309 applies to a single type of plug, socket-outlet, ship connector and ship
inlet, hereinafter referred to as accessories, intended to connect ships to dedicated shore
supply systems described in IEC/IEEE 80005-3.
This part of IEC 60309 applies to three-phase accessories with an earth contact and with four
pilot contacts.
NOTE 1 In the following countries the term “ground” is used instead of “earth": US.
These accessories have a maximum rated current of 350 A and a maximum ...view more

This document applies to two-wire, up to five-wire installation couplers, including earth, if
provided, with a rated voltage up to and including 500 V AC or DC and a rated connecting
capacity up to and including 10 mm2 for permanent connection in electrical installations.
Installation couplers with additional contacts for voltages other than mains voltages are
outside the scope of this document.
An installation coupler consists of an installation female connector and an installation male
c...view more

IEC 63057:2020 specifies safety tests and requirements for secondary lithium batteries permanently installed in road vehicles not for the propulsion. Replacement secondary batteries permanently installed in road vehicles not for propulsion are covered by this document.
The following are typical applications that utilize the batteries under the scope of this document: a power source for the starting of internal combustion engines, lighting, on-board auxiliary equipment, and energy absorption for...view more

IEC 60309-5:2017 applies to a single type of plug, socket-outlet, ship connector and ship inlet, hereinafter referred to as accessories, intended to connect ships to dedicated shore supply systems described in IEC/IEEE 80005-3. This part of IEC 60309 applies to three-phase accessories with an earth contact and with four pilot contacts. This publication is to be read in conjunction with IEC 60309-1:2012.

This part of lEC 60320 sets the general requirements for appliance couplers for two poles and
two poles with earth contact and for the connection of electrical devices for household and
similar onto the mains supply.
This part of lEC 60320 is also valid for appliance inlets/appliance outlets integrated or
incorporated in appliances.
The rated voltage does not exceed 250 V (a.c.) and the rated current does not exceed 16 A.
Appliance couplers complying with this part of lEC 60320 are suitabl...view more

This part of lEC 60320 sets the general requirements for appliance couplers for two poles and
two poles with earth contact and for the connection of electrical devices for household and
similar onto the mains supply.
This part of lEC 60320 is also valid for appliance inlets/appliance outlets integrated or
incorporated in appliances.
The rated voltage does not exceed 250 V (a.c.) and the rated current does not exceed 16 A.
Appliance couplers complying with this part of lEC 60320 are suitabl...view more

This document applies in connection with EN 15869-1 for the supply of berthed inland navigation vessels with electrical energy.
This document specifies additional requirements for the on-shore unit of the electrical shore connection.

IEC 62613-1:2019 applies to accessories with
- three phases and earth with pilot contacts,
- one pole for neutral.
These accessories have rated currents not exceeding 500 A and rated operating voltages not exceeding 12 kV 50/60 Hz.
This second edition cancels and replaces the first edition published in 2011. This edition constitutes a technical revision.
This edition includes the following significant technical changes with respect to the previous edition:
a) extension of the scope to an u...view more

Standard določa dimenzijske zahteve za vtiče in vtičnice za hišno in podobno uporabo.
Ta standard se nanaša samo na vtiče z ozemljitvenim kontaktom ali brez njega in fiksne ali prenosne
vtičnice z ozemljitvenim kontaktom z naznačeno izmenično napetostjo, večjo od 50 V in manjšo od 250
V, ter z naznačenim tokom, ki ne presega 16 A, namenjene za hišno in podobno uporabo v zgradbah in
zunaj njih v enofaznem omrežju.
Ta standard velja tudi za vtiče, ki so del konfekcioniranih kablov, za vtiče i...view more

IEC 60320-2-4:2018 is now available as IEC 60320-2-4:2018 RLV which contains the International Standard and its Redline version, showing all changes of the technical content compared to the previous edition.
IEC 60320-2-4:2018 is applicable to two-pole appliance couplers for alternating current only, with or without earthing contact, with a rated voltage not exceeding 250 V and a rated current not exceeding 16 A, for household and similar general purposes and intended for incorporation or int...view more

IEC 60320-2-3:2018 is now available as IEC 60320-2-3:2018 RLV which contains the International Standard and its Redline version, showing all changes of the technical content compared to the previous edition.
IEC 60320-1:2018 applies with the following addition: This document applies to appliance couplers with a degree of protection against ingress of water higher than IPX0. This second edition cancels and replaces the first edition published in 1998 and Amendment 1:2004. This edition constitu...view more

The purpose of the IEC/ISO/IEEE 80005-1 is to define requirements that allow compliant ships to connect to compliant high-voltage shore power supplies through a compatible shore-to-ship connection.
IEC 62613 has been written to address the needs of 80005-1 in terms of plugs, socket-outlets, ship connectors and ship inlets (herein referred to as "accessories") to deliver electrical power to ships in ports.
IEC 62613 applies to accessories with
-   three phases and earth with pilot contacts,
-...view more

The purpose of the IEC/ISO/IEEE 80005-1 is to define requirements that allow compliant ships to connect to compliant high-voltage shore power supplies through a compatible shore-to-ship connection.
IEC 62613 has been written to address the needs of 80005-1 in terms of plugs, socket-outlets, ship connectors and ship inlets (herein referred to as "accessories") to deliver electrical power to ships in ports.
IEC 62613 applies to accessories with
-   three phases and earth with pilot contacts,
-...view more

The purpose of the IEC/ISO/IEEE 80005-1 is to define requirements that allow compliant ships to connect to compliant high-voltage shore power supplies through a compatible shore-to-ship connection. IEC 62613 has been written to address the needs of 80005-1 in terms of plugs, socket-outlets, ship connectors and ship inlets (herein referred to as "accessories") to deliver electrical power to ships in ports. IEC 62613 applies to accessories with - three phases and earth with pilot contacts, - one s...view more

The purpose of the IEC/ISO/IEEE 80005-1 is to define requirements that allow compliant ships to connect to compliant high-voltage shore power supplies through a compatible shore-to-ship connection. IEC 62613 has been written to address the needs of 80005-1 in terms of plugs, socket-outlets, ship connectors and ship inlets (herein referred to as "accessories") to deliver electrical power to ships in ports. IEC 62613 applies to accessories with - three phases and earth with pilot contacts, - one s...view more